DLA A-A-55822-1996 CHESTS PLYWOOD [Superseded DLA MIL-C-12044 D CANC NOTICE 1 DLA MIL-C-12044 D DLA MIL-C-12044 C (2) DLA MIL-C-12044 C]《胶合板箱(被替代 DLA MIL-C-12044 D 撤消通告 1 DLA MIL-C.pdf

《DLA A-A-55822-1996 CHESTS PLYWOOD [Superseded DLA MIL-C-12044 D CANC NOTICE 1 DLA MIL-C-12044 D DLA MIL-C-12044 C (2) DLA MIL-C-12044 C]《胶合板箱(被替代 DLA MIL-C-12044 D 撤消通告 1 DLA MIL-C.pdf》由会员分享，可在线阅读，更多相关《DLA A-A-55822-1996 CHESTS PLYWOOD [Superseded DLA MIL-C-12044 D CANC NOTICE 1 DLA MIL-C-12044 D DLA MIL-C-12044 C (2) DLA MIL-C-12044 C]《胶合板箱(被替代 DLA MIL-C-12044 D 撤消通告 1 DLA MIL-C.pdf（5页珍藏版）》请在麦多课文档分享上搜索。

1、A-A-551322 9999974 01173752 936 A-A-55822 1 August 1996 SUPERSEDING 13 February 1975 MIL-C-12044D COMMERCIAL ITEM DESCRIPTION CHESTS, PLYWOOD The General Services Adrxiinislration ha5 authrizcd the use of this comercid item description as a replacement for MIL-C- 12044D for all federal agencies. 1.

2、SCOPE. This commercial item description covers plywood chests with hinged covers. Figure 1 depicts a typical plywood chest. 2. SALIENT CHARACTERISTICS. The plywood chests are to be built such that when fully loaded there is no more than 6 mm (1/4 inch) bottom and side deflection. Nominal 1 O cm (4 i

3、nch) by 8 cm (3 inch) skids shall be used on all chests having a gross weight (including contents) in excess of 114 kilograms (kg) (250 pounds) and a length of 90 centimeters (cm) (36 inches). Block and wood partitions, if required, shall be held in place with waterproof wood glue and counter sunk w

4、ood screws or bolts as appropriate to the load and loading. The plywood chests shall be constructed such that the sanded, unplugged surface of the plywood shall be on the outside of the plywood chest. All exposed edges and corners are to be protected by metal protective and reinforcing edges. Latche

5、s, hinges, pulls and cover restraining chains shall be installed. Corner cover pulls are to be installed on all chests. Straight cover pulls shall be used only if the plywood chest length exceeds 1.2 meters (m) (48 inches). The number of handles for each end and side panel shall be as follows: under

6、 60 cm (24 inches) of length - none; one handle for each 30 cm (12 inches) over 60 cm (24 inches) of length. The number of hinges shall be as follows: i mkiimum of two binges up to 90 crn (36 inches) of length; one additional hinge for every 30 cm (12 inches) of length over 90 cm (36 inches). There

7、shall be one latch opposite each hinge. All hardware, metal protective and reinforcing edges and restraining chains shall be securely attached such that they cannot be pulled off during their intended use. Beneficial comments, recommendations, additions, deletions, clarifications, etc. and any other

8、 data which may improve this document should be sent by letter to: Defense Supply Center Richmond, ATTN: DSCR-VBD, 8000 Jefferson Davis Highway, Richmond, VA 23297-5610. AMSC NIA FSC MISC DISTRIBUT ION S TATEMENT A. Approved for public release; distrbution is unlimited. Licensed by Information Handl

9、ing ServicesA-A-55822 iQt I T N c( x I L A-A-55822 9993974 0171753 872 1/6 of E- kR1 r is z g rw- 15 B + 3/16 = C (lor cover) - the color the plywood chest is to be painted; the type and weight of the load; details of the trays and partitions; a loading plan (if required), and etc. shall be as speci

10、fied in the contract or order. 3. REGULATORY REQUIREMENTS. The offerorcontractor is encouraged to use recovered materials to the maximum extent possible in accordance with paragraph 23.403 of the Federal Acquisition Regulation (FAR). 4. QUALITY ASSURANCE PROVISIONS 4.1 Product conformance. The produ

11、cts provided shall meet the salient characteristics of this commercial item description, conform to the producers own drawings, specifications, standards, and quality assurance practices, and be the same product offered for sale in the commercial market. The government reserves the right to require

12、proof of such conformance. 4.2 Market acceptability. The item offered must have been sold to the govemment or commercial market. 4.3 Inspection requirements. Bid samples may be required for item offered when necessary to assure product quality. As specified in the contract or order, the contractor s

13、hall supply a sample for government inspection. 3 Licensed by Information Handling ServicesA-A-55 822 5. PACKAGING. Preservation, packing, labeling, and marking shall be as specified in the contract or order. 6. NOTES 6.1 Source of documents. 6.1.1 American Plywood Association Standards are availabl

14、e fi-om the American Plywood Association, 701 1 S. 19th St., P.O. Box 11700, Tacoma, WA 9841 1-0700 6.1.2 Western Wood Products Association Standards are available from the Western Wood Products Association, Yeon Building, 522 S.W. Fifth Avenue, Portland, OR 97204-2122. 6.1.3 The Federal Acquisition

15、 Regulations may be obtained from the Superintendent of Documents, U.S. Government Printing Office, Washington, DC 20402-0001. 6.2 National s tock numbers (NSNs). The following table is a list of NSNs which correspond to this CID. The list may not be indicative of all possible NSNs associated with t

16、his document. TABLE 1. NSNs. 1375-00-2 12-460 1 3950-00-276-91 87 5 140-00-024-0335 5 140-00-092-9609 5 140-00-212-5324 5 140-00-392-271 8 5140-00-905-4381 5430-00-541 -2577 6230-00-355-5375 6635-00-527-5996 6675-00-249-0986 6675-00-561-0122 NSNs Assigned to A-A-55822 361 0-00-933-6279 3950-00-276-9

17、1 88 5 140-00-024-0336 5 140-00-092-9610 5 140-00-212-5325 5 140-00-392-2720 5420-00-034-7835 5430-00-693-2963 6635-00-371-9679 6675-00-026-0339 6675-00-249-0988 81 15-00-033-6542 3 895-00-883-7466 5 140-00-024-0332 5 140-00-024-0374 5 140-00-098-6846 5 140-00-2 12-5326 5 140-00-392-2721 5420-00-355

18、-61 50 5430-.OO-693-2965 6635-00-371-9685 6675-00-026-0340 6675-00-250-9194 8 145-00-693-2966 3 895-00-883-7444 5 140-00-024-0334 5 140-00-034-78 19 5 140-00-212-5323 5 140-00-212-5327 5 140-00-542-2362 5420-00-371 -9597 621 0-00-325-3020 6635-00-371-9686 6675-00-049-5 132 6675-00-254-8916 9905-00-3

19、71 -9408 4 Licensed by Information Handling ServicesA-A-55822 = 9999974 O373756 583 A-A-5 5 822 6.3 Ordering: data. Acquisition documents must specifj the following: a. Title, name, and date of this commercial item description. b. Length, width and height of the interior of the plywood chest. c. Det

20、ails of the interior arrangements, trays, partitions, and blocking requirements. d. The usage the chest is being put to, i.e., the contents, shape and weight. e. When skids are not required. f. The color the chest is to be painted. g. Loading plan, if required. h. Any special requirements. i. Any special packaging requirements. MILITARY INTERESTS: CIVIL AGENCY COORDINATING ACTIVITIES: Custodian Air Force - 99 Reviewers Navy - MC Air Force - O1 OASD - SO DLA- CS GSA - FSS PREPARING ACTIVITY: DLA - GS (Project No: MISC-0229) 5 Licensed by Information Handling Services