BS ISO IEC 29103-2011 Information technology Office equipment Colour photo test pages for measurement of ink cartridge yield for colour photo printing《信息技术 办公设备 用于测量印制彩色照片的墨盒的彩色照片试.pdf

《BS ISO IEC 29103-2011 Information technology Office equipment Colour photo test pages for measurement of ink cartridge yield for colour photo printing《信息技术 办公设备 用于测量印制彩色照片的墨盒的彩色照片试.pdf》由会员分享，可在线阅读，更多相关《BS ISO IEC 29103-2011 Information technology Office equipment Colour photo test pages for measurement of ink cartridge yield for colour photo printing《信息技术 办公设备 用于测量印制彩色照片的墨盒的彩色照片试.pdf（16页珍藏版）》请在麦多课文档分享上搜索。

1、raising standards worldwideNO COPYING WITHOUT BSI PERMISSION EXCEPT AS PERMITTED BY COPYRIGHT LAWBSI Standards PublicationBS ISO/IEC 29103:2011Information technology Office equipment Colour photo test pages for measurement of ink cartridge yield for colour photo printingBS ISO/IEC 29103:2011 BRITISH

2、 STANDARDNational forewordThis British Standard is the UK implementation of ISO/IEC 29103:2011.The UK participation in its preparation was entrusted to T e c h n i c a l C o m m i t t e e I S T / 3 , I T P r i n t e r s a n d C a r t r i d g e s .A list of organizations represented on this committee

3、 can be obtained on request to its secretary.This publication does not purport to include all the necessary provisions of a contract. Users are responsible for its correct application. BSI 2011 ISBN 978 0 580 57768 0 ICS 37.100.10 Compliance with a British Standard cannot confer immunity from legal

4、obligations.This British Standard was published under the authority of the Standards Policy and Strategy Committee on 31 May 2011.Amendments issued since publicationDate T e x t a f f e c t e dBS ISO/IEC 29103:2011Reference number ISO/IEC 29103:2011(E)ISO/IEC 2011INTERNATIONAL STANDARD ISO/IEC 29103

5、First edition 2011-05-01Information technology Office equipment Colour photo test pages for measurement of ink cartridge yield for colour photo printing Technologies de linformation quipement de bureau Pages dessai pour photographies en couleurs pour le mesurage du rendement des cartouches dencre po

6、ur limpression de photographies en couleurs BS ISO/IEC 29103:2011ISO/IEC 29103:2011(E) COPYRIGHT PROTECTED DOCUMENT ISO/IEC 2011 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including

7、 photocopying and microfilm, without permission in writing from either ISO at the address below or ISOs member body in the country of the requester. ISO copyright office Case postale 56 CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyrightiso.org Web www.iso.org Published i

8、n Switzerland ii ISO/IEC 2011 All rights reservedBS ISO/IEC 29103:2011ISO/IEC 29103:2011(E) ISO/IEC 2011 All rights reserved iiiForeword ISO (the International Organization for Standardization) and IEC (the International Electrotechnical Commission) form the specialized system for worldwide standard

9、ization. National bodies that are members of ISO or IEC participate in the development of International Standards through technical committees established by the respective organization to deal with particular fields of technical activity. ISO and IEC technical committees collaborate in fields of mu

10、tual interest. Other international organizations, governmental and non-governmental, in liaison with ISO and IEC, also take part in the work. In the field of information technology, ISO and IEC have established a joint technical committee, ISO/IEC JTC 1. International Standards are drafted in accord

11、ance with the rules given in the ISO/IEC Directives, Part 2. The main task of the joint technical committee is to prepare International Standards. Draft International Standards adopted by the joint technical committee are circulated to national bodies for voting. Publication as an International Stan

12、dard requires approval by at least 75 % of the national bodies casting a vote. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. ISO and IEC shall not be held responsible for identifying any or all such patent rights. ISO/IEC 29103

13、was prepared by Joint Technical Committee ISO/IEC JTC 1, Information technology, Subcommittee SC 28, Office equipment. BS ISO/IEC 29103:2011ISO/IEC 29103:2011(E) iv ISO/IEC 2011 All rights reservedIntroduction The purpose of this International Standard is to define a set of test images in a common f

14、ile format, JPEG, that are used in the testing of cartridge yield for printing of photographs. The defined documents are used in ISO/IEC 29102 to determine the photo yield of cartridges in an inkjet-based printing system. BS ISO/IEC 29103:2011INTERNATIONAL STANDARD ISO/IEC 29103:2011(E) ISO/IEC 2011

15、 All rights reserved 1Information technology Office equipment Colour photo test pages for measurement of ink cartridge yield for colour photo printing IMPORTANT The electronic file of this document contains colours which are considered to be useful for the correct understanding of the document. User

16、s should therefore consider printing this document using a colour printer. 1 Scope This International Standard defines colour test pages for the measurement of consumable yield when printing photographs. These pages can be used for any printing technology including multi-function devices that have a

17、 digital printing path, i.e. an all-in-one inkjet machine that has digital printing capabilities. This International Standard provides a set of test files in a common file format, JPEG, which would be used in the testing of consumable yield when printing photographs. The procedure for using these pa

18、ges for an inkjet printing system is defined in ISO/IEC 29102. 2 Terms and definitions For the purposes of this document, the following terms and definitions apply. 2.1 photo test suite collection of the six pages defined in this International Standard 3 Test suite description The photo test suite i

19、s composed of six pages. Each one of these pages is a composite of several photo thumbnail images along with diagnostic targets. The use of thumbnails is to provide a greater coverage of the printable gamut while using actual images and not synthetic images. The files are specified in 1800x1200 pixe

20、l and 1800x1350 pixel RGB JPEG format without any attached metadata. 3.1 Image size Worldwide there are several different “standard” paper sizes for printing snapshot photos. This International Standard alternates between 3:2 and 4:3 images to match the aspect ratio of most digital cameras. “Fit to

21、Print” or “Fit to Page” shall be used for testing with this image set. Test results generated using one print size cannot be converted to another size. 3.2 Diagnostic Target Description The diagnostic targets are designed to provide a simple visual tool to determine what colorant is out in a printin

22、g system. Figure 1 shows the diagnostic targets that are used in this International Standard, alternating between a horizontal orientation on even pages and a vertical orientation on odd pages. BS ISO/IEC 29103:2011ISO/IEC 29103:2011(E) 2 ISO/IEC 2011 All rights reservedFigure 1 Out of colorant targ

23、et BS ISO/IEC 29103:2011ISO/IEC 29103:2011(E) ISO/IEC 2011 All rights reserved 3Annex A (normative) Test suite thumbnails BS ISO/IEC 29103:2011ISO/IEC 29103:2011(E) 4 ISO/IEC 2011 All rights reservedBS ISO/IEC 29103:2011ISO/IEC 29103:2011(E) ISO/IEC 2011 All rights reserved 5BS ISO/IEC 29103:2011ISO

24、/IEC 29103:2011(E) 6 ISO/IEC 2011 All rights reservedBibliography 1 ISO/IEC 29102, Information technology Office equipment Method for the determination of ink cartridge photo yield for colour printing with inkjet printers and multi-function devices that contain inkjet printer components BS ISO/IEC 2

25、9103:2011BS ISO/IEC 29103:2011ISO/IEC 29103:2011(E) ICS 37.100.10 Price based on 6 pages ISO/IEC 2011 All rights reserved This page deliberately left blankBSI is the independent national body responsible for preparing British Standardsand other standards-related publications, information and service

26、s. It presents the UK view on standards in Europe and at the international level. It is incorporated by Royal Charter.British Standards Institution (BSI)raising standards worldwideBSI Group Headquarters389 Chiswick High Road London W4 4AL UKTel +44 (0)20 8996 9001Fax +44 (0)20 8996 Standards are up

27、dated by amendment or revision. Users of British Stan-dards should make sure that they possess the latest amendments or editions.It is the constant aim of BSI to improve the quality of our products and serv-ices. We would be grateful if anyone finding an inaccuracy or ambiguity whileusing this Briti

28、sh Standard would inform the Secretary of the technical com-mittee responsible, the identity of which can be found on the inside frontcover.Tel: +44 (0)20 8996 9001 Fax: +44 (0)20 8996 7001BSI offers Members an individual updating service called PLUS which ensuresthat subscribers automatically recei

29、ve the latest editions of standards.Tel: +44 (0)20 8996 7669 Fax: +44 (0)20 8996 7001Email: Buying standardsYou may buy PDF and hard copy versions of standards directly using acredit card from the BSI Shop on the website addition all orders for BSI, international and foreign standards publicationsc

30、an be addressed to BSI Customer Services.Tel: +44 (0)20 8996 9001 Fax: +44 (0)20 8996 7001Email: In response to orders for international standards, it is BSI policy tosupply the BSI implementation of those that have been publishedas British Standards, unless otherwise requested.Information on standa

31、rdsBSI provides a wide range of information on national, Europeanand international standards through its Knowledge Centre.Tel: +44 (0)20 8996 7004 Fax: +44 (0)20 8996 7005Email: Various BSI electronic information services are also available whichgive details on all its products and services. Tel: +4

32、4 (0)20 8996 7111 Fax: +44 (0)20 8996 7048Email: BSI Subscribing Members are kept up to date with standardsdevelopments and receive substantial discounts on the purchase priceof standards. For details of these and other benefits contact Membership Ad-ministration. Tel: +44 (0)20 8996 7002 Fax: +44 (

33、0)20 8996 7001 Email: Information regarding online access to British Standards via BritishStandards Online can be found at information about BSI is available on the BSI website at www.bsi- subsists in all BSI publications. BSI also holds the copyright,in the UK, of the publications of the internat

34、ional standardization bodies. Ex-cept as permitted under the Copyright, Designs and Patents Act 1988 no ex-tract may be reproduced, stored in a retrieval system or transmitted in anyform or by any means electronic, photocopying, recording or otherwise without prior written permission from BSI. This

35、does not preclude the freeuse, in the course of implementing the standard of necessary details such assymbols, and size, type or grade designations. If these details are to be usedfor any other purpose than implementation then the prior written permissionof BSI must be obtained. Details and advice can be obtained from the Copy-right & Licensing Manager.Tel: +44 (0)20 8996 7070Email: