ASTM E2753-2010 Standard Specification for Eretmocerus eremicus Rose and Zolnerowich (Hymenoptera Aphelinidae)《浆角蚜小蜂(Eretmocerus eremicus Rose and Zolnerowich)(膜翅目 小蜂科)的标准规范》.pdf

《ASTM E2753-2010 Standard Specification for Eretmocerus eremicus Rose and Zolnerowich (Hymenoptera Aphelinidae)《浆角蚜小蜂(Eretmocerus eremicus Rose and Zolnerowich)(膜翅目 小蜂科)的标准规范》.pdf》由会员分享，可在线阅读，更多相关《ASTM E2753-2010 Standard Specification for Eretmocerus eremicus Rose and Zolnerowich (Hymenoptera Aphelinidae)《浆角蚜小蜂(Eretmocerus eremicus Rose and Zolnerowich)(膜翅目 小蜂科)的标准规范》.pdf（3页珍藏版）》请在麦多课文档分享上搜索。

1、Designation: E2753 10Standard Specification forEretmocerus eremicus Rose and Zolnerowich(Hymenoptera: Aphelinidae)1This standard is issued under the fixed designation E2753; the number immediately following the designation indicates the year oforiginal adoption or, in the case of revision, the year

2、of last revision. A number in parentheses indicates the year of last reapproval. Asuperscript epsilon () indicates an editorial change since the last revision or reapproval.1. Scope1.1 This specification describes a method for determiningwhether the quantity and quality of adult Eretmocerus eremicus

3、in a shipment adhere to quantity and quality specifications. Thetest also allows the purity of shipments to be determined.Included are referenced documents, a description of standardterminology, specifications, and the test method.1.2 The values stated in SI units are to be regarded asstandard. No o

4、ther units of measurement are included in thisstandard.2. Referenced Documents2.1 ASTM Standards:2E2200 Specification for Information Included with Packag-ing of Multi-Cellular Biological Control Organisms3. Terminology3.1 name of productEretmocerus eremicus Gahan.3.2 preferred hosts and preyGreenho

5、use Whitefly, Tri-aleurodes vaporariorum (Westwood), Silverleaf Whitefly, Be-misia argentifolii Bellows and Perring and Tobacco Whitefly,Bemisia tabaci (Gennadius).3.3 life stage shippedpupa within the host insect, T.vaporariorum.3.4 carda sample unit. Pupae of Eretmocerus eremicusare mounted on car

6、dstock strips that are subdivided into“cards”.3.5 package claimthe number of adults expected toemerge from and leave each card.3.6 test statisticthe average number of wasps caughtduring the flight test expressed as a percentage of the packageclaim.3.7 critical valuea number that the test statistic i

7、s com-pared to in order to determine whether the quantity and qualityrequirement has been met. Critical values depend on theprobability of error that can be tolerated and on the number ofsamples used in the test.4. Classification4.1 PhylumArthropoda.4.2 ClassInsecta.4.3 OrderHymenoptera.4.4 FamilyAp

8、helinidae.4.5 GenusEretmocerus.4.6 Specieseremicus.5. Summary of Test Method (Determining the Number ofE. eremicus Released from a Shipment and itsConformity to the Standard)5.1 The test describes methods for determining whether thenumber of adult E. eremicus that are capable of flight meets orexcee

9、ds the package claim.Amethod of assessing the purity ofa shipment is included.5.2 The quantity of E. eremicus per card and their flightability is determined by counting the number of wasps caughton a sticky trap suspended in a test chamber. Three or more testchambers are used per shipment, each cham

10、ber contains onerandomly chosen card with E. eremicus pupae. The numbers ofwasps caught on each sticky card are counted and results areused to calculate the average number of wasps per card. Thisaverage is used in combination with the known samplingdistribution and variation in counts to judge wheth

11、er specifi-cations are met. Live contaminants are identified and recorded.5.3 Quantity and Quality SpecificationThe test describedin this document is used for both the quantity and qualityassessment. To meet the quantity and quality specificationdefined by the “package claim”, 100 % of the number of

12、 adultsshould be capable of flight as measured by the flight testdescribed herein.5.4 PurityThe purity specification is that shipments, andhence samples, do not contain species other than Eretmoceruseremicus.6. Significance and Use6.1 This method was developed to determine that thenumbers of E. erem

13、icus supplied in a shipment meet thepackage claim and that wasps at receipt have good flight1This specification is under the jurisdiction of ASTM Committee E35 onPesticides and Alternative Control Agents and is the direct responsibility ofSubcommittee E35.30 on Natural Multi-Cellular (Metazoan) Biol

14、ogical ControlOrganisms.Current edition approved April 1, 2010. Published May 2010.2For referenced ASTM standards, visit the ASTM website, www.astm.org, orcontact ASTM Customer Service at serviceastm.org. For Annual Book of ASTMStandards volume information, refer to the standards Document Summary pa

15、ge onthe ASTM website.1Copyright ASTM International, 100 Barr Harbor Drive, PO Box C700, West Conshohocken, PA 19428-2959, United States.capability. The application of this method will ensure astandardized evaluation of the product and judicious decisionsabout product compliance to the package claim

16、.7. Materials7.1 Test chamber (6.5 3 8 cm acrylic tube).7.2 Support wire.7.3 Double-sided dry-stick yellow sticky trap (2.5 3 4 cm).7.4 Nylon screen (100 micron mesh).7.5 Clear plastic cling-film (see Fig. 1).7.6 Headband magnifier (7 to 103) is optional.8. Test Unit8.1 A single shipment of E. eremi

17、cus is considered a testunit.9. Pre-Test Conditions9.1 If required, a shipment can be stored for a maximum 24h at 10 to 15C, relative humidity (RH) 60 to 90 %.10. Sample Size10.1 Choose three or more sample cards per shipment (seethe interpretation of results to decide on the sample size).11. Sampli

18、ng and Testing11.1 Place one card on the floor of each chamber. Positionthe yellow sticky trap inside the chamber on the support wire.Seal the top of the chamber with plastic wrap. Place thechamber within the crop, away from the heating pipes and outof direct sunlight. Test conditions should be with

19、in 20 to 25Cand 60 to 90 % RH.12. Counting Procedure and the Assessment of Purity12.1 After two weeks, count the number of wasps caught onthe sticky trap and calculate the average for all chambers used.Express the average as a percentage of the number expected(the package claim) from the card. This

20、value is called the teststatistic.12.2 Examine the parasitized scales and the yellow stickytrap and record the presence of other live insects or mitesappearing among the parasitoids.13. Properties of the Test13.1 In the absence of other data, the quantity and quality ofwasps in shipments are assumed

21、 to meet or exceed packageclaims. The test statistic and known properties of the counts ofwasps on sticky cards are used to judge whether the packageclaim is met. This is done by comparing the test statistic to acritical value (CV) that is tied to a probability of incorrectlydeclaring a shipment to

22、be substandard and to the number ofcards tested. The CVs for three sample sizes and differentprobabilities of error are presented in Table 2.ACVisdetermined by selecting a sample size (the number of cardsassessed) and a probability of error. For example, if 3 cardswere assessed and a probability of

23、error of 0.05 was chosen,CV = 90.13.2 Each probability of error in Table 2 is a measure of thelikelihood of wrongly categorizing the package to be deficientwhen it in fact has the specified number of healthy, flightcapable insects. More precisely, these are the probabilities ofobtaining a test stati

24、stic that is less than or equal to the CVwhen the package claim is exactly met. Note that for aparticular CV, the probability of error declines with increasingsample size reflecting the fact that the precision of the sampleinformation increases as the number of samples increase. Theprobabilities of

25、error were calculated using a normal distribu-tion model with a standard deviation of 10.60. This model wasfound to well describe counts of wasps caught in the flight testchamber. Additional details for this statistical model areprovided in the appendix.14. Interpretation of Results14.1 The quantity

26、 and quality of wasps in a shipment will beconsidered below the package claim when the test statistic isFIG. 1 Test ChamberTABLE 1 ExampleBased on 3 Random Samples and anExpectation of 60 Wasps/Card (the Package Claim)Sample Number Wasps on Yellow Card157254351Average 162/3 = 54Observed/Expected 100

27、 Observed/Expected 100 = 90%Example: Test statistic = 90TABLE 2 Critical Values for the 3 Sample Sizes (3, 5 and 10Cards) and Corresponding Probabilities of ErrorProbability of Error for Sample Size of:Count as %of standard351084 0.00 0.00 0.0085 0.01 0.00 0.0086 0.01 0.00 0.0087 0.02 0.00 0.0088 0.

28、02 0.01 0.0089 0.04 0.01 0.0090 0.05 0.02 0.0091 0.07 0.03 0.0092 0.10 0.05 0.0193 0.13 0.07 0.0294 0.16 0.10 0.0495 0.21 0.15 0.0796 0.26 0.20 0.12E2753 102smaller than the selected critical value. If an acceptable errorrate is 0.05, then the CV for a sample size of 3 is 82 % (Table2). For the exam

29、ple presented in the Table 1, the test statistic(90 %) is larger than 82 %; therefore, the shipment would beclassified as meeting the package claim. If 5 samples wereused, the CV with an error rate of 0.05 is 86 % (Table 2)sotheshipment would again be classified as meeting the packageclaim. However,

30、 if 10 samples were used, the CV for an errorrate of 0.05 is approximately 91 %, so now the shipment wouldbe classified as not meeting the package claim.15. Precision and Bias15.1 The probabilities of error shown in Table 2 reflect theprecision of the test. The bias for E. eremicus has not beenasses

31、sed.16. Keywords16.1 Bemisia argentifolii; Bemisia tabaci; Eretmocerus er-emicus; Greenhouse Whitefly; purity; quantity; SilverleafWhitefly; Tobacco Whitefly; Trialeurodes vaporariorum;whitefly parasiteAPPENDIX(Nonmandatory Information)X1. STATISTICAL BACKGROUNDX1.1 The test assumes that a shipment

32、meets the require-ment that the number of wasps that will emerge and fly is atleast 100 % of the package claim. Hence the null hypothesis is:Ho: $100 (X1.1)where: = the scaled mean number of wasps in a shipment that arecapable of flight.X1.2 We wish to determine a critical value (CV) withwhich to co

33、mpare a sample mean to so that the probability ofincorrectly declaring a shipment substandard is acceptable(e.g., # 0.05). This CV will depend on the number of samplestaken from a shipment and will increase as the number ofsamples increase. Thus, we seek to find a CV such that:Pr$x#CV | $100% 5 0.05

34、 (X1.2)X1.3 This is not possible unless is fixed. Because thisprobability will decrease for a fixed value of CV and increasingvalues of , we can set to 100 and determine CV so that:Pr$x#CV | 5 100% 5 0.05 (X1.3)X1.4 If sample counts (x) are distributed as normal randomvariables with known standard d

35、eviation, appropriate values ofCV can be determined using a normal cumulative distributionfunction.BIBLIOGRAPHY(1) van Lenteren, et al, “Guidelines for Quality Control of Commer-cially Produced Natural Enemies,” Quality Control and Produc-tion of Biological Control AgentsTheory and Testing Procedure

36、s,J. C. van Lenteren, Ed., CABI Publishing, 2003, pp. 286287.(2) Luczynski, A., et al, “Influence of Cold Storage on Pupal Devel-opment and Mortality During Storage and on Post-Storage Perfor-mance of Encarsia formosa and Eretmocerus eremicus (Hy-menoptera: Aphelinidae),” Biological Control, Vol 40,

37、 2007, pp.107117.ASTM International takes no position respecting the validity of any patent rights asserted in connection with any item mentionedin this standard. Users of this standard are expressly advised that determination of the validity of any such patent rights, and the riskof infringement of

38、 such rights, are entirely their own responsibility.This standard is subject to revision at any time by the responsible technical committee and must be reviewed every five years andif not revised, either reapproved or withdrawn. Your comments are invited either for revision of this standard or for a

39、dditional standardsand should be addressed to ASTM International Headquarters. Your comments will receive careful consideration at a meeting of theresponsible technical committee, which you may attend. If you feel that your comments have not received a fair hearing you shouldmake your views known to

40、 the ASTM Committee on Standards, at the address shown below.This standard is copyrighted by ASTM International, 100 Barr Harbor Drive, PO Box C700, West Conshohocken, PA 19428-2959,United States. Individual reprints (single or multiple copies) of this standard may be obtained by contacting ASTM at the aboveaddress or at 610-832-9585 (phone), 610-832-9555 (fax), or serviceastm.org (e-mail); or through the ASTM website(www.astm.org). Permission rights to photocopy the standard may also be secured from the ASTM website (www.astm.org/COPYRIGHT/).E2753 103