NAVY MIL-C-60555 (1)-1986 CARTRIDGE INITIATOR DELAY M113《M113型延迟引发炮筒》.pdf

《NAVY MIL-C-60555 (1)-1986 CARTRIDGE INITIATOR DELAY M113《M113型延迟引发炮筒》.pdf》由会员分享，可在线阅读，更多相关《NAVY MIL-C-60555 (1)-1986 CARTRIDGE INITIATOR DELAY M113《M113型延迟引发炮筒》.pdf（2页珍藏版）》请在麦多课文档分享上搜索。

1、MI b-C-60555 (OS ) AMENDMENT 1 8 December 1986 MILITARY SPECIFICATION CARTRIDGE, %FdPTIATOW, DELAY, Ml13 This amendment forms a part of FJ/lli%ary Specification MIL-C-6Q555(MU) dated 19 August 1966, and is approved for use within the Naval Sea Systems Command9 Department of the Navy, and is availabl

2、e for use by all Departments and Agencies OP the Department of Defense. PAGE 1 2.1 Delete: “MIL-E-5272 . . ell in Its entirety. Delete: “MIL-STD-639 e e .I in lts entirety. Add : WIL-STD-810 Envi ronmental Test Methods and Engi neeri ng Guidelines“. PAGE 2 : Add : II The following document forma a p

3、art of thPs speciPi c ified herein. Unless stherwise specified, the issues of the document which are DOD adopted shall be those listed in the issue of the DODISS specifled in the solicitation. Unless otherwise specified, the issues of documents not 1Psted in the DBBPSS shall be the issue of the nong

4、overnment documents which is current on the date of the sol Isitation. ANSI B46.1 (AppSPcation for copies should be addressed to the American National (Nongovernment standards and other pub1 ieations are normally available Surface Texture (Surface Roughness o bdaviness and Lay) Standards Institute (

5、ANSI) Prom the organlnatlon which prepares or whfch di %tri butes the documenta. These documents also may be available in or through librarles or other informational services. )I 1430 Broadway9 NY 10018) AMSC N/A Page 1 of 2 FSC DISTRIBUTION STATEMENT A: Approved Por pub1 ie release; distrfbution is

6、 unlirn 1377 ted. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-i M b-C-68555 ( QS ) AMENDMENT 1 3.5 Delete: IIe e e MIL-E-5272, Procedure XI1 o . .II and substitute Io . , MIL-SYD-810, Method 514.3, Test Procedure I, Test Condition I - 3.2.5 e . o

7、 e II PAGE 4 4.3.2 Delete: “The Ordnance Standard Finish Blocks prescribed in MIL-STD-639 . . .II md substitute “The roughness comparison standards prescr-ibed in ANSI B46.1 . . . II PAGE 8 4.4.2 Delete: le e . MIL-E-5272, Procedure X11“ and cubst9tute IIc o . MIL-STC-81Q9 Method 514.3$ Test Procedure 1, Test Condition I - 3.2.5“. Preparing act9 vi ty: Project No. l377-N857 Navy - OS 2 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-