FORD FLTM EU-BI 050-01-2001 EVAPORATION RATE OF SOLVENTS《溶剂的蒸发率》.pdf

《FORD FLTM EU-BI 050-01-2001 EVAPORATION RATE OF SOLVENTS《溶剂的蒸发率》.pdf》由会员分享，可在线阅读，更多相关《FORD FLTM EU-BI 050-01-2001 EVAPORATION RATE OF SOLVENTS《溶剂的蒸发率》.pdf（2页珍藏版）》请在麦多课文档分享上搜索。

1、 FORD LABORATORY TEST METHOD EU-BI 050-01 Date Action Revisions 2001 03 13 Revised Editorial no technical change A. Cockman 1994 02 28 Printed copies are uncontrolled Page 1 of 2 Copyright 2001, Ford Global Technologies, Inc. EVAPORATION RATE OF SOLVENTS Application This method is used to determine

2、the evaporation rate of solvents and diluents. The evaporation rate of a solvent is defined as the rate at which it will evaporate, at a temperature below its boiling point, when placed in an atmosphere of specified temperature and humidity. Apparatus and Materials Required Filter Paper Uniform tran

3、sparency, not hardened, even and of uniform density. Size approx 100 x 150 mm, e.g., Schleicher & Schll 598, Whatman No. 91, or equivalent. Diethylether Reference solvent. Pipette Petri Dish Approx 80 mm dia. Stop Watch Procedure 1. The test must be performed in a draught-free room at a temperature

4、20 +/-2 C and 65 +/- 3 % relative humidity. Ensure that all test equipment and the material under test have attained this temperature. Use a transparent screen for close observation to avoid heat (of breath, etc.) affecting the test. 2. Lay the filter paper across the top of the petri dish and using

5、 the pipette, drop 0.3 mL of the material under test on the filter paper within 5 s and start the stop watch at the last drop of material. The distance between pipette and paper must be 10 mm. FORD LABORATORY TEST METHOD EU-BI 050-01 Page 2 of 2 Copyright 2001, Ford Global Technologies, Inc. 3. Supp

6、ort the filter paper in a vertical position and allow to dry. 4. Stop the watch when by visual examination the filter paper appears to be dry. 5. The test must be run five times with alternate runs of the material under test and the referenced standard solvent (Diethylether) using a new filter paper

7、 for each test. Evaluation Calculate the average evaporation rate according to the following formula: Evaporation Rate = Average Evaporation Time of the Material Under Test Average Evaporation Time of the Reference Solvent Note: 1. For evaporation rates below 15 results should not differ by more tha

8、n +/-5 % of the average. 2. For high evaporation rates better results will be obtained if tests are run simultaneously with butyl acetate 98/100, evaporation rate 14, or ethylene glycol acetate, evaporation rate 60, for comparison. Chemicals, materials, parts, and equipment referenced in this document must be used and handled properly. Each party is responsible for determining proper use and handling in its facilities.