EN 12947-2000 en Liming Materials - Determination of Magnesium Content - Atomic Absorption Spectrometric Method《石灰浸物质 镁含量测定 原子吸收分光光度法》.pdf

《EN 12947-2000 en Liming Materials - Determination of Magnesium Content - Atomic Absorption Spectrometric Method《石灰浸物质 镁含量测定 原子吸收分光光度法》.pdf》由会员分享，可在线阅读，更多相关《EN 12947-2000 en Liming Materials - Determination of Magnesium Content - Atomic Absorption Spectrometric Method《石灰浸物质 镁含量测定 原子吸收分光光度法》.pdf（11页珍藏版）》请在麦多课文档分享上搜索。

1、STDOBSI BS EN 12747-ENGL 2000 = 1b24bb7 08b7443 O82 BRITISH STANDARD Liming materials - Determination of magnesium content - Atomic absorption spectrometric method The European Standard EN 129472000 has the status of a British Standard ICs 66.080 NO COPYING Wi“J3OuT BSI PERMISSION EXCEPT AS PEEMIlTE

2、D BY COPYBIGET LAW BS EN 12947:ZOOO National foreword AmdNo. Date This British Standard is the officiai English language version of EN 1294F2000. The UK participation in its preparation was enrusted to Technical Committee CII/37, Fertilizem and related chemicals, which has the responsibility to: com

3、ments - aid enquirem to understand the tee - present to the responsible European committee any enquiries on the - monitor related international and European developments and promulgate interpretation, or proposals for change, and keep the UK interests informed; them in the UK. A list of organization

4、s represented on this committee can be obtained on request to its secretary. The United Kingdom voted against the acceptance of this standard at the CEN Formai Vote stage because the precision data quoted for this method is incomplete and highly suspect. Cross-references The British Standards which

5、implement international or European publications referred to in this document may be found in the BSI Standards Catalogue under the section entitled %ternational Standards Correspondence Indexm, or by using the “Find“ facility of the BSI Standards Electronic Catalogue. A British Standard does not pu

6、rport to include all the necessary provisions of a contract. Usem of British Standards are responsible for their correct applidon. Compliance with a British Standard does not of itself confer immunity from legal obligations. Summary of pages This document comprises a front cover, an inside front cov

7、er, the EN title page, pages 2 to 8, an inside back cover and a back cover. The BSI copyright notice displayed in this document indicates when the document waslastissued. This British Standard, having been prepared under the direction of the Sector Committee for Materiais and Chemicals, was publishe

8、d under the authority of the Standards Committee and comes into effect on 16 August ZOO0 ISBN O 580 35921 2 Amendments issued since publication STD*BSI BS EN L29Li7-ENGL 2000 = Lb24bb9 08b74q5 955 = EUROPEAN STANDARD EN 12947 NORME EUROPENNE EUROPISCHE NORM June 2000 ICs 65.080 English version Limin

9、g materials - Determination of magnesium content - Atomic absorption spectrometric method Amendements calciques eou magnsiens - Dbtermination de la teneur en magnsium - Mthode par spectromtrie dabsorption atomique Calcium-/Magnesium-Bodanverbesserungsmittel - Bestimmung des Magnesiumgehaltes - Atoma

10、bsorptionsspekrometrisches Vetfahren This European Standard was approved by CEN on 13 November 1999. CEN members are bound to comply with the CENICENELEC Internal Regulations which stipulate the conditions for giving this Europmn Standard the status of a national standard without any alteration. Up-

11、todate lists and bibliographical references concerning sich national standards may be obtained on application to the Central Secretariat or to any CEN member. This European Standard exists in three official versions (English, French, German). A version in any other language made by tmslation under t

12、he responsibility of a CEN member into its own language and notified to the Central Secretariat has the same status as tie official versions. CEN members are the national standards bodies of Austria, Belgium, Czech Republic, Denmark, Finland, France, Germany, Greece, Iceland, Ireland, Italy, Luxembo

13、urg, Netherlands, Norway, Portugal, Spain, Sweden, Switzerland and United Kingdom. EUROPEAN COMMITTEE FOR STANDARDIZATION COMIT EUROPkEN DE NORMALISATION EUROPISCHES KOMITEE FUR NORMUNG Central Secretariat rue de Stassart, 36 8-1050 Brussels Q 2000 CEN All rights of exploitation in any form and by a

14、ny means reserved worldwide for CEN national Members. Ref. No. EN 12947:2000 E Page 2 EN 12947:2000 Contents Foreword . 3 1 Scope . 4 2 Normative references . 4 3 Principle . 4 4 Reagents 4 5 Apparatus 5 7 Procedure 5 8 Expression of results . 6 9 Precision - . 7 10 Test report . 7 Bibliography . 8

15、6 Sampling 5 OBSI oa2000 - STD*BSI BS EN L2747-ENGL 2000 W Lb24bb9 08b7447 728 Page 3 EN 12947:2000 Foreword This European Standard has been prepared by Technical Committee CENTTC 260, Fertilizers and liming materials, the Secretariat of which is held by DIN. This European Standard shall be given th

16、e status of a national standard, either by publication of an identical text or by endorsement, at the latest by December 2000, and conflicting national standards shall be withdrawn at the latest by December 2000. According to the CENICENELEC Internal Regulations, the national standards organizations

17、 of the following countries are bound to implement this European Standard: Austria, Belgium, Czech Republic, Denmark, Finland, France, Germany, Greece, Iceland, Ireland, Italy, Luxembourg, Netherlands, Norway, Portugal, Spain, Sweden, Switzerland and the United Kingdom. QBSI 08-2000 - STD*BSI BS EN

18、L2947-ENGL 2000 D Lb24bb9 OBb7448 bb4 Page 4 EN 12947:2000 I Scope This European Standard specifies a method for the determination of the magnesium content of all liming materials by atomic absorption spectrometry. 2 Nonnative references This European Standard incorporates by dated or undated refere

19、nce, provisions from other publications. These normative references are cited at the appropriate places in the text, and the publications are listed hereafter. For dated references, subsequent amendments to or revisions of any of these publications apply to this European Standard only when incorpora

20、ted in it by amendment or revision. For undated references the latest edition of the publication referred to applies (including amendments). EN 1482, Sampling of solid fertilizers and liming materials. IS0 331 0-1, Test sieves - Technical requirement and testing - Part I: Test sieves of metal wire c

21、loth. 3 Principle Dissolution of the test portion in diluted hydrochloric acid. Filtration and dilution. Determination of magnesium by flame atomic absorption spectrometry at a wavelength of 2852 nm. 4 Reagents 4.1 General Commercially available standard solutions may be used instead of standard sol

22、utions produced on-site in the laboratory. 4.2 Hydrochloric acid solution, diluted Dilute 500 ml of concentrated hydrochloric acid (pro = 1 ,I 8 g/ml) to I O00 ml with water. 4.3 Hydrochloric acid solution Approximately c(HCI) c 1 mol/l 4.4 Hydrochloric acid solution Approximately c(HCI) = 0,5 molA

23、4.5 Standard magnesium solution Containing 1,000 g of magnesium per litre. 4.5.1 hydrochloric acid solution (4.4) and dilute to the mark with the same solution. Weigh 1,013 g of magnesium sulfate (MgS04 7H20) into a 100 ml volumetric flask, dissolve in or 4.5.2 Heat magnesium oxide (MgO) at 600 “C f

24、or 2 h. Weigh 1,658 g of the freshly calcined MgO into a 500 ml beaker, dissolve in 100 ml of water and 120 ml of hydrochloric acid solution (4.3). Transfer quantitatively the solution to a 1 O00 ml volumetric flask, dilute to the mark with water and mix thoroughly. QBSI 08-2000 Page 5 EN 12947:2000

25、 4.6 Lanthanum solution, Containing 50 g lanthanum per litre. 4.6.1 Weigh 58,64 g lanthanum oxide (L%03) into a 600 ml beaker. Add 50 ml of water and carefully 250 ml of concentrated hydrochloric acid ro = 1 ,I8 glml). Stir, while cooling to room temperature. Transfer the solution quantitatively to

26、a 1 O00 ml volumetric flask, dilute to the mark with water and mix thoroughly. or; 4.6.2 Weigh 133,69 g of lanthanum chloride (Lach . 7H20) into a 600 ml beaker. Dissolve the salt in 500 ml of water under stirring. Transfer quantitatively to a 1 O00 ml volumetric flask, dilute to the mark with water

27、 and mix thoroughly. or 4.6.3 500 ml of water under stirring. Weigh 155,85 g of lanthanum nitrate (La(NC POV DI, D2, D, is the blank value, read off from the calibration graph for the blank solution; are the dilution factors m is the mass, of the test portion, in grams. The magnesium content express

28、ed as a mass fraction of MgO is obtained by dividing the above result by 0,6. 9 Precision 9.1 General The values derived from inter-laboratory tests. 9.2 Repeatability The absolute difference between two single results found on identical test materials by one operator using the same apparatus within

29、 the shortest feasible time interval will exceed the repeatability limit r in not more than 5 % of cases. The value is: r= 0,21 % 9.3 Reproducibility The absolute difference between two single test results on identical test material reported by two laboratories will exceed the reproducibility limit

30、R in not more than 5 % of the cases. The value is: R= 0,25 % 10 Test report The test report shall contain at least the following information: - all data necessary for the identification of the sample; - a reference to this European Standard; - the results and the units in which the results have been

31、 expressed; - any particular points observed in the course of the test; - any operations not specified in the method or regarded as optional which might have affected the results. OBSI 08-2000 STD*BSI BS EN 129ii7-ENGL 2000 M lb2rlbb9 OBb7r152 095 Page 8 EN 12947:2000 Bibliography VDLUFA, Manual II

32、of analysing methods for fertilizers. (VDLUFA-Verlag, Bismarckstrae 41 A, D-4293 Darmstadt). EC 77/535:1977, Council directive of 22.06.1977 on the approximation of laws in Member states regarding sampling and testing of fertilizers. OJEC no L 213/1 of 22.08.1977. QBSI 08-2000 BS EN 12947:2000 BSI 3

33、89 chiswicR High Road London w4 4AL BSI - British Standards Institution BSI is the independent national body responsible for preparing British Standards. It presents the UK view on standards in Europe and at the international level. It is incorporated by Royal Charter. Revisions British Standards ar

34、e updated by amendment or revision Users of British Standards should make sure that they possess the latest amendments or editions. It is the constant aim of BSI to improve the quality of our produds and services. We would be grateful if anyone finding an inaccuracy or ambiity while using this Briti

35、sh Standard would inform the Secretary of the technical committee responsible, the identity of which can be found on the inside front cover. Tek 020 8996 9OOO. Fax: O20 8996 7400. BSI offers members an individual updating service called PLUS which ensures that subscribers automatically receive the l

36、atest editions of standards. Buying standards rders for ali BSI, international and foreign standards pubiications should be adressed to Customer Services. Tek 020 8996 9001. Fax: O20 8996 7001. In response to orders for intemational standards, it is BSI policy to supply the BSI implementation of tha

37、w that have been published as British Standards, unless otherwise requested. Information on standards BSI provides a wide range of infodon on national, European and international standards through its Library and its Technical Help to Exporters Service. Various BSI electronic information services ar

38、e also available which give details on all its products and services. Contact the Information Centre. Tek O20 8996 7111. Fax: 020 8996 7048. Subscribing members of BSI are kept up to date with standards developments and receive substantial discounts on the purchase price of standards. For details of

39、 these and other benefits contact Membership fhM&n& ?on Tel O20 8996 7002. Fax: 020 8996 7001. Copyright Copyright subsists in all BSI publications. BSI also holds the copyright, in the UK, of the publications of the internationai stanaon bodies. Except as permiaed under the Copyright, Desii and Pat

40、ents Act 1988 no extsact may be reproduced, stored in a retrieval system or transmitted in any form or by any means - electronic, photocopying, recording or otherwise - without prior written permission from BSL This does not preclude the free use, in the course of implementing the standard, of neces

41、sary details such as symbols, and size, type or grade desigmtiors. If these details are to be used for any other purpose than implementation then the prior written permission of BSI must be obtained. if permission is granted, the tem may include royalty payments or a licensing agreement. Details and advice can be obtained from the Copyright Manager. Tek O20 8996 7070.