ASTM F1665-2008(2013) Standard Specification for Poly(Vinyl Chloride) (PVC) and Other Conforming Organic Polymer-Coated Steel Barbed Wire Used With Chain-Link Fence《与链状连接栅栏一起使用的聚氯乙.pdf
《ASTM F1665-2008(2013) Standard Specification for Poly(Vinyl Chloride) (PVC) and Other Conforming Organic Polymer-Coated Steel Barbed Wire Used With Chain-Link Fence《与链状连接栅栏一起使用的聚氯乙.pdf》由会员分享,可在线阅读,更多相关《ASTM F1665-2008(2013) Standard Specification for Poly(Vinyl Chloride) (PVC) and Other Conforming Organic Polymer-Coated Steel Barbed Wire Used With Chain-Link Fence《与链状连接栅栏一起使用的聚氯乙.pdf(4页珍藏版)》请在麦多课文档分享上搜索。
1、Designation: F1665 08 (Reapproved 2013)Standard Specification forPoly(Vinyl Chloride) (PVC) and Other Conforming OrganicPolymer-Coated Steel Barbed Wire Used With Chain-LinkFence1This standard is issued under the fixed designation F1665; the number immediately following the designation indicates the
2、 year oforiginal adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. Asuperscript epsilon () indicates an editorial change since the last revision or reapproval.1. Scope1.1 This specification covers PVC and other conformingo
3、rganic polymer-coated steel barbed wire consisting of twopolymer-coated strands, with four-point barbs of zinc-coatedsteel or aluminum alloy wire. PVC and other organic polymercoatings hereinafter will be designated as polymer coating.1.2 Barbed wire strand wire, produced from three classes ofwire c
4、oatings, is covered as follows:1.2.1 Class 1, consisting of a polymer coating extruded overzinc-coated or aluminum-coated or zinc-5 % aluminum-mischmetal alloy-coated steel wire;1.2.2 Class 2a, consisting of a polymer coating extrudedand adhered to zinc-coated or aluminum-coated or zinc-5 %aluminum-
5、mischmetal alloy-coated steel wire; and1.2.3 Class 2b, consisting of a polymer coating fused andadhered to zinc-coated or aluminum-coated or zinc-5 %aluminum-mischmetal alloy-coated steel wire.1.3 The values stated in inch-pound units are to be regardedas the standard. The values given in parenthese
6、s are forinformation only.2. Referenced Documents2.1 ASTM Standards:2A90/A90M Test Method for Weight Mass of Coating onIron and Steel Articles with Zinc or Zinc-Alloy CoatingsA370 Test Methods and Definitions for Mechanical Testingof Steel ProductsA428/A428M Test Method for Weight Mass of Coating on
7、Aluminum-Coated Iron or Steel ArticlesA700 Practices for Packaging, Marking, and Loading Meth-ods for Steel Products for ShipmentD1499 Practice for Filtered Open-Flame Carbon-Arc Expo-sures of PlasticsF552 Terminology Relating to Chain Link FencingF934 Specification for Colors for Polymer-Coated Cha
8、inLink Fence MaterialsG152 Practice for Operating Open Flame Carbon Arc LightApparatus for Exposure of Nonmetallic MaterialsG153 Practice for Operating Enclosed Carbon Arc LightApparatus for Exposure of Nonmetallic Materials2.2 Federal Standard:3Fed. Std. No. 123 Marking for Shipments (Civil Agencie
9、s)2.3 Military Standards:3MIL-STD-129 Marking for Shipment and StorageMIL-STD-163 Steel Mill Products, Preparation for Ship-ment and Storage3. Terminology3.1 DefinitionsFor definitions of terms such as fabric(chain-link fence), PVC, and polymer coating, see Terminol-ogy F552.4. Classification4.1 Pol
10、ymer-coated steel barbed wire is supplied in a choiceof two types as follows:4.1.1 Type I (Standard), with barbs spaced on 5-in. (127-mm) centers; and4.1.2 Type II (High Security), with barbs spaced on 3-in.(76-mm) centers.5. Ordering Information5.1 Orders for barbed wire purchased in accordance wit
11、hthis specification shall include the following information:5.1.1 Quantity (expressed in number of spools);5.1.2 Length of spools (1320 or 1000 ft (402 or 305 m); see9.4);5.1.3 Class of a polymer coating to be applied to metallic-coated steel strand wire;1This specification is under the jurisdiction
12、 of ASTM Committee F14 on Fencesand is the direct responsibility of Subcommittee F14.40 on Chain Link Fence andWire Accessories.Current edition approved March 1, 2013. Published March 2013. Originallyapproved in 1995. Last previous edition approved in 2008 as F1665 08. DOI:10.1520/F1665-08R13.2For r
13、eferenced ASTM standards, visit the ASTM website, www.astm.org, orcontact ASTM Customer Service at serviceastm.org. For Annual Book of ASTMStandards volume information, refer to the standards Document Summary page onthe ASTM website.3Available from Standardization Documents Order Desk, DODSSP, Bldg.
14、 4,Section D, 700 Robbins Ave., Philadelphia, PA 19111-5098, http:/www.dodssp.daps.mil.Copyright ASTM International, 100 Barr Harbor Drive, PO Box C700, West Conshohocken, PA 19428-2959. United States15.1.4 Color of coating;5.1.5 Type of barbs (galvanized steel or aluminum alloy; see6.3);5.1.6 Type
15、of barbed wire (Type I or II; see 4.1.1 and 4.1.2);5.1.7 Selection of type of metallic coating on the steel strandwire substrate, which shall be the choice of the producer unlessotherwise specified;5.1.8 Packaging requirements;5.1.9 ASTM designation and year of issue; and5.1.10 Certification, if req
16、uired;5.2 Any tests required other than those covered specificallyin this specification must be stipulated by the purchaser in theorder or contract.5.3 All spools of barbed wire accepted by the purchasershall be billed on the basis of the number and original length.NOTE 1A typical ordering descripti
17、on is as follows: 20 spoolspolymer-coated steel barbed wire, 1000-ft (305-m) spools, Class 2bcoating, olive green color, aluminum alloy barbs, Type II (high security),on pallets, certified this specification.6. Materials6.1 Base MetalThe base metal shall be steel of suchquality and purity that, when
18、 drawn to the size of wirespecified, it shall be of uniform quality and have properties andcharacteristics as prescribed in this specification.6.2 Wire used for the manufacture of strand wire shall meetthe requirements of this specification. The polymer coatingshall be formulated and produced proper
19、ly to conform to therequirements of this specification.6.3 Materials for Barbs:6.3.1 Zinc-Coated Steel Wire, if used for the barbs, shall be14 gage, 0.080 in. (2.03 mm), having a Class 3 zinc coating,minimum 0.70 oz/ft (215 g/m) when tested in accordance withTest Method A90/A90M.6.3.2 Aluminum Alloy
20、 Wire, if used for the barbs, shall be 14gage, 0.080 in. (2.03 mm), Alloy 5000-H38, 6061-T94, orequal, as agreed upon between the manufacturer and thepurchaser at the time of purchase.6.3.3 The choice of either zinc-coated steel wire or alumi-num alloy wire for the barbs shall be that of the manufac
21、turer,unless otherwise specified by the purchaser.7. Manufacture7.1 Class 1 polymer-coated wire shall have the coatingextruded onto the strand wire that conforms to the requirementsas given in Table 1.7.2 Class 2a polymer-coated wire shall have the coatingextruded and adhered to the strand wire that
22、 conforms to therequirements as given in Table 1.7.3 Class 2b polymer-coated wire shall have the coatingfused and adhered to the strand wire that conforms to therequirements as given in Table 1.8. Size and Construction8.1 All barbed wire furnished in accordance with thisspecification shall be fabric
23、ated from two strands of 14 gage,0.080-in. (2.03-mm) metallic-coated core, polymer-coatedsteel wire, with four-point barbs of 14 gage, 0.080-in. zinc-coated steel or aluminum alloy wire.9. Size and Permissible Variations9.1 Line WireThe permissible variation from the nominaldiameter of the wire shal
24、l be 60.004 in. (0.10 mm).9.2 BarbsDue to the mechanics of the manufacture whenforming the barbs, a certain amount of out-of-roundness can beexpected, and this precludes barbs from being subjected tochecks for other than nominal diameter and length. Measuredfrom the center of the two strand wires, t
- 1.请仔细阅读文档,确保文档完整性,对于不预览、不比对内容而直接下载带来的问题本站不予受理。
- 2.下载的文档,不会出现我们的网址水印。
- 3、该文档所得收入(下载+内容+预览)归上传者、原创作者;如果您是本文档原作者,请点此认领!既往收益都归您。
下载文档到电脑,查找使用更方便
5000 积分 0人已下载
下载 | 加入VIP,交流精品资源 |
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- ASTMF166520082013STANDARDSPECIFICATIONFORPOLYVINYLCHLORIDEPVCANDOTHERCONFORMINGORGANICPOLYMERCOATEDSTEELBARBEDWIREUSEDWITHCHAINLINKFENCE

链接地址:http://www.mydoc123.com/p-535353.html