ASTM E2727-2010e1 Standard Practice for Assessment of Rainwater Quality《雨水质量评估的标准实施规程》.pdf
《ASTM E2727-2010e1 Standard Practice for Assessment of Rainwater Quality《雨水质量评估的标准实施规程》.pdf》由会员分享,可在线阅读,更多相关《ASTM E2727-2010e1 Standard Practice for Assessment of Rainwater Quality《雨水质量评估的标准实施规程》.pdf(7页珍藏版)》请在麦多课文档分享上搜索。
1、Designation: E2727 101Standard Practice forAssessment of Rainwater Quality1This standard is issued under the fixed designation E2727; the number immediately following the designation indicates the year oforiginal adoption or, in the case of revision, the year of last revision. A number in parenthese
2、s indicates the year of last reapproval. Asuperscript epsilon () indicates an editorial change since the last revision or reapproval.1NOTETable X1.1 alignment was editorially corrected in October 2014.1. Scope1.1 This practice provides a methodology for assessingrainwater quality.1.1.1 This practice
3、 identifies a set of research and reportingrequirements that will permit the intended user to assess therainwater quality of a particular site.1.1.2 This practice characterizes rainwater quality in gen-eral and identifies site conditions that may affect rainwaterquality. Where site conditions affect
4、ing rainwater exist, addi-tional assessment techniques may be required.1.1.3 Objectives guiding the development of this practiceare (1) to synthesize and put in writing good commercial andcustomary practice for rainwater quality assessment; (2)tofacilitate high quality, standardized water stewardshi
5、p proto-cols; and (3) to clarify a standard of due diligence that ispractical and reasonable.1.2 This practice does not establish design requirements forrainwater harvesting systems. However, it may provide infor-mation in support of decisions relative to design and imple-mentation of rainwater harv
6、esting projects.1.3 This practice does not identify use(s) of rainwater,commercial or otherwise. However, it may provide informationin support of decisions relative to evaluation of propertyconditions and development options.1.4 This practice offers a set of instructions for performingone or more sp
7、ecific operations. This document cannot replaceeducation or experience and should be used in conjunction withprofessional judgment.1.4.1 Water laws vary among governing jurisdictions. It isthe responsibility of the user of this practice to determineregulatory requirements applicable to rainwater qua
8、lity assess-ment and potential use(s).1.5 The values stated in SI units are to be regarded asstandard. The values given in parentheses are mathematicalconversions to inch-pound units that are provided for informa-tion only and are not considered standard.1.6 This standard does not purport to address
9、 all of thesafety concerns, if any, associated with its use. It is theresponsibility of the user of this standard to establish appro-priate safety and health practices and determine the applica-bility of regulatory limitations prior to use.2. Referenced Documents2.1 ASTM Standards:2E1527 Practice fo
10、r Environmental Site Assessments: Phase IEnvironmental Site Assessment ProcessE1528 Practice for Limited Environmental Due Diligence:Transaction Screen ProcessE2114 Terminology for Sustainability Relative to the Perfor-mance of BuildingsE2635 Practice for Water Conservation in BuildingsThrough In-Si
11、tu Water Reclamation2.2 EPA Documents:3CERCLA Comprehensive Environmental Response, Com-pensation and Liability Act, commonly known as Super-fund3. Terminology3.1 Definitions:3.1.1 For terms related to sustainability relative to theperformance of buildings, refer to Terminology E2114.3.2 Definitions
12、 of Terms Specific to This Standard:3.2.1 adjacent site, nany property or properties the borderof which is contiguous or partially contiguous with that of theproperty, or that would be contiguous or partially contiguouswith that of the property but for a street, road, publicthoroughfare, or other ph
13、ysical barrier separating them.1This practice is under the jurisdiction of ASTM Committee E60 on Sustain-ability and is the direct responsibility of Subcommittee E60.01 on Buildings andConstruction.Current edition approved July 1, 2010. Published October 2010. DOI:10.1520/E2727-10E01.2For referenced
14、 ASTM standards, visit the ASTM website, www.astm.org, orcontact ASTM Customer Service at serviceastm.org. For Annual Book of ASTMStandards volume information, refer to the standards Document Summary page onthe ASTM website.3Available from United States Environmental Protection Agency (EPA), ArielRi
15、os Bldg., 1200 Pennsylvania Ave., NW, Washington, DC 20460, http:/www.epa.gov.Copyright ASTM International, 100 Barr Harbor Drive, PO Box C700, West Conshohocken, PA 19428-2959. United States13.2.2 brownfield site, nreal property, the expansion,redevelopment, or reuse of whichmay be complicated by t
16、hepresence or potential presence of a hazardous substance,pollutant, orcontaminant.3.2.2.1 DiscussionThe term “brownfield site“ does notinclude a site described in Comprehensive EnvironmentalResponse, Compensation, and Liability Act (CERCLA), com-monly known as Superfund, Section 101(39)(B), even th
17、oughthis language tracks the definition of “brownfield site“ inCERCLA Section 101(39)(A) and (B).3.2.3 building department records, nthose records of thelocal government in which the property is located indicatingpermission of the local government to construct, alter, ordemolish improvements on the
18、property.3.2.4 catchment area, nsurface, including hard roofs,from which rainwater may be collected.3.2.5 first flush filter, ndevice that automatically divertsthe first flow of rainwater collected from the catchment area.3.2.5.1 DiscussionA first flush filter device usually con-tains a temporary st
19、orage of 50100 L (13.2126.42 gal) (al-though size is determined by specific design objectives of therainwater harvesting system) and a simple valve unit consistingof a ball and seat. The initial rainfall fills the storage and floatsthe ball until it rises up to the seat, blocking the opening to thes
20、torage.3.2.6 intended user, nindividual or organization identifiedby the entity assessing rainwater quality as being the one whorelies on that information to make decisions.3.2.6.1 DiscussionThe intended user could be the client,the responsible party, program administrators, regulators, thefinancial
21、 community or other affected stakeholders, such aslocal communities, governmental agencies, or non-governmental organizations.3.2.7 nonpotable water, nwater that has not been treatedfor human consumption in conformance with applicable drink-ing water quality regulations.3.2.8 other contaminated site
22、, na facility that is describedin Comprehensive Environmental Response, Compensation,and Liability Act (CERCLA), commonly known as Superfund,Section 101(39)(B).3.2.8.1 DiscussionA facility that is listed on the NationalPriorities List4or is proposed for listing would be an exampleof a contaminated s
23、ite.3.2.9 potable water, nwater that does not endanger thelives or health of human beings and that conforms to applicableregulations for drinking water quality.3.2.10 rainwater harvesting, vcollecting rainwater from acatchment area and storing it for future use.3.2.11 recognized environmental condit
24、ion, nthe presenceor likely presence of any hazardous substances or petroleumproducts that may affect the catchment area.3.2.11.1 DiscussionThe term includes hazardous sub-stances or petroleum products even under conditions in com-pliance with laws. The term is not intended to include deminimis cond
- 1.请仔细阅读文档,确保文档完整性,对于不预览、不比对内容而直接下载带来的问题本站不予受理。
- 2.下载的文档,不会出现我们的网址水印。
- 3、该文档所得收入(下载+内容+预览)归上传者、原创作者;如果您是本文档原作者,请点此认领!既往收益都归您。
下载文档到电脑,查找使用更方便
5000 积分 0人已下载
下载 | 加入VIP,交流精品资源 |
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- ASTME27272010E1STANDARDPRACTICEFORASSESSMENTOFRAINWATERQUALITY 雨水 质量 评估 标准 实施 规程 PDF

链接地址:http://www.mydoc123.com/p-531772.html