ARMY MIL-PRF-55585 G-1997 ELECTRONICS EQUIPMENT AND PARTS PACKAGING OF《电子学装置和元件打包》.pdf

《ARMY MIL-PRF-55585 G-1997 ELECTRONICS EQUIPMENT AND PARTS PACKAGING OF《电子学装置和元件打包》.pdf》由会员分享，可在线阅读，更多相关《ARMY MIL-PRF-55585 G-1997 ELECTRONICS EQUIPMENT AND PARTS PACKAGING OF《电子学装置和元件打包》.pdf（5页珍藏版）》请在麦多课文档分享上搜索。

1、I NOT MEASUREMENT SENSITIVE I 9 October 1997 SUPERSEDING 20 March 1992 MIL-PRF- 55585G (CR) MIL-E- 55 585F (CR) PERFORMANCE SPECIFICATION ELECTRONICS EQUIPMENT AND PARTS, PACKAGING OF This specification is approved for use by Communications-Electronics Command, Department of the Army, and is availab

2、le for use by all Departments and Agencies of the Department of Defense. 1. SCOPE 1.1 Scope. This specification covers the packing and marking requirements for use in acquisition documents, contracts, or orders, for electronics equipment and parts containing packaging requirement codes, special pack

3、aging instructions, and specifications. 2. APPLICABLE DOCUMENTS 2.1 General. The documents listed in this section are specified in sections 3 and 4 of this specification. This section does not include documents cited in other sections of this specification or recommended for additional information o

4、r as examples. While every effort has been made to ensure the completeness of this list, document users are cautioned that they must meet all specified requirements documents cited in sections 3 and 4 of this specification, whether or not they are listed. 2.2 Government documents 2.2.1 Specification

5、s, standards, and handbooks The following specifications, standards, and handbooks form a part of this document to the extent specified herein. Unless otherwise specified, the issues of these documents shall be those listed in the issue of the Department of Defense Index of Specifications and Standa

6、rds (DODISS) and supplement thereto, cited in the solicitation (see 6.1). Beneficial comments (recommendations, additions, deletions) and any pertinent data which may be of use in improving this document should be addressed to: Commander, U.S. Army Communications-Electronics Command, ATTN: AMSEL-LC-

7、LEO-E-ET-3, Fort Monmouth, New Jersey 07703- 5023, by using the Standardization Document Improvement Proposal (DD Form 1426) appearing at the end of this document or by letter. AMSC N/A AREA - PACK DISTRIBUTION STATEMENT A Approved for public release; distribution is unlimited. Copyright Communicati

8、ons - Electronics Command Provided by IHS under license with CRAINot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-PRF- 5 5 5 85G (CR) STANDARDS DEPARTMENT OF DEFENSE MIL-STD-129 MIL-STD-2073-1 HANDBOOKS DEPARTMENT OF DEFENSE MIL-HDBK-129 MIL-HDBK-774 (Unless oth

9、erwise indicated, - Standard Practice for Military - Standard Practice for Military Marking Packaging - Military Marking - Palletized Unit Loads copies of the above specifications, standards, and handbooks are available from the Standardization Document Order Desk, 700 Robbins Avenue, Building 40, P

10、hiladelphia, PA 1911-5094.) 2.1.2 Other Government Documents, drawings, and publications The following government documents, drawings, and publications form a part of this document to the extent specified herein. Unless otherwise specified, the issues are those cited in the solicitation. CODE OF FED

11、ERAL REGULATIONS (CFR) CFR Title 49- Transportation (Application for copies should be addressed to the Superintendent of Documents, Government Printing Office, Washington, DC. 20402.) 2.2 Non-Government publications The following documents form a part of this document to the extent specified herein.

12、 Unless otherwise specified, the issues of the documents which are DoD adopted are those listed in the issue of the DODISS cited in the solicitation. Unless otherwise specified, the issues of documents not listed in the DODISS are the issues of the documents cited in the solicitation (see 6.1). AMER

13、ICAN SOCIETY FOR QUALITY CONTROL ASQC-21.4 - Sampling Procedures and Tables for (Application for copies should be addressed to the American Society for Quality Control, P.O. Box 3005, 611 E. Wisconsin Avenue, Milwaukee, WI 53201- 4606) Inspection by Attributes (DoD Adopted) AMERICAN SOCIETY FOR TEST

14、ING AND MATERIALS (ASTM) ASTM D 3951 - Standard Practice for Commercial Packaging (DoD Adopted) (Application for copies should be addressed to the American Society for Testing and Materials, 100 Barr Harbor Drive, West Conshohocken, PA). 2.3 Order of precedence In the event of a conflict between the

15、 text of this document and the reference cited herein the text of this document takes precedence. Nothing in this document, however, supersedes applicable laws and regulations unless a specific exemption has been obtained. Copyright Communications - Electronics Command Provided by IHS under license

16、with CRAINot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-PRF- 5 55 8 5G ( CR) 3. REQUIREMENTS 3.1 Packaging. 3.1.1 Military packaging Military packaging shall be accomplished as specified in MIL-STD-2073-1C. 3.1.2 Commercial packaging Commercial packaging will

17、be as specified in ASTM D 3951. 3.2. Unitization Palletization shall be required when quantities per destination exceed either a total of 250 pounds (excluding the pallet) or a volume of 20 cubic feet. A quantity of items, packed for shipment, shall be placed on pallets, standard size 40 by 48 inche

18、s as shown in MIL-HDBK-774. The load shall be bonded to the pallet by any means that will ensure safe delivery to destination. 3.3 Marking. 3.3.1 Military. In addition to any special marking required by the contract or order, military marking shall be in accordance with the requirements of MIL-STD-1

19、29. Further guidance is contained in MIL-HDBK-129. 3.3.1.1 Special marking requirements When required by the contract or order, containers shall be marked as specified. 3.3.1.1.1 Sensitive electronic devices Unit, intermediate, and exterior packs containing sensitive electronic devices susceptible t

20、o damage from environmental field forces shall be marked in accordance with MIL-STD-129 and MIL-HDBK-129. 3.3.2 Commercial. Items shall be marked in accordance with ASTM D 3951. 3.4 Hazardous materials In addition to the requirements of this specification, hazardous materials will be packaged, marke

21、d, and labeled according to the hazardous materials regulations of the Department of Transportation, Title 49 Code of Federal Regulations, Parts 100-199. 3.5 Workmanship The quality of workmanship shall be such as to permit acceptance of the completed packing requirements in accordance with the insp

22、ection provisions specified in section 4. 4. VERIFICATION 4.1 Packing inspection Inspection of packing and the marking for shipment and storage shall consist of the examinations specified in table I, “Packing inspection provisions. Lot formation shall consist of all packs made of the same materials

23、during an identifiable period and submitted at one time for acceptance. Sampling procedures shall be in accordance with ASQC-Z1.4. 3 Copyright Communications - Electronics Command Provided by IHS under license with CRAINot for ResaleNo reproduction or networking permitted without license from IHS-,-

24、,-I 103 MIL- PRF-5558 5G (CR) Shipping containers not in accordance with specification Visual TABLE I. Packing inspection provisions 107 108 I NO. I Weight and size exceed container limitations Strapping not in accordance with specification, incorrectly applied, omitted CHARACTERISTIC METHOD OF I IN

25、SPECTION I I101 I Intermediate container not as specified I I 102 I Improper closure of intermediate container Ivisua I104 I Excessive cube 105 I Improper blocking and bracing 106 I Closure not in accordance with specification Visual Visual Measure Visual I 109 I Marking omitted, incorrect, or illeg

26、ible 1 5. PACKAGING 5.1 Packaging. Not applicable to this specification. 6. NOTES (This section contains information of a general or explanatory nature that may be helpful, but is not mandatory.) 6.1 Acquisition requirements Acquisition documents should specify the following: a. Title, number, and d

27、ate of this specification. b. Issue of DODISS to be cited in the Solicitation, and if required, the c. Military or commercial packaging (see section 3). 6.2 Subject term (key word) listing specific issue of individual documents referenced (see 2.2.1 and 2.2). Intermediate Pack Packing Palletize Pres

28、enrat ion Unitization Unit Pack r, 6.3 Changes from previous issue Marginal notations are not used in this revision to identify changes with respect to the previous issue due to the extensiveness of the changes. 4 Copyright Communications - Electronics Command Provided by IHS under license with CRAI

29、Not for ResaleNo reproduction or networking permitted without license from IHS-,-,-Custodian : Army - CR MIL-PRF-55585G 99999Ob 2055b80 O4T Review activity Army - SM CONCLUDING MATERIAL Preparing activity: Amy - CR Pro) ect PACK-A398 1 5 Copyright Communications - Electronics Command Provided by IHS under license with CRAINot for ResaleNo reproduction or networking permitted without license from IHS-,-,-