ARMY MIL-PRF-39010 7 F-2008 COILS FIXED RADIO FREQUENCY MOLDED MICROMINIATURE (POWDERED IRON CORE) ESTABLISHED RELIABILITY AND NONESTABLISHED RELIABILITY《既设可靠度和非既设可靠度微小型(粉末铁心)模塑无线射.pdf

《ARMY MIL-PRF-39010 7 F-2008 COILS FIXED RADIO FREQUENCY MOLDED MICROMINIATURE (POWDERED IRON CORE) ESTABLISHED RELIABILITY AND NONESTABLISHED RELIABILITY《既设可靠度和非既设可靠度微小型(粉末铁心)模塑无线射.pdf》由会员分享，可在线阅读，更多相关《ARMY MIL-PRF-39010 7 F-2008 COILS FIXED RADIO FREQUENCY MOLDED MICROMINIATURE (POWDERED IRON CORE) ESTABLISHED RELIABILITY AND NONESTABLISHED RELIABILITY《既设可靠度和非既设可靠度微小型(粉末铁心)模塑无线射.pdf（5页珍藏版）》请在麦多课文档分享上搜索。

1、AMSC N/A FSC 5950 MIL-PRF-39010/7F 4 April 2008 SUPERSEDING MIL-PRF-39010/7E 27 August 1997 PERFORMANCE SPECIFICATION SHEET COILS, FIXED, RADIO FREQUENCY, MOLDED, MICROMINIATURE (POWDERED IRON CORE), ESTABLISHED RELIABILITY AND NONESTABLISHED RELIABILITY This specification is approved for use by all

2、 Departments and Agencies of the Department of Defense. The requirements for acquiring the product described herein shall consist of this specification sheet and MIL-PRF-39010. LTR Dimensions are in inches with metric equivalents (mm) in parentheses Minimum Maximum A B C D .146 (3.71) .365 (9.27) 1.

3、250 (31.75) .023 (0.58) .166 (4.22) .385 (9.78) 1.626 (41.30) .027 (0.69) NOTES: 1. Dimensions are in inches. 2. Metric equivalents are given for information only. FIGURE 1. Dimensions and configuration. INCH-POUNDCopyright Communications - Electronics Command Provided by IHS under license with CRAI

4、Not for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-PRF-39010/7F 2 REQUIREMENTS: Interface and physical dimensions: See figure 1. Material: Iron core. Weight: 0.03 ounce maximum. Operating temperature range: -55C to +105C. Dielectric withstanding voltage: Method 30

5、1 of MIL-STD-202; test voltage of 1,000 V rms. Barometric pressure: Method 105 of MIL-STD-202; test condition C, 70,000 feet with a test voltage of 200 V rms. Electrical characteristics: See table I and table II. Inductance: See table I. Inductance tolerance: See table I. Q values: See table I. Self

6、-resonant frequency: See table I. DC resistance: See table I. Temperature rise: 15C. Terminal pull: 5 pounds, minimum. Part or Identifying Number (PIN): M39010/07-(dash number from table I). Supersession data: This specification supersedes MS14046. Copyright Communications - Electronics Command Prov

7、ided by IHS under license with CRAINot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-PRF-39010/7F 3 TABLE I. Electrical characteristics (initial) and dash numbers. Dash number 1/ Inductance H Inductance tolerance percent Q minimum Test frequency (MHz) Self-resona

8、nt frequency minimum (MHz) DC resistance (25C) maximum (ohms) Rated dc current (mA) 2/ A5R1* A5R6* A6R2* A6R8* 5.1 5.6 6.2 6.8 5 5, 10 5 5, 10 45 45 45 50 7.9 7.9 7.9 7.9 60 60 55 55 0.32 0.32 0.50 0.50 495 495 395 395 A7R5* A8R2* A9R1* A100* 7.5 8.2 9.1 10.0 5 5, 10 5 5, 10 50 50 50 55 7.9 7.9 7.9

9、7.9 50 50 45 45 0.60 0.60 0.90 0.90 360 360 290 290 A110* A120* A130* A150* 11.0 12.0 13.0 15.0 5 5, 10 5 5, 10 55 65 65 65 2.5 2.5 2.5 2.5 42 42 40 40 1.10 1.10 1.40 1.40 265 265 240 240 A160* A180* A200* A220* 16.0 18.0 20.0 22.0 5 5, 10 5 5, 10 65 75 75 75 2.5 2.5 2.5 2.5 34 34 30 30 2.25 2.25 2.

10、50 2.50 185 185 175 175 A240* A270* A300* A330* 24.0 27.0 30.0 33.0 5 5, 10 5 5, 10 60 60 60 65 2.5 2.5 2.5 2.5 25 25 19 19 2.60 2.60 3.00 3.00 170 170 165 165 See footnotes at end of table. Copyright Communications - Electronics Command Provided by IHS under license with CRAINot for ResaleNo reprod

11、uction or networking permitted without license from IHS-,-,-MIL-PRF-39010/7F 4 TABLE I. Electrical characteristics (initial) and dash numbers. - continued Dash number 1/ Inductance H Inductance tolerance percent Q minimum Test frequency (MHz) Self-resonant frequency minimum (MHz) DC resistance (25C)

12、 maximum (ohms) Rated dc current (mA) 2/ A360* A390* A430* A470* 36.0 39.0 43.0 47.0 5 5 5 5 60 60 60 55 2.5 2.5 2.5 2.5 15.5 14.5 13.7 13.0 2.50 2.60 2.70 2.75 180 176 172 170 A510* A560* A620* A680* 51.0 56.0 62.0 68.0 5 5 5 5 55 55 55 55 2.5 2.5 2.5 2.5 12.7 12.0 11.5 11.0 2.85 3.00 3.15 3.30 167

13、 164 160 156 A750* A820* A910* A101* 75.0 82.0 91.0 100 5 5 5 5 55 50 50 50 2.5 2.5 2.5 2.5 10.5 10.3 10.0 9.5 3.70 3.90 4.30 4.50 147 143 136 133 A111* A121* A131* A151* 110 120 130 150 5 5 5 5 60 65 65 65 .79 .79 .79 .79 8.9 8.7 8.5 8.0 4.90 5.20 5.45 6.05 128 124 121 114 A161* A181* A201* A221* 1

14、60 180 200 220 5 5 5 5 65 65 65 65 .79 .79 .79 .79 7.5 7.0 6.5 6.2 6.40 6.75 7.10 7.45 111 108 106 103 A241* 240 5 65 .79 5.9 7.80 101 1/ The complete dash number will include two additional letters (indicated by *). The first additional letter will indicate the inductance tolerance and the second a

15、dditional letter will indicate the product level (e.g., C, M, P, R, S) and will be added to the end of the dash number. 2/ The rated dc current is based on 90C ambient temperature with a 15C rise. Copyright Communications - Electronics Command Provided by IHS under license with CRAINot for ResaleNo

16、reproduction or networking permitted without license from IHS-,-,-MIL-PRF-39010/7F 5 TABLE II. Electrical characteristics (final). 1/ Inspection group Allowable variation from initial measurement Allowable percent from specified minimum value in electrical characteristics (initial) table Inductance

17、(percent) DC resistance Self-resonant frequency Q Qualification inspection Group II Group IV Group V 2 5 5 (3% +.001 ohm) (2% +.001 ohm) 2/ 2/ -10 -10 -15 Quality conformance inspection Group B Subgroup 1 Subgroup 3 Subgroup 4 5 2 5 (2% +.001 ohm) (3% +.001 ohm) 2/ 2/ -15 -10 -10 1/ Test fixture all

18、owance of +.01 H shall be added to all change in inductance limits ( _ percent +.01 H). 2/ The self-resonant frequency shall be not less than the value specified in table I. Changes from previous issue. The margins of this specification are marked with vertical lines to indicate where changes from t

19、he previous issue were made. This was done as a convenience only and the Government assumes no liability whatsoever for any inaccuracies in these notations. Bidders and contractors are cautioned to evaluate the requirements of this document based on the entire content irrespective of the marginal no

20、tations and relationship to the last previous issue. Referenced documents. MIL-PRF-39010 MIL-STD-202 Custodians: Preparing activity: Army - CR Army - CR Navy - EC Air Force - 11 Agent: DLA - CC Review activities: Army - AR, CR4, MI Project 5950-2008-002 Navy - AS, CG, MC, OS, SH Air Force - 19, 99 D

21、LA CC NOTE: The activities listed above were interested in this document as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST Online database at http:/assist.daps.dla.mil. Copyright Communications - Electronics Command Provided by IHS under license with CRAINot for ResaleNo reproduction or networking permitted without license from IHS-,-,-