ARMY MIL-P-70762 (2)-1996 PROPELLANT COMPOSITE CAST FOR USE IN SIMULATOR MISSILE SAGGER XM27《赛格(SAGGER)XM27式导弹仿真器用模铸复合推进剂》.pdf

《ARMY MIL-P-70762 (2)-1996 PROPELLANT COMPOSITE CAST FOR USE IN SIMULATOR MISSILE SAGGER XM27《赛格(SAGGER)XM27式导弹仿真器用模铸复合推进剂》.pdf》由会员分享，可在线阅读，更多相关《ARMY MIL-P-70762 (2)-1996 PROPELLANT COMPOSITE CAST FOR USE IN SIMULATOR MISSILE SAGGER XM27《赛格(SAGGER)XM27式导弹仿真器用模铸复合推进剂》.pdf（3页珍藏版）》请在麦多课文档分享上搜索。

1、 MIL-P-70762 (2) 9999906 2016662 319 MILITARY I INCH-POUNDI MIL-P-70762 (AR) AMENDMENT 2 SUPERSEDING AMENDMENT 1 30 September 1991 O1 Februarv 1996 SPECIFICATION PROPELLANT, COMPOSITE, CAST, FOR USE IN SIMULATOR, MISSILE: SAGGER XM27 This Amendment forms a part of Military Specification MIL-P- 70762

2、 (AR), dated 12 April 1990, and is approved for use by the U;S. Army Armament, Research, Development and Engineering Center and is available for use by all Departments and Agencies of the Department of ,Defense. PAGE 1 * Title: Delete “SIMULATOR, MISSILE: SAGGER XM27“ and substitute “SIMULATOR, ANTI

3、-TANK GUIDED MISSTLE SIGNATURE: M27.“ PAGE 6 3.3.4 Delete “.890 50 calories per gram“ and substitute “850 2 50 calories per gram.“ PAGE 7 4.3.1 Delete paragraph 4.3.1 in its entirety and substitute the following paragraph: “4.3.1 Sub mission. The contractor shall submit a first article sample as des

4、ignated by the Contracting Officer for evaluation in accordance with the provisions of 4.3.2. The first article sample shall consist of five (5) blocks of propellant for lots of multiple mixer loads or three (3) blocks of propellant forlots of a single mixer load. The sample propellant shall have be

5、en vacuum cast and cured in accordance with note two (2) of drawing 12576572. Each block shall be large enough for all first article tests of Section 4.3.2, but -YSC N/A 1 of 3 FSC 1376 NT A. Approved for public release; distribution is unlimited. Provided by IHSNot for ResaleNo reproduction or netw

6、orking permitted without license from IHS-,-,-i MIL-P-70762 (AR) AMENDMENT 2 shall not be larger than 700 cubic inches. One of the five sample blocks shall be cast from the first mixer load and one from the last mixerload of the propellant lot. The three remaining sample blocks shall be randomly tak

7、en from the ,propellant mix if the lot contains more than one mixer load. If the lot is one mixer load, then one sample block shall be taken from the top, one from the bottom, and one from the middle. These samples shall be,obtained from the first production lot which has been produced by the contra

8、ctor using the same production process, procedures and equipment as will be used in fulfilling the contract. All material shall be obtained from the sources of supply as will be used in regular production. I PAGE 9 4.4.4 Delete paragraph 4.4.4 in its entirety, and substitute with: “4.4.4 mlitv confo

9、mce sou and testinq . The quality conformance sample shall consist of five (5) blocks of propellant for lots of multiple mixer loads or three (3) blocks of propellant for lots of a single mixer.load. These sample blocks shall have been vacuum cast and cured in accordance with note two (2) of drawing

10、 12576572. Each sample block shall be large enough to do the testing required but not larger than 300 cubic inches. One of the five sample blocks shallbe cast from the first mixer load and one from the last mixer load of propellant lot. The remaining three (3) sample blocks shall be randomly taken f

11、rom the propellant lot if a lot contains more than one mixer load. If the lot contains only one mixer load, then one sample block shall be cast from the top, one from the bottom, and one from the middle of the lot. Each of the sample blocks shall be subjected to all the tests of Section 3 and Sectio

12、n 4 of this specification. If any of the samples do not meet the requirements of Section 3, the lot shall be rejected.“ Note: The margins of this amendment are rkrked with asterisks to indicate where changes (additions, modifications, corrections, deletions) from the previous issue were made. This w

13、as done as a convenience only and the Government assumes no liability whatsoever for any inaccuracies in these notations. Bidders and contractors are cautioned to evaluate the requirements of this document based on the entire content irrespective of the marginal notations and relationship to the las

14、t previous issue. 2 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-Custodian: AITIIY - AR MIL-P-70762 (AR) AMENDMENT 2 Preparing activity: AW - AR (Project: 1376-0026) 3 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-