IPPC workshop on the practical application of ISPM No.15 28 .ppt

《IPPC workshop on the practical application of ISPM No.15 28 .ppt》由会员分享，可在线阅读，更多相关《IPPC workshop on the practical application of ISPM No.15 28 .ppt（34页珍藏版）》请在麦多课文档分享上搜索。

1、IPPC workshop on the practical application of ISPM No.15 28 February 2005 - 04 March 2005 Vancouver, CanadaBrent Larson, Standards Officer IPPC Secretariat, FAO, Rome, Italy,ISPM No.15 “Guidelines for Regulating Wood Packaging Material in International Trade” - An Overview -,Scope of ISPM No.15,To r

2、educe the risk of introduction and/or spread of pests associated with wood. Wood packaging material: including dunnage; made of coniferous and non-coniferous; used in international trade.,Basis for Regulating (Sec.1),Countries should have technical justification for requiring the application of the

3、approved measures described in this standard,Basis for Regulating (Sec.1),Raw wood may serve as a pathway for pests. Wood packaging is reused, recycled or remanufactured. Origin and phytosanitary status of wood packaging may not be known.,Basis for Regulating (Sec.1),Globally accepted measures appli

4、ed to wood packaging reduces the risk of pests.,Regulated Wood Packaging Material (Sec.2),pallets crating drums load boards skids,dunnage packing blocks cases pallet collars,Wood packaging material includes:,Regulated Wood Packaging Material (cont.),Wood packaging material, which sufficiently proces

5、sed to eliminate pests or which may not be pathways for pests, should not be regulated unless technically justified.,Regulated Wood Packaging Material (cont.),Processing includes: Using glue, heat and pressure or a combination; Veneer peeler cores, sawdust, wood wool, shavings; Raw wood cut into thi

6、n pieces (e.g. 6mm thickness or less).,Approved Measures (Sec.3.1),Approved measures should be accepted by all NPPOs without further requirements: Currently these are:Heat treatment; Methyl bromide fumigation.,Approved Measures (ANNEX I),Wood core temperature of 56C for a minimum of 30 minutes.,Heat

7、 treatment (HT),Approved Measures (ANNEX I),The minimum standard for MB treatment is as follows:,Methyl bromide fumigation (MB),The minimum temperature should not be less that 10C and the minimum exposure time should be 16 hours.,Approved Measures,Requiring phytosanitary measures beyond an approved

8、measure requires technical justification.,Marking for Approved Measures (ANNEX II),Wood packaging material subjected to the approved measures should display a specified mark shown in Annex II.,Marking for Approved Measures (cont.),The mark should at minimum include: Symbol; ISO two letter country co

9、de followed by a unique number assigned by the NPPO Abbreviation for the approved measure used Additional information used for identifying specific lots may be added.,Marking for Approved Measures (cont.),Marking should be: According to the model shown in Annex II; Legible; Permanent and not transfe

10、rable; Placed in a visible location on at least two opposite sides of the article being certified. Colors of red/orange should be avoided since these are used in the labeling of dangerous goods.,Marking for Approved Measures (cont.),Where debarking is required the letters DB should be added to the a

11、bbreviation of the approved measures. Other information may be included provided it is not confusing, misleading, or deceptive.,Marking for Approved Measures (cont.),Recycled, remanufactured or repaired wood packaging should be re-certified and re-marked after treatment. Shippers should be encourage

12、d to use appropriately marked wood for dunnage.,Marking for Approved Measures (ANNEX II),The mark shown below is to certify that the wood packaging material that bears the mark has been subjected to an approved measure.,Measures Pending Approval (Sec.3.2),Other treatments or processes will be approv

13、ed when it can be demonstrated that they provide an appropriate level of phytosanitary protection. (Annex III),Measures Pending Approval (cont.),The ICPM agreed to ask the International Forestry Quarantine Research Group (IFQRG) to review scientific information regarding ISPM No. 15 treatments.,Othe

14、r Measures (Sec.3.3),If a NPPO wants to apply measures other than the approved measures, these measures should be technically justified. The NPPOs of importing countries should consider other arrangements where there is evidence that the pest risk is adequately managed or absent.,Other Measures (con

15、t.),Subject to technical justification, countries may require that imported wood packaging subjected to an approved measure be made from debarked wood. Where debarking is required the letters DB should be added to the mark of the approved measure.,Dunnage (Sec.4),Wood packaging material used to secu

16、re or support a commodity but which does not remain associated with the commodity.,IPPC Definition:,Dunnage (cont.),Dunnage should also be treated and marked in accordance with Annex II as having been subjected to an approved measure. If not, it requires special consideration and should be made from

17、 bark-free wood.,Compliance Checks on Procedures Applied Prior to Export (Sec.5.1),The NPPO of exporting country has responsibility for ensuring that systems for exports meet the requirements set out in this standard.,Compliance Checks on Procedures Applied Prior to Export (cont.),Compliance checks

18、can be accomplished through: Monitoring certification and marking systems; Establishing inspection procedures (ISPM7); Registration or accreditation and auditing of companies applying the measures.,Procedures upon Import (Sec.6),Wood packaging materials are associated with almost all shipments inclu

19、ding those not normally the target of inspection.,Procedures upon Import (cont.),Cooperation with organizations not normally involved with meeting phytosanitary export conditions/import requirements is important. Cooperation with Customs organizations should be reviewed to ensure effectiveness in de

20、tecting potential non-compliance.,Measures for Non-compliance at Point of Entry (Sec.6.1),Action may be taken if wood packaging material does not have the required mark, or there is evidence of pests. The action may take the form of treatment, disposal or refused entry. NPPO of exporting country may

21、 be notified (based on ISPM 13).,Disposal (Sec.6.2),Disposal is a risk management option where treatment is not available or desirable. Recommended methods for disposal: Incineration; Burial; Processing; Other effective methods endorsed by NPPO.,IPPC Questions & Answers,The Q Whether particular repr

22、oductions of it proposed at national level are in line with Annex II. On the web at www.ippc.int,The final word,In case the standard does not provide guidance and issues on how the standard should be interpreted are raised, countries should interpret and implement the standard.,Brent Larson, Standards Officer, IPPC Secretariat, FAO Rome, Italy,