NEMA NTCIP 1210-2013 National Transportation Communications for ITS Protocol Field Management Stations (FMS) Part 1 Object Definitions for Signal System Masters (SSM) (Version v01).pdf

《NEMA NTCIP 1210-2013 National Transportation Communications for ITS Protocol Field Management Stations (FMS) Part 1 Object Definitions for Signal System Masters (SSM) (Version v01).pdf》由会员分享，可在线阅读，更多相关《NEMA NTCIP 1210-2013 National Transportation Communications for ITS Protocol Field Management Stations (FMS) Part 1 Object Definitions for Signal System Masters (SSM) (Version v01).pdf（263页珍藏版）》请在麦多课文档分享上搜索。

1、A Joint Publication of:American Association of State Highway and Transportation Officials (AASHTO) Institute of Transportation Engineers (ITE)National Electrical Manufacturers Association (NEMA)NTCIP Standards PublicationNTCIP 1210:2013 v01National TransportationCommunications for ITS ProtocolField

2、Management Stations (FMS)Part1: Object Definitions for Signal System Masters (SSM)A Joint Standard of AASHTO, ITE, and NEMAA Joint Standard of AASHTO, ITE, and NEMA NTCIP 1210 version v01 National Transportation Communications for ITS Protocol Field Management Stations (FMS) Part 1: Object Definitio

3、ns for Signal System Masters (SSM) published in September 2013 Published by American Association of State Highway and Transportation Officials (AASHTO) 444 North Capitol Street, N.W., Suite 249 Washington, D.C. 20001 Institute of Transportation Engineers (ITE) 1627 I (“Eye”) Street, N.W., Suite 600

4、Washington, D.C. 20006 National Electrical Manufacturers Association (NEMA) 1300 North 17th Street, Suite 900 Rosslyn, Virginia 22209-3801 file version 1210 v01.55p 2013b 2013 AASHTO / ITE / NEMA. All rights reserved. NOTICES Copyright Notice 2013 by the American Association of State Highway and Tra

5、nsportation Officials (AASHTO), the Institute of Transportation Engineers (ITE), and the National Electrical Manufacturers Association (NEMA). All intellectual property rights, including, but not limited to, the rights of reproduction, translation, and display are reserved under the laws of the Unit

6、ed States of America, the Universal Copyright Convention, the Berne Convention, and the International and Pan American Copyright Conventions. Except as licensed or permitted, you may not copy these materials without prior written permission from AASHTO, ITE, or NEMA. Use of these materials does not

7、give you any rights of ownership or claim of copyright in or to these materials. Visit www.ntcip.org for other copyright information, for instructions to request reprints of excerpts, and to request reproduction that is not granted below. PDF File License Agreement To the extent that these materials

8、 are distributed by AASHTO / ITE / NEMA in the form of an Adobe Portable Document Format (PDF) electronic data file (the “PDF file”), AASHTO / ITE / NEMA authorizes each registered PDF file user to view, download, copy, or print the PDF file available from the authorized Web site, subject to the ter

9、ms and conditions of this license agreement: a) you may download one copy of each PDF file for personal, noncommercial, and intraorganizational use only; b) ownership of the PDF file is not transferred to you; you are licensed to use the PDF file; c) you may make one more electronic copy of the PDF

10、file, such as to a second hard drive or burn to a CD; d) you agree not to copy, distribute, or transfer the PDF file from that media to any other electronic media or device; e) you may print one paper copy of the PDF file; f) you may make one paper reproduction of the printed copy; g) any permitted

11、copies of the PDF file must retain the copyright notice, and any other proprietary notices contained in the file; h) the PDF file license does not include (1) resale of the PDF file or copies, (2) republishing the content in compendiums or anthologies, (3) publishing excerpts in commercial publicati

12、ons or works for hire, (4) editing or modification of the PDF file except those portions as permitted, (5) posting on network servers or distribution by electronic mail or from electronic storage devices, and (6) translation to other languages or conversion to other electronic formats; i) other use

13、of the PDF file and printed copy requires express, prior written consent. Data Dictionary and MIB Distribution Permission To the extent that these materials are distributed by AASHTO / ITE / NEMA in the form of a Data Dictionary (“DD”) or Management Information Base (“MIB”), AASHTO / ITE / NEMA exte

14、nd the following permission: You may make or distribute unlimited copies, including derivative works, of the DD or MIB, including copies for commercial distribution, provided that: a) each copy you make or distribute includes the citation “Derived from NTCIP 0000 insert the standard number. Copyrigh

15、t by AASHTO / ITE / NEMA. Used by permission.”; b) the copies or derivative works are not made part of the standard publications or works offered by other standard developing organizations or publishers or as works-for-hire not associated with commercial hardware or software products intended for fi

16、eld implementation; c) use of the DD or MIB is restricted in that the syntax fields may only be modified to define: 1) a more restrictive subrange; or 2) a subset of the standard enumerated values; or 3) a set of retired and defined enumerated values for systems supporting multiversion interoperabil

17、ity; d) the description field may be modified but only to the extent that: 1) the more restrictive subrange is defined; and 2) only those bit values or enumerated values that are supported are listed. These materials are delivered “AS IS” without any warranties as to their use or performance. AASHTO

18、 / ITE / NEMA and their suppliers do not warrant the performance or results you may obtain by using these materials. AASHTO / ITE / NEMA and their suppliers make no warranties, express or implied, as to noninfringement of third party rights, merchantability, or fitness for any particular purpose. In

19、 no event will AASHTO / ITE / NEMA or their suppliers be liable to you or any third party for any claim or for any consequential, incidental or special damages, including any lost profits or lost savings, arising from your reproduction or use of these materials, even if an AASHTO / ITE / NEMA repres

20、entative has been advised of the possibility of such damages. Some states or jurisdictions do not allow the exclusion or limitation of incidental, consequential, or special damages, or the exclusion of implied warranties, so the above limitations may not apply to a given user. Use of these materials

21、 does not constitute an endorsement or affiliation by or between AASHTO, ITE, or NEMA and the user, the users company, or the products and services of the users company. If the user is unwilling to accept the foregoing restrictions, he or she should immediately return these materials. PRL and RTM Di

22、stribution Permission To the extent that these materials are distributed by AASHTO / ITE / NEMA in the form of a Profile Requirements List (“PRL”) or a Requirements Traceability Matrix (“RTM”), AASHTO / ITE / NEMA extend the following permission: a) you may make or distribute unlimited copies, inclu

23、ding derivative works of the PRL (then known as a Profile Implementation Conformance Statement (“PICS”) or the RTM, provided that each copy you make or distribute contains the citation “Based on NTCIP 0000 insert the standard number PRL or RTM. Used by permission. Original text AASHTO / ITE / NEMA.”

24、; b) you may only modify the PRL or the RTM by adding: 1) text in the Project Requirements column, which is the only column that may be modified to show a products implementation or the project-specific requirements; and/or 2) additional table columns or table rows that are clearly labeled as ADDITI

25、ONAL for project-unique or vendor-unique features; and c) if the PRL or RTM excerpt is made from an unapproved draft, add to the citation “PRL (or RTM) excerpted from a draft standard containing preliminary information that is subject to change.” This limited permission does not include reuse in wor

26、ks offered by other standards developing organizations or publishers, and does not include reuse in works-for-hire, compendiums, or electronic storage devices that are not associated with procurement documents, or commercial hardware, or commercial software products intended for field installation.

27、A PICS is a Profile Requirements List that is completed to indicate the features that are supported in an implementation. Visit www.ntcip.org for information on electronic copies of the MIBs, PRLs, and RTMs. Content and Liability Disclaimer The information in this publication was considered technica

28、lly sound by the consensus of persons engaged in the development and approval of the document at the time it was developed. Consensus does not necessarily mean that there is unanimous agreement among every person participating in the development of this document. AASHTO, ITE, and NEMA standards and

29、guideline publications, of which the document contained herein is one, are developed through a voluntary consensus standards development process. This process brings together volunteers and seeks out the views of persons who have an interest in the topic covered by this publication. While AASHTO, IT

30、E, and NEMA administer the process and establish rules to promote fairness in the development of consensus, they do not write the document and they do not independently test, evaluate, or verify the accuracy or completeness of any information or the soundness of any judgments contained in their stan

31、dards and guideline publications. AASHTO, ITE, and NEMA disclaim liability for any personal injury, property, or other damages of any nature whatsoever, whether special, indirect, consequential, or compensatory, directly or indirectly resulting from the publication, use of, application, or reliance

32、on this document. AASHTO, ITE, and NEMA disclaim and make no guaranty or warranty, express or implied, as to the accuracy or completeness of any information published herein, and disclaims and makes no warranty that the information in this document will fulfill any of your particular purposes or nee

33、ds. AASHTO, ITE, and NEMA do not undertake to guarantee the performance of any individual manufacturer or sellers products or services by virtue of this standard or guide. In publishing and making this document available, AASHTO, ITE, and NEMA are not undertaking to render professional or other serv

34、ices for or on behalf of any person or entity, nor are AASHTO, ITE, and NEMA undertaking to perform any duty owed by any person or entity to someone else. Anyone using this document should rely on his or her own independent judgment or, as appropriate, seek the advice of a competent professional in

35、determining the exercise of reasonable care in any given circumstances. Information and other standards on the topic covered by this publication may be available from other sources, which the user may wish to consult for additional views or information not covered by this publication. AASHTO, ITE, a

36、nd NEMA have no power, nor do they undertake to police or enforce compliance with the contents of this document. AASHTO, ITE, and NEMA do not certify, test, or inspect products, designs, or installations for safety or health purposes. Any certification or other statement of compliance with any healt

37、h or safety-related information in this document shall not be attributable to AASHTO, ITE, or NEMA and is solely the responsibility of the certifier or maker of the statement. Trademark Notice NTCIP is a trademark of AASHTO / ITE / NEMA. All other marks mentioned in this standard are the trademarks

38、of their respective owners. NTCIP 1210 v01.55 Page i 2013 AASHTO / ITE / NEMA Do Not Copy Without Written Permission ACKNOWLEDGEMENTS NTCIP 1210 v01 was prepared by the NTCIP Field Master Stations Working Group (FMS WG), which is a subdivision of the Joint Committee on the NTCIP. The Joint Committee

39、 on the NTCIP is organized under a Memorandum of Understanding among the American Association of State Highway and Transportation Officials (AASHTO), the Institute of Transportation Engineers (ITE), and the National Electrical Manufacturers Association (NEMA). The Joint Committee on the NTCIP consis

40、ts of six representatives from each of the standards organizations, and provides guidance for NTCIP development. When NTCIP 1210 v01 was prepared, the following individuals were active members of the NTCIP FMS WG: Robert Betts John Black Al Bonificio Rick Denney (Chair) Robert De Roche Bud Kent Kai

41、Leung Andy Mao Greg Mizell Ken Montgomery Saeed Nowkhasteh Peter Ragsdale Guillermo Ramos Joerg Rosenbohm Jo Versavel Other individuals providing input to NTCIP 1210 v01 include: Ralph Boaz Jack Brown Jeff Brummond Patrick Chan Blake Christie Gary Duncan Bruce Eisenhart Jim Forbes Craig Gardner Curt

42、is Gobeli Curtis Herrick David McKinley John Michael Amrish Raj David Richie Mike Shea Ray Starr Warren Tighe Ken Vaughn Jeris White In addition to the many volunteer efforts, recognition is also given to those organizations that supported FMS WG efforts by providing comments and funding, including:

43、 U.S. Department of Transportation, Research and Innovative Technology Administration Caltrans Consensus Systems Technologies Econolite Control Products Florida Department of Transportation G.C. Herrick and Associates Georgia Department of Transportation Harris County Iteris McCain Traffic Supply, I

44、nc. Ministry of Transportation, Ontario, Canada Minnesota Department of Transportation Naztec, Inc. New York State DOT Noblis Peek Traffic Systems Pillar Consulting Robert De Roche Consulting Siemens ITS Southwest Research Institute SRF Consulting Group, Inc. Telvent Farradyne Texas Department of Tr

45、ansportation Washington State Department of Transportation NTCIP 1210 v01.55 Page ii Do Not Copy Without Written Permission 2013 AASHTO / ITE / NEMA INTRODUCTION NTCIP 1210 v01 defines the management information related to a Signal System Master (SSM). SSM management information includes individual

46、parameters that represent the configuration, status, and control information that is unique to SSMs. NTCIP 1210 v01 also includes pre-defined message sets of these parameters and others from other standards to address operational and informational exchanges in a baseline system configuration. The pa

47、rameters and message sets are collectively referred to as objects. Specific groupings of these parameters and others to address operational configuration, monitoring, and control in a baseline system configuration are defined. The objects are defined using several ASN.1 Macros that were initially de

48、veloped for use with Internet information management. The macros have been modified to include additional information specific to NTCIP and ITS Data Dictionaries and Message Sets. NTCIP 1210 v01 defines requirements that are applicable to an NTCIP environment that involves the control of traffic sig

49、nal controllers. While the term SSM implies some type of physical device, many of the data concepts are applicable to any logical implementation. By definition, an SSM operates in the context of a “system“ that includes traffic signal controllers and office, computer-based traffic management center software. NTCIP 1210 v01, therefore, imposes requirements on both of these “system“ components, as well. NTCIP 1210 v01 defines requirements that are applicabl