FORD FLTM BN 114-01-2001 THICKNESS TEST FOR AUTOMOTIVE TEXTILE MATERIALS (Replaces FLTM BN 014-01 FLTM EU-BN 014-01)《汽车纺织材料的厚度试验 替代FLTM BN 014-01 FLTM EU-BN 014-01[替代 FORD FLTM BN .pdf

《FORD FLTM BN 114-01-2001 THICKNESS TEST FOR AUTOMOTIVE TEXTILE MATERIALS (Replaces FLTM BN 014-01 FLTM EU-BN 014-01)《汽车纺织材料的厚度试验 替代FLTM BN 014-01 FLTM EU-BN 014-01[替代 FORD FLTM BN .pdf》由会员分享，可在线阅读，更多相关《FORD FLTM BN 114-01-2001 THICKNESS TEST FOR AUTOMOTIVE TEXTILE MATERIALS (Replaces FLTM BN 014-01 FLTM EU-BN 014-01)《汽车纺织材料的厚度试验 替代FLTM BN 014-01 FLTM EU-BN 014-01[替代 FORD FLTM BN .pdf（1页珍藏版）》请在麦多课文档分享上搜索。

1、FORD LABORATORY TEST METHOD BN 114-01 Date 2001 O9 11 1990 05 18 THICKNESS TEST FOR AUTOMOTIVE TEXTILE MATERIALS Action Revisions Revised Editorial - no technical change A. Cockman Application This procedure is used to determine the thickness of fiber padding and other materials when specified. Appa

2、ratus Required Platen Square platen($ with dimensions greater than 100 x 100 mm and weighing 85 g (and 280 g respectively if specified in the applicable Engineering Material Specification or when FLTM BN 14-2 is specified or when firm padding materials are being tested). Vernier Gage Conditioning an

3、d Test Conditions All test values indicated herein are based on material conditioned in a controlled atmosphere of 23 +/- 2 OC and 50 +/- 5 % relative humidity for not less than 24 h prior to testing and tested under the same conditions unless otherwise specified. Procedure 1. Cut 100 x 100 mm speci

4、mens at random from across the width of the roll and build up to a pile not less than 25 mm in thickness. 2. Condition specimens for 24 h at 23 +/- 2 OC and 50 +/- 5 % relative humidity. (The measurements must also be made in a room maintained under these conditions.) 3. Place the square (85 g) plat

5、en over the specimens and measure the thickness (using the vernier gage or equivalent) at the four corners of the platen. (Use other weight platens as specified by the applicable Engineering Material Specification, e.g., a 280 g platen is to be used when firm padding materials are to be tested.) 4.

6、Take the average of these four values and divide by the number of layers to obtain the thickness. Chemicals, materials, parts, and equipment referenced in this document must be used and handled properly. Each party is responsible for determining proper use and handling in its facilities. Copynght02001, Ford Global Technologies, Inc