DLA DSCC-DWG-89083 REV D-2006 CONNECTOR ELECTRICAL INSERT ARRANGEMENT MINIATURE FORTY ONE SIZE 20 SIGNAL CONTACTS WITH TWO SIZE 8 CONTACT CAVITIES《插入管理微型四十一号20次信号接触带二号8次接触能力的连接器》.pdf

《DLA DSCC-DWG-89083 REV D-2006 CONNECTOR ELECTRICAL INSERT ARRANGEMENT MINIATURE FORTY ONE SIZE 20 SIGNAL CONTACTS WITH TWO SIZE 8 CONTACT CAVITIES《插入管理微型四十一号20次信号接触带二号8次接触能力的连接器》.pdf》由会员分享，可在线阅读，更多相关《DLA DSCC-DWG-89083 REV D-2006 CONNECTOR ELECTRICAL INSERT ARRANGEMENT MINIATURE FORTY ONE SIZE 20 SIGNAL CONTACTS WITH TWO SIZE 8 CONTACT CAVITIES《插入管理微型四十一号20次信号接触带二号8次接触能力的连接器》.pdf（6页珍藏版）》请在麦多课文档分享上搜索。

1、REVISIONS LTR DESCRIPTION DATE APPROVED A Changes in accordance with NOR 5935-R022-92. Add DESC part numbers and corresponding vendor part numbers for CAGE 28198. 92-05-08 James P. Donohue B Clarify dimensions on figure 1. Correct part numbers on page 5. Change “part number” to Part of Identifying N

2、umber (PIN)”. Editorial changes throughout. 93-10-27 James P. Donohue C Vendor CAGE 60563, PINs, delete and substitute new PINs. Editorial changes throughout. 01-01-22 Robert M. Heber D Add Vendor CAGE SW884, delete MIL-STD-1344 test methods, add EIA-364 test procedures 06-01-20 Richard L. Taylor Pr

3、epared in accordance with ASME-Y14.100 REV PAGE REV D C C D D D REV STATUS OF PAGES PAGE 1 2 3 4 5 6 PREPARED BY PMIC G Ralph Antonelli DEFENSE SUPPLY CENTER, COLUMBUS COLUMBUS, OHIO 43218-3990 CHECKED BY TITLE Carl Dello-Stritto APPROVED BY Charles W. Koeller CONNECTOR, ELECTRICAL, INSERT ARRANGEME

4、NT, MINIATURE, FORTY ONE SIZE 20 SIGNAL CONTACTS, WITH TWO SIZE 8 CONTACT CAVITIES SIZE CAGE CODE 037Z3 DWG. NO.89083 Original date of drawing 31 July 1990 A REV D PAGE 1 OF 6 AMSC N/A 5935-E778-000 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-SIZ

5、E CAGE CODE DWG NO. Engaging face (pin) Inches mm Inches mm .055 .056 .109 .112 .163 .218 .272 .326 .381 .435 1.40 1.42 2.77 2.84 4.14 5.54 6.41 8.28 9.68 11.05 .489 .540 .544 .598 .652 .707 .761 .810 .815 .870 12.42 13.72 13.81 15.19 16.56 17.96 19.33 20.57 20.70 22.10 NOTES: 1. Dimensions are in i

6、nches. 2. Metric equivalents are given for general information only. 3. Unless otherwise specified, tolerance for three place decimals is .005 inch (0.13 mm). 4. All dimensions are true position (TP). 5. Contact holes in insert shall be located on TP within a .005 inch (0.13 mm) diameter circle. 6.

7、Markings are shown for the pin insert front. Socket inserts are the opposite. 7. Reference documents shall be of the issue in effect on date of invitations for bid. FIGURE 1. Insert arrangement forty one size 20 signal contacts, with two size 8 contact cavities. 037Z3 89083 DEFENSE SUPPLY CENTER, CO

8、LUMBUS COLUMBUS, OH 43218-3990 A REVC PAGE2 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-SIZE CAGE CODE DWG NO. ENGINEERING DATA: Voltage rating: 500 volts rms at sea level. Operating temperature: -55C to +125C. REQUIREMENTS: Requirements of drawi

9、ng 85039 and MIL-DTL-24308 are applicable. Dimensions and configurations: See figure 1. Signal contact specifications: Style A (crimp removable signal contacts): Socket: M39029/63-368. Pin: M39029/64-369. Style B (solder fixed signal contacts): Socket: MIL-DTL-24308, Appendix B, figure B-1. Pin: MIL

10、-DTL-24308, Appendix B, figure B-2. Shell size: Five. Shell specifications: Style A: Socket: MIL-DTL-24308/2, figure 1. Pin: MIL-DTL-24308/4, figure 1. Style B: Socket: MIL-DTL-24308/1, figure 1. Pin: MIL-DTL-24308/3, figure 1. Tools: Connectors with crimp removable signal contacts shall be designat

11、ed for contact insertion and removal with the applicable military tool as follows: Contact size Tool PIN20 M81969/39 - 01 with plastic tip M81969/1-02 with metal tip 037Z3 89083 DEFENSE SUPPLY CENTER, COLUMBUS COLUMBUS, OH 43218-3990 A REVC PAGE3 Provided by IHSNot for ResaleNo reproduction or netwo

12、rking permitted without license from IHS-,-,-SIZE CAGE CODE DWG NO. Mating and unmating forces (with signal contacts only installed): See table I. TABLE I. Mating and unmating forces. Mating force (pounds) Unmating force (pounds) Contact type Minimum Maximum Minimum Maximum Signal 1.58 26.85 1.58 15

13、.8 Contact resistance: See table II. TABLE II. Contact resistance (millivolts maximum). 1/ Contact classes G, D, M, N Contact Size AWG wire Size Test current (amperes) After salt spray All others 20 24 20 3.0 7.5 55 65 45 55 1/ Not applicable to crimp or shielded contacts. Dielectric withstanding vo

14、ltage: See table III. TABLE III. Dielectric withstanding voltage. Altitude Humidity condition All other conditions Sea level 600 1,000 70,000 - 325 Vibration: Test procedure EIA364-28, test condition IV. Temperature cycling: Test procedure EIA364-32, condition 1, 5 cycles, except temperature shall b

15、e -55C to +125C. 037Z3 89083 DEFENSE SUPPLY CENTER, COLUMBUS COLUMBUS, OH 43218-3990 A REVD PAGE4 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-SIZE CAGE CODE DWG NO. Approved sources of supply are listed herein. Additional sources will be added as

16、 they become available. The vendors listed on the requirements drawing have agreed to this drawing and a certificate of compliance has been submitted to DSCC-VAI. Vendor similar PIN 1/ DSCC drawing PIN 2/ 3/ 4/ 5/ CAGE 71468 CAGE 60563 CAGE 28198 CAGE SW884 89083DAEPT 89083DAEST 89083DAEPR 89083DAES

17、R CBM43W2M1F000-50-799-.2 CBM43W2F1F000-50-799.2 CBM43W2M10000-50-799.0 CBM43W2F10000-50-799.0 89083GAEPT 89083GAEST 89083GAEPR 89083GAESR CBM43W2M1F000-50-799-.2 CBM43W2F1F000-50-799.2 CBM43W2M10000-50-799.0 CBM43W2F10000-50-799.0 89083GBEPT 89083GBEST 89083GBEPR 89083GBESR DDMMY43W2PA101 DDMMY43W2

18、SA101 DDMM43W2PA101 DDMM43W2SA101 89083GBEPT 89083GBEST 89083GBEPR 89083GBESR CBM43W2M02F00C-0 CBM43W2F02F00C-0 CBM43W2M02000C-0 CBM43W2F02000C-0 PDMMHW43W2P PDMMHW43W2S PDMMW43W2P PDMMW43W2S 89083NAEPT 89083NAEST 89083NAEPR 89083NAESR CBC43W2M1F00C-50-403.0 CBC43W2F1F00C-50-403.0 CBC43W2M1000C-50-4

19、03.0 CBC43W2F1000C-50-403.0 89083MAEPT 89083MAEST 89083MAEPR 89083MAESR CBC43W2M1F000-50-403.4 CBC43W2F1F000-50-403.4 CBC43W2M10000-50-403.3 CBC43W2F10000-50-403.3 1/ Caution. Do not use this number for item acquisition. Items acquired to this number may not satisfy the performance requirements of t

20、his drawing. 2/ Connectors supplied to this drawing shall include a full complement of signal contacts. 3/ Size 8 contacts should be ordered separately. 4/ Size 8 contacts are snap-in and removable. 5/ For size 8 contacts, see DSCC drawings 89046 through 89061. 037Z3 89083 DEFENSE SUPPLY CENTER, COL

21、UMBUS COLUMBUS, OH 43218-3990 A REVD PAGE5 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-SIZE CAGE CODE DWG NO. Vender CAGE Vendor name number and address 28198 Positronics Industries, Incorporated 423 North Campbell Springfield, MO 65801-8247 6056

22、3 The Phoenix Company 555 Pond Drive Wood Dale, IL 60191-1192 71468 ITT Cannon P.O. Box 929 666 East Dyer Road Santa Ana, CA 92702-0929 SW884 The Phoenix Company of Chicago, Mexico Carretera Internacional K M 1969 Guadalajara Nogales KM 2 Empalme, Mexico 85340 037Z3 89083 DEFENSE SUPPLY CENTER, COLUMBUS COLUMBUS, OH 43218-3990 A REVD PAGE6 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-