DLA A-A-55492 D-2011 FUSE CARTRIDGE SEMICONDUCTOR TYPE 130 VOLTS.pdf

《DLA A-A-55492 D-2011 FUSE CARTRIDGE SEMICONDUCTOR TYPE 130 VOLTS.pdf》由会员分享，可在线阅读，更多相关《DLA A-A-55492 D-2011 FUSE CARTRIDGE SEMICONDUCTOR TYPE 130 VOLTS.pdf（7页珍藏版）》请在麦多课文档分享上搜索。

1、 Beneficial comments, recommendations, additions, deletions, clarifications, etc., and any data that may improve this document should be sent to: DLA Land and Maritime, ATTN: DLA Land and Maritime-VAT, P.O. Box 3990, Columbus, OH 43218-3990, or email mailto:CircuitProtectdscc.dla.mil. Since contact

2、information can change you may want to verify the currency of the address information using the ASSIST Online database at https:/assist.daps.dla.mil. AMSC N/A FSC 5920 INCH-POUND A-A-55492D 17 February 2011 SUPERSEDING A-A-55492C 6 July 2006 COMMERCIAL ITEM DESCRIPTION FUSE CARTRIDGE, SEMICONDUCTOR

3、TYPE, 130 VOLTS The General Services Administration has authorized the use of this commercial item description for all federal agencies. 1. SCOPE. This commercial item description (CID) covers the general requirements for 130 volt semiconductor type fuse cartridges. Fuse cartridges covered by this C

4、ID are intended for commercial/industrial applications. 2. CLASSIFICATION/PART OR IDENTIFICATION NUMBER (PIN). This CID uses a classification system which is included in the PIN as shown in the following example (see 7.1). AA55492 - 001 CID PIN Dash number (see table I) 3. SALIENT CHARACTERISTICS. 3

5、.1 Interface and physical dimensions. Fuse cartridges supplied to this CID shall be as specified herein (see figure 1 and figure 2). 3.2. Ampere rating. The ampere rating shall be as specified in table I. 3.3 Voltage rating. The voltage rating shall be 130 V ac maximum. 3.4 Short circuit interrupt r

6、ating. The short circuit interrupt shall be 100,000 amperes root mean square (RMS) symmetrical. 3.5 Maximum current clearing I2t. The maximum current clearing I2t shall be as specified in table I. 3.6 Marking. Fuse cartridges supplied to this CID shall be marked with the manufacturers (MFRs) standar

7、d commercial PIN. (NOTE: the part number marked on the unit pack shall be the CID PIN.) Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-A-A-55492D 2 AA55492- Dimensions A B C 001 through 006 1.500 (38.10) .406 (10.31) .374 (9.50) 007 through 011 2.00

8、0 (50.80) .811 (20.60) .631 (16.03) .495 (12.57) Configuration A NOTES: 1. Dimensions are in inches. 2. Unless otherwise specified, tolerance is .005 inch (0.13 mm). FIGURE 1. Configuration A and dimensions. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IH

9、S-,-,-A-A-55492D 3 AA55492- Dimensions A B C D E F G H 012 through 021 1.157 (29.38) 1.890 (48.01) 2.194 (55.73) 2.151 (54.64)2.657 (67.48)1.130 (28.70).995 (25.27).880 (22.35).745 (18.92).332 (8.43) .306 (7.77) .188 (4.78) Configuration B NOTES: 1. Dimensions are in inches. 2. Unless otherwise spec

10、ified, tolerance is .005 inch (0.13 mm). FIGURE 2. Configuration B and dimensions. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-A-A-55492D 4 TABLE I. Electrical characteristics. AA55492- Ampere rating I2t (A2s) AA55492- Ampere rating I2t (A2s) 001

11、 5 7 012 70 19,000 002 10 12 013 80 30,000 003 15 37 014 100 41,000 004 20 95 015 125 55,000 005 25 170 016 150 63,000 006 30 300 017 200 80,000 007 35 400 018 250 110,000 008 40 600 019 300 190,000 009 45 800 020 350 280,000 010 50 1,100 021 400 325,000 011 60 1,500 3.7 Recycled, recovered, or envi

12、ronmentally preferable materials. Recycled, recovered, or environmentally preferable materials should be used to the maximum extent possible provided that the material meets or exceeds the operational and maintenance requirements, and promotes economically advantageous life cycle costs. 3.8 Workmans

13、hip. Fuse cartridges shall be processed in such a manner as to be uniform in quality and shall be free from other defects that will affect life, serviceability, or appearance. 4. REGULATORY REQUIREMENTS. The offeror/contractor is encouraged to use recovered materials to the maximum extent practicabl

14、e, in accordance with 23.403 of the Federal Acquisition Regulation (FAR). 5. PRODUCT CONFORMANCE PROVISIONS. 5.1 Product conformance. The products provided shall meet the salient characteristics of this CID, conform to the producers own drawings, specifications, standards, and quality assurance prac

15、tices, and be the same product offered for sale in the commercial market. The Government reserves the right to require proof of such conformance. 5.2 Market acceptance. The following market acceptance criteria are necessary to document the quality of the product to be provided under this CID: a. The

16、 company producing the item must have been producing a product meeting the requirements of this CID for at least 2 years. b. The company producing the item must have sold 1,000 units meeting this CID in the commercial marketplace over the past 2 years. 6. PACKAGING. Preservation, packing, and markin

17、g shall be as specified in the contract or order. 7. NOTES. 7.1 PIN. The PIN should be used for Government purposes to buy commercial products to this CID. See the classification section for PIN format example. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from

18、 IHS-,-,-A-A-55492D 5 7.2 Environmentally preferable material. Environmentally preferable materials should be used to the maximum extent possible to meet the requirements of this specification. As of the dating of this document, the U.S. Environmentally Protection Agency (EPA) is focusing efforts on

19、 reducing 31 priority chemicals. The list of chemicals is available on their website at http:/www.epa.gov/osw/hazard/wastemin/priority.htm. Use of these materials on the list should be minimized or eliminated unless needed to meet the requirements specified herein (see Section 3). 7.3 Commercial and

20、 Government Entity (CAGE) code. For ordering purposes, inventory control, and submission of these fuse cartridges to DLA Land and Maritime under the Military Parts control Advisory Group (MPCAG) evaluation program, CAGE code 58536 should be used. 7.4 Source of documents. FEDERAL REGULATIONS FAR - Fe

21、deral Acquisition Regulations (FAR). (Copies of this document are available online at https:/www.acquisition.gov/comp/far/index.html or from the U.S. Government Printing Office, 732 North Capital Street, NW, Washington D.C. 20401-0001.) 7.5 Ordering data. The contract or order should specify the fol

22、lowing: a. CID document number, revision, and CID PIN. b. Product conformance provisions. c. Packaging requirements. 7.6 Commercial products. As part of the market analysis and research effort, this CID was coordinated with the following manufacturers of commercial products. At the time of CID prepa

23、ration and coordination, these manufacturers were known to have commercial products that would meet the requirements of this CID. (NOTE: This information should not be considered as a list of approved manufacturers or be used to restrict procurement to only the manufacturers shown.) MFRs CAGE MFRs n

24、ame and address 067U2 DENCO Fuses, Incorporated 8244 S.W. 103 Avenue Miami, FL 33173-3906 Phone number: (305) 273-6226 Facsimile number: (305) 273-4335 E-mail: mailto: Uniform Resource Locator (URL): http:/ 71424 Ferraz Shawmut 374 Merrimac Street Newburyport, MA 01950-1930 Phone number: 978-462-666

25、2 Facsimile number: 978-462-0181 E-mail: mailto: URL: http:/ Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-A-A-55492D 6 7.7 Part number (P/N) supersession data. These CID PINs supersede the following MFRs P/Ns as shown. This information is being pr

26、ovided to assist in reducing proliferation in the Government inventory system. TABLE III. P/N supersession data. CID dash number (see table I) Vendor commercial P/N 1/ CID dash number(see table I) Vendor commercial P/N 1/ AA55492- CAGE 067U2 CAGE 71424 AA55492- CAGE 067U2 CAGE 71424 001 UFR13X005 A1

27、3X5-2 012 UFR13X070 A13X70-4 002 UFR13X010 A13X10-2 013 UFR13X080 A13X80-4 003 UFR13X015 A13X15-2 014 UFR13X100 A13X100-4 004 UFR13X020 A13X20-2 015 UFR13X125 N/A 005 UFR13X025 A13X25-2 016 UFR13X150 A13X150-4 006 UFR13X030 A13X30-2 017 UFR13X200 A13X200-4 007 UFR13X035 A13X35-1 018 UFR13X250 A13X25

28、0-4 008 UFR13X040 A13X40-1 019 UFR13X300 A13X300-4 009 UFR13X045 A13X45-1 020 UFR13X350 A13X350-4 010 UFR13X050 A13X50-1 021 UFR13X400 A13X400-4 011 UFR13X060 A13X60-1 1/ The manufacturers P/N shall not be used for procurement to the requirements of this CID. At the time of preparation of this CID,

29、the aforementioned commercial products were reviewed and could be replaced by the CID PIN shown. For actual part marking requirements, see 3.6. 7.8 Government users. To acquire information on obtaining these fuse cartridges from the Government inventory system, contact DLA Land and Maritime, ATTN: L

30、and and Maritime-FMX, P.O. Box 3990, Columbus, OH 43218-3990, or telephone (614) 692-3677. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-A-A-55492D 7 7.8.1 National stock number (NSN). The following is a list of NSNs assigned which correspond to th

31、is CID. The list is for information only and may not be indicative of all possible NSNs associated with the CID. For up to date information on assigned NSNs, please contact the aforementioned DLA Land and Maritime office (See 7.8). TABLE IV. NSNs. Dash number (see table I) AA55492- NSN Dash number (

32、see table I) AA55492- NSN 001 N/A 012 N/A 002 N/A 013 5920-00-778-3882 003 N/A 014 5920-00-828-0148 004 N/A 015 5920-01-194-1192 005 N/A 016 5920-00-713-4242 006 N/A 017 5920-00-881-2895 007 N/A 018 5920-00-823-0071 008 5920-00-879-8161 019 N/A 009 N/A 020 5920-01-172-5748 010 5920-00-998-2231 021 5

33、920-00-767-9044 011 N/A 7.9 Changes from previous issue. Marginal notations are not used in this revision to identify changes with respect to the previous issue due to the extensiveness of the changes. MILITARY INTERESTS: CIVIL AGENCY COORDINATING ACTIVITY: GSA - FAS Custodians: Navy - EC Preparing

34、activity: DLA - CC DLA-CC Project 5920-2011-026 NOTE: The activities listed above were interested in this document as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST Online database at https:/assist.daps.dla.mil. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-