ARMY MIL-G-51375 (1)-1987 GRENADE HAND RIOT CS M47《M47 CS防暴动手榴弹》.pdf

《ARMY MIL-G-51375 (1)-1987 GRENADE HAND RIOT CS M47《M47 CS防暴动手榴弹》.pdf》由会员分享，可在线阅读，更多相关《ARMY MIL-G-51375 (1)-1987 GRENADE HAND RIOT CS M47《M47 CS防暴动手榴弹》.pdf（2页珍藏版）》请在麦多课文档分享上搜索。

1、MIL-G-51375 (1) 13 W 7977906 0333996 2 i! 5-37-07 MIL-G-51375 (EA) AMENDMENT 1 3 April 1987 I MILITARY SPECIFICATION GRENADE, HAND: RIOT, CS, M47 This amenciment forins a part of MITJ-G-51375(EA) , dated . 15 November 1974, and is approved for use within the Chemical Research, Development and Engine

2、ering Center , Department of the Army and is available for use by all Departments and Agencies of the Desartment of Defense. PAGE 1 2.1: Under “SPECIFICATIONS“ “FEDERAL“ : Delete “QQ-S-781 - Strapping, Steel, Flat and Seals.“ Delete “TT-W-572 - Wood Preservative, Water Repellent.“ Under “SPECIFICATI

3、ONS“ “MILITARY If : Delete “MIL-B-2427 - Boxes , Ammunition Packing; Wood , Nailed.“ Add “MIL-B-46506 - Boxes, Amunition Paclring Wood , 17irebound.“ PAGE 6 Change “Preparation for delivery (Section 5) .I1 to “Packaging (section 5) .I Add to the list of defects “i08 Strapping missing or incorrect“ 4

4、.4.4.2, line 5: Delete “the grenade . . . hard level“ and substitute the tape over the grenade emission port shall be removed, the grenade armed and thrown tit least 50 feet onto a hard level“. AMSC N/A FSC i330 . DISTRIBUTION STATEMENT A. Approved 0.r public release; distribution is unlimited. Page

5、 1 of 2 I Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-G-51375 (1) 13 I 9797706 0333777 LI I MILG-51375 (EA) MNDMENT 1 PAGE 5 5: Delete PREPARATION FOR DELIVERY“ and substitute “PACKAGING“. 5.1, line 1: Delete “Packaging, level A.“ and substit

6、ute “Preservation, level A.“ 5.2: Line 2: After “box“ add I, Grade A,“. Lines 5-9: Delete “Prior to loading, . . . in MIL-B-2427.“ Lines 11-13: Delete the last two sentences in their entirety and substi- tute “The PPP-B-O and PPP-B-621 boxes shall be closed and strapped in accm- dance with the appen

7、dix of the applicable box specification. The 1411,-B-46506 boxes shall be strapped using 5/8 by 0.020 inch strapping, class 1, type I, finish A or finish B, grade 2; and seals type D, style I or IV, class R, finish B, grade 2 conforming -to QQ-S-781. Straps shall be applied straight, at right- angle

8、s to the edges of the box, and under sufficient tension to firmly grip the edges of the face board naterial. Strapping shall be applied before the wires at the closing edges of the box are twisted or looped Straps shall be placed as near as practicable, but not more than 3 inches fron each end edge

9、of the box. I PAGE 8 Add new paragraph 6.7 as follows: “6.7 International interest. Certain provisions of this specification are . the subject of international standardization agreement ABCA - Army Quadripar- tite Standardization Agreement - 319. When amendment, revision, or cancella- tion of this s

10、pecification is proposed which will modify the international ttGreement concerned, the preparing activity will take appropriate action through international standardization channels including departmental stan- dardization offices to change the %reement or make other appropriate accorn- moclat ions .If Custodian: Army - El Preparing activity: Army - EA Project No. 1330-A306 2 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-