ASTM F2212-2002(2007)e1 Standard Guide for Characterization of Type I Collagen as Starting Material for Surgical Implants and Substrates for Tissue Engineered Medical Products (TEM.pdf
《ASTM F2212-2002(2007)e1 Standard Guide for Characterization of Type I Collagen as Starting Material for Surgical Implants and Substrates for Tissue Engineered Medical Products (TEM.pdf》由会员分享,可在线阅读,更多相关《ASTM F2212-2002(2007)e1 Standard Guide for Characterization of Type I Collagen as Starting Material for Surgical Implants and Substrates for Tissue Engineered Medical Products (TEM.pdf(10页珍藏版)》请在麦多课文档分享上搜索。
1、Designation: F 2212 02 (Reapproved 2007)e1Standard Guide forCharacterization of Type I Collagen as Starting Material forSurgical Implants and Substrates for Tissue-EngineeredMedical Products (TEMPs)1This standard is issued under the fixed designation F 2212; the number immediately following the desi
2、gnation indicates the year oforiginal adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. Asuperscript epsilon (e) indicates an editorial change since the last revision or reapproval.e1NOTEFormatting and grammar were correct
3、ed editorially throughout in April 2007.INTRODUCTIONCollagen-based medical devices are becoming more prevalent, especially in the area of soft tissueaugmentation. The use of collagen in surgery dates back to the late 1800s, with the use of catgutsutures, human cadaveric skin, and fascia. More recent
4、ly, collagen has been used in hemostaticsponges, dermal equivalents, injectables for soft tissue augmentation, as a matrix for cell-basedproducts and as a vehicle for drug delivery. It is because of the versatility of collagen in medicalapplications that specific characterizations should be performe
5、d as a way to compare materials.1. Scope1.1 This guide for characterizing collagen-containing bio-materials is intended to provide characteristics, properties, andtest methods for use by producers, manufacturers, and re-searchers to more clearly identify the specific collagen mate-rials used. With g
6、reater than 20 types of collagen and thedifferent properties of each, a single document would becumbersome. This guide will focus on the characterization ofType I collagen, which is the most abundant collagen inmammals, especially in skin and bone. Collagen isolated fromthese sources may contain oth
7、er types of collagen, for example,Type III and Type V. This guide does not provide specificparameters for any collagen product or mix of products or theacceptability of those products for the intended use. Thecollagen may be from any source, including, but not limited to,animal or cadaveric sources,
8、 human cell culture, or recombi-nant sources. The biological, immunological, or toxicologicalproperties of the collagen may vary, depending on the sourcematerial. The properties of the collagen prepared from each ofthe above sources must be thoroughly investigated, as thechanges in the collagen prop
9、erties as a function of sourcematerials is not thoroughly understood. This guide is intendedto focus on purified Type I collagen as a starting material forsurgical implants and substrates for Tissue-Engineered MedicalProducts (TEMPs); some methods may not be applicable forgelatin nor for tissue impl
10、ants. This guide may serve as atemplate for characterization of other types of collagen.1.2 The biological response to collagen in soft tissue hasbeen well documented by a history of clinical use (1, 2)2andlaboratory studies (3, 4, 5, 21). Biocompatibility and appropri-ateness of use for a specific
11、application(s) is the responsibilityof the device manufacturer.1.3 The following precautionary caveat pertains only to thetest method portion, Section 5, of this guide. This standarddoes not purport to address all of the safety concerns, if any,associated with its use. It is the responsibility of th
12、e user of thisstandard to establish appropriate safety and health practicesand determine the applicability of regulatory requirementsprior to use.2. Referenced Documents2.1 ASTM Standards:3E 1298 Guide for Determination of Purity, Impurities, andContaminants in Biological Drug ProductsF 619 Practice
13、 for Extraction of Medical PlasticsF 720 Practice for Testing Guinea Pigs for Contact Aller-gens: Guinea Pig Maximization Test1This guide is under the jurisdiction of ASTM Committee F04 on Medical andSurgical Materials and Devices and is the direct responsibility of SubcommitteeF04.42 on Biomaterial
14、s and Biomolecules for TEMPs.Current edition approved Feb. 1, 2007. Published February 2007. Originallyapproved in 2002. Last previous edition approved in 2002 as F 2212 02.2The boldface numbers in parentheses refer to the list of references at the end ofthis standard.3For referenced ASTM standards,
15、 visit the ASTM website, www.astm.org, orcontact ASTM Customer Service at serviceastm.org. For Annual Book of ASTMStandards volume information, refer to the standards Document Summary page onthe ASTM website.1Copyright ASTM International, 100 Barr Harbor Drive, PO Box C700, West Conshohocken, PA 194
16、28-2959, United States.F 748 Practice for Selecting Generic Biological Test Meth-ods for Materials and DevicesF 749 Practice for Evaluating Material Extracts by Intracu-taneous Injection in the RabbitF 756 Practice for Assessment of Hemolytic Properties ofMaterialsF 763 Practice for Short-Term Scree
17、ning of Implant Mate-rialsF 813 Practice for Direct Contact Cell Culture Evaluation ofMaterials for Medical DevicesF 895 Test Method for Agar Diffusion Cell Culture Screen-ing for CytotoxicityF 981 Practice for Assessment of Compatibility of Bioma-terials for Surgical Implants with Respect to Effect
18、 ofMaterials on Muscle and BoneF 1251 Terminology Relating to Polymeric Biomaterials inMedical and Surgical DevicesF 1439 Guide for Performance of Lifetime Bioassay for theTumorigenic Potential of Implant MaterialsF 1903 Practice for Testing For Biological Responses toParticles in vitroF 1904 Practi
19、ce for Testing the Biological Responses toParticles in vivoF 1905 Practice For Selecting Tests for Determining thePropensity of Materials to Cause ImmunotoxicityF 1906 Practice for Evaluation of Immune Responses InBiocompatibility Testing Using ELISA Tests, LymphocyteProliferation, and Cell Migratio
20、nF 1983 Practice for Assessment of Compatibility ofAbsorbable/Resorbable Biomaterials for Implant Applica-tionsF 2148 Practice for Evaluation of Delayed Contact Hyper-sensitivity Using the Murine Local Lymph Node Assay(LLNA)2.2 ISO Standards:4ISO 10993-1 Biological Evaluation of Medical DevicesPart
21、1: Evaluation and TestingISO 10993-3Part 3 Tests for Genotoxicity, Carcinogenic-ity and Reproductive ToxicityISO 10993-9Part 9 Framework for Identification andQuantification of Potential Degradation ProductsISO 10993-10 Biological Evaluation of Medical DevicesPart 10: Tests for Irritation and Delaye
22、d-Type Hypersen-sitivityISO 10993-17Part 17 Methods for Establishment of Al-lowable Limits for Leachable Substances Using Health-Based Risk AssessmentISO 13408-1: 1998 Aseptic Processing of Health CareProductsPart 1: General Requirements2.3 EN (European Norm) Documents:5EN 12442-1 Animal Tissues and
23、 their Derivatives Utilizedin the Manufacture of Medical DevicesPart 1: Analysisand Management of RiskEN 12442-2Part 2 Controls on Sourcing, Collection andHandlingEN 12442-3Part 3 Validation of the Elimination and/orInactivation of Virus and Transmissible Agents2.4 U. S. Pharmacopeia Documents:6Unit
24、ed States Pharmacopeia (USP), Edition XXIV (24)USP 24/NF 19 Viral Safety Evaluation of BiotechnologyProducts Derived from Cell Lines of Human or AnimalOrigin2.5 Code of Federal Regulations:7Code of Federal Regulations, Title 21, Part 820Federal Register Vol. 43, No. 141, Friday, July 21, 1978Human C
- 1.请仔细阅读文档,确保文档完整性,对于不预览、不比对内容而直接下载带来的问题本站不予受理。
- 2.下载的文档,不会出现我们的网址水印。
- 3、该文档所得收入(下载+内容+预览)归上传者、原创作者;如果您是本文档原作者,请点此认领!既往收益都归您。
下载文档到电脑,查找使用更方便
5000 积分 0人已下载
下载 | 加入VIP,交流精品资源 |
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- ASTMF221220022007E1STANDARDGUIDEFORCHARACTERIZATIONOFTYPEICOLLAGENASSTARTINGMATERIALFORSURGICALIMPLANTSANDSUBSTRATESFORTISSUEENGINEEREDMEDICALPRODUCTSTEMPDF

链接地址:http://www.mydoc123.com/p-538062.html