ASTM D5219-2009e1 Standard Terminology Relating to Body Dimensions for Apparel Sizing《有关服装度量用人体尺寸的标准术语》.pdf
《ASTM D5219-2009e1 Standard Terminology Relating to Body Dimensions for Apparel Sizing《有关服装度量用人体尺寸的标准术语》.pdf》由会员分享,可在线阅读,更多相关《ASTM D5219-2009e1 Standard Terminology Relating to Body Dimensions for Apparel Sizing《有关服装度量用人体尺寸的标准术语》.pdf(13页珍藏版)》请在麦多课文档分享上搜索。
1、Designation: D5219 091Standard Terminology Relating toBody Dimensions for Apparel Sizing1This standard is issued under the fixed designation D5219; the number immediately following the designation indicates the year oforiginal adoption or, in the case of revision, the year of last revision. A number
2、 in parentheses indicates the year of last reapproval. Asuperscript epsilon () indicates an editorial change since the last revision or reapproval.1NOTEEditorial corrections were made to some of the Figure references in August 2014.1. Scope1.1 This standard is a compilation of terminology related to
3、the body dimensions for necessary apparel sizing.1.2 For definitions of other textile terms, refer to Terminol-ogy D123.1.3 The terms are listed in alphabetical order regardless ofwhether they are horizontal or vertical measurements. Thethree dimensional Avatars were created by Alvanon Inc. SeeFigs.
4、 1-18.2. Referenced Documents2.1 ASTM Standards:2D123 Terminology Relating to Textiles2.2 ISO Standards:3ISO 3635 Size Designation of Clothes, Definitions and BodyMeasurement ProceduresISO 8559 Garment Construction and AnthropometricSurveysBody Dimensions3. Terminology3.1 Anatomy:acromion, nthat par
5、t of the shoulder blade located at the endof the spine, which articulates with the collarbone. (See alsoshoulder joint.) (See Fig. 2.)ankle, nthe joint between the foot and the lower leg. (SeeFig. 1.)apex, nthe greatest protrusion of the breast as seen from theside.armpit, nthe hollow under the junc
6、tion of the arm and theshoulder. (See Fig. 1.)back-break point, nthe location on the back of the torsowhere the arm separates from the body (See Fig. 2.)cervicale, nthe prominent point of the seventh or lowestneck vertebra at the back of the torso.DISCUSSIONThe cervicale is identified by being more
7、prominentwhen the head is bent forward; however, cervicale height measure-ments are made only when the head is erect. (See Fig. 2.)crotch, nthe lowest point of the torso where the legsseparate. (See Fig. 1.)crown, nthe top of the head. (See Fig. 1.)elbow, nthe joint that articulates between the uppe
8、r arm andthe lower arm. (See Fig. 1.)front-break point, nthe location on the front of the torsowhere the arm separates from the torso. (See Fig. 1.)hip, nthe laterally projecting region formed by the lateralparts of the pelvis and the upper part of the femur togetherwith the flesh covering them. (Se
9、e Fig. 1.)knee, nthe joint between the lower and upper leg. (See Fig.1.)shoulder joint, nthe juncture of the collarbone and theshoulder blade.DISCUSSIONThe outer end of the collarbone or clavicle pivotsagainst the acromion which in turn pivots against the humerus or upperarm bone in the arm. These b
10、ones form the shoulder girdle. (See alsoacromion.) (See Fig. 2.)waist, nthe part of the torso at the location between thelowest rib and hip identified by bending the torso to the side.(See Fig. 1.)wrist, nthe joint that articulates between the end of the lowerarm and the hand. (See Fig. 1.)3.2 Anthr
11、opometry:body measurements, na standardized distance between twospecified points on the human anatomy.DISCUSSIONBody measurements generally are based on standard-ized values from statistical studies of large populations.1This terminology is under the jurisdiction ofASTM Committee D13 on Textilesand
12、is the direct responsibility of Subcommittee D13.55 on Body Measurement forApparel Sizing.Current edition approved Jan. 15, 2009. Published March 2009. Originallyapproved in 1992. Last previous edition approved in 2007 as D5219 07a. DOI:10.1520/D5219-09E01.2For referenced ASTM standards, visit the A
13、STM website, www.astm.org, orcontact ASTM Customer Service at serviceastm.org. For Annual Book of ASTMStandards volume information, refer to the standards Document Summary page onthe ASTM website.3Available from American National Standards Institute (ANSI), 25 W. 43rd St.,4th Floor, New York, NY 100
14、36.Copyright ASTM International, 100 Barr Harbor Drive, PO Box C700, West Conshohocken, PA 19428-2959. United States13.3 Body Measurements:across back shoulder width, nthe horizontal distance acrossthe back from the top of one shoulder joint to the top of theother shoulder joint, taken with the arms
15、 down. (See Fig.10.)across front shoulder width, nthe horizontal distance acrossthe front from the top of one shoulder joint to the top of theother shoulder joint, taken with the arms down. (See Fig.11.)FIG. 1 Body MeasurementsFIG. 2 Upper Back MeasurementsD5219 0912ankle girth, nthe maximum horizon
16、tal circumference of theankle, taken over the greatest prominence of the anklebones.(See Fig. 3.)ankle height, nthe vertical distance from the prominence ofthe outer ankle bone to the floor, taken with subject standingand without shoes. (See Fig. 6.)ankle height (infant special case), n the straight
17、 distancefrom the prominence of the outer ankle bone to the soles of thefeet, taken with subject lying down flat with legs extended andthe foot positioned at 1.57 rad (90) to the leg.arm length, nthe distance from the top of the shoulder jointalong the outside of the arm over the elbow to the promin
18、entFIG. 3 Body MeasurementsD5219 0913wrist bone, taken with the arm bent (1.57 rad or 90) and thehand placed on the hip. (See Fig. 11.)armscye girth, nthe circumference taken from the shoulderjoint through the front break-point, the armpit, the backbreak-point and to the starting point, taken with t
19、he armsdown. (See Fig. 3.)back width, nthe horizontal distance across the back fromback break-point to back break-point over the shoulderblades, taken with the arms down. (See Fig. 10.)body weight, nthe weight as measured on a calibrated scaletaken with the subject in undergarments.bust point to bus
20、t point (halter), n the horizontal distancefrom bust apex around the back of the neck to bust apex,taken with the arms down. (See Fig. 9.)bust point to bust point, nthe horizontal distance from bustapex to bust apex, taken with the arms down. (See Fig. 9.)calf girth, nthe maximum horizontal circumfe
21、rence of thelower leg, taken between the knee and the ankle. (See Fig.3.)center back waist length, nthe distance from the cervicaleto the center back waist level, taken along the spine(contour). (See Fig. 8.)FIG. 4 Upper Body MeaurementsD5219 0914center front waist length, nthe distance from the cen
22、terfront neck base line to the center front waist level (contour).(See Fig. 7.)cervicale height, nthe vertical distance from the cervicale tothe floor, taken with subject standing and without shoes. (SeeFig. 6.)cervicale height (infant special case), nthe straight dis-tance from the cervicale to the
23、 soles of the feet, taken withsubject lying down flat with legs extended and foot positionedat 1.57 rad (90) to the leg.cervicale to knee height, nthe vertical distance from thecervicale to a point level with the midpoint of the back of theknee (or crease). (See Fig. 6.)cervicale to knee height (inf
24、ant special case), nthe straightdistance from the cervicale to a point level with the midpointof the back of the knee (or crease), taken with subject lyingdown flat with legs extended.cervicale to wrist length, nthe distance from the cervicaleover the top of the shoulder joint, along the outside of
- 1.请仔细阅读文档,确保文档完整性,对于不预览、不比对内容而直接下载带来的问题本站不予受理。
- 2.下载的文档,不会出现我们的网址水印。
- 3、该文档所得收入(下载+内容+预览)归上传者、原创作者;如果您是本文档原作者,请点此认领!既往收益都归您。
下载文档到电脑,查找使用更方便
10000 积分 0人已下载
下载 | 加入VIP,交流精品资源 |
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- ASTMD52192009E1STANDARDTERMINOLOGYRELATINGTOBODYDIMENSIONSFORAPPARELSIZING 有关 服装 度量 用人 尺寸 标准 术语 PDF

链接地址:http://www.mydoc123.com/p-519185.html