IEEE C37.100.5-2018 Definitions of High-Voltage Circuit Breakers Above 1000 Vac and 3200 Vdc, and Reclosers and Other Distribution Equipment from 1000 Vac to 38 000 Vac.pdf

《IEEE C37.100.5-2018 Definitions of High-Voltage Circuit Breakers Above 1000 Vac and 3200 Vdc, and Reclosers and Other Distribution Equipment from 1000 Vac to 38 000 Vac.pdf》由会员分享，可在线阅读，更多相关《IEEE C37.100.5-2018 Definitions of High-Voltage Circuit Breakers Above 1000 Vac and 3200 Vdc, and Reclosers and Other Distribution Equipment from 1000 Vac to 38 000 Vac.pdf（28页珍藏版）》请在麦多课文档分享上搜索。

1、IEEE Standard for Definitions of High-Voltage Circuit Breakers Above 1000 Vac and 3200 Vdc, and Reclosers and Other Distribution Equipment from 1000 Vac to 38 000 Vac IEEE Std C37.100.5-2018 IEEE Power and Energy Society Sponsored by the Switchgear Committee IEEE 3 Park Avenue New York, NY 10016-599

2、7 USAIEEE Std C37.100.5-2018 IEEE Standard for Definitions of High-Voltage Circuit Breakers Above 1000 Vac and 3200 Vdc, and Reclosers and Other Distribution Equipment from 1000 Vac to 38 000 Vac Sponsor Switchgear Committee of the IEEE Power and Energy Society Approved 15 February 2018 IEEE-SA Stan

3、dards Board Abstract: The terms and definitions in the standard are intended to encompass the products within the scope of the IEEE C37 series of power switchgear standards for high-voltage circuit breakers (above 1000 Vac and 3200 Vdc) and for reclosers and other distribution equipment (above 1000

4、Vac to 38,000 Vac) as used primarily in connection with generation, transmission, distribution, and conversion of electric power. The definitions of terms and explanatory notes relating thereto contained in this standard are not intended to embrace all possible meanings of the terms. They are intend

5、ed for the sole purpose of establishing only those meanings of terms used in switchgear standards. They do not purport to embrace other meanings that the terms may properly have when used in connection with other subjects. In some instances, terms and definitions that are not identical to those in t

6、his standard have been developed by other branches of industry. Where this situation exists, the definitions in this standard shall be used for power switchgear within the IEEE C37 series of standards. Keywords: capacitor switch, circuit breaker, definitions, fault interrupter, IEEE C37.100.5, pad-

7、mounted switchgear, recloser, sectionalizer, submersible switchgear, switchgear The Institute of Electrical and Electronics Engineers, Inc. 3 Park Avenue, New York, NY 10016-5997, USA Copyright 2018 by The Institute of Electrical and Electronics Engineers, Inc. All rights reserved. Published 6 April

8、 2018. Printed in the United States of America. IEEE is a registered trademark in the U.S. Patent fitness for a particular purpose; non-infringement; and quality, accuracy, effectiveness, currency, or completeness of material. In addition, IEEE disclaims any and all conditions relating to: results;

9、and workmanlike effort. IEEE standards documents are supplied “AS IS” and “WITH ALL FAULTS.” Use of an IEEE standard is wholly voluntary. The existence of an IEEE standard does not imply that there are no other ways to produce, test, measure, purchase, market, or provide other goods and services rel

10、ated to the scope of the IEEE standard. Furthermore, the viewpoint expressed at the time a standard is approved and issued is subject to change brought about through developments in the state of the art and comments received from users of the standard. In publishing and making its standards availabl

11、e, IEEE is not suggesting or rendering professional or other services for, or on behalf of, any person or entity nor is IEEE undertaking to perform any duty owed by any other person or entity to another. Any person utilizing any IEEE Standards document, should rely upon his or her own independent ju

12、dgment in the exercise of reasonable care in any given circumstances or, as appropriate, seek the advice of a competent professional in determining the appropriateness of a given IEEE standard. IN NO EVENT SHALL IEEE BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIA

13、L DAMAGES (INCLUDING, BUT NOT LIMITED TO: PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF

14、THE PUBLICATION, USE OF, OR RELIANCE UPON ANY STANDARD, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE AND REGARDLESS OF WHETHER SUCH DAMAGE WAS FORESEEABLE. Translations The IEEE consensus development process involves the review of documents in English only. In the event that an IEEE standard is

15、 translated, only the English version published by IEEE should be considered the approved IEEE standard. IEEE Std C37.100.5-2018 IEEE Standard for Definitions of High-Voltage Circuit Breakers Above 1000 Vac and 3200 Vdc, and Reclosers and Other Distribution Equipment from 1000 Vac to 38 000 Vac 4 Co

16、pyright 2018 IEEE. All rights reserved. Official statements A statement, written or oral, that is not processed in accordance with the IEEE-SA Standards Board Operations Manual shall not be considered or inferred to be the official position of IEEE or any of its committees and shall not be considere

17、d to be, or be relied upon as, a formal position of IEEE. At lectures, symposia, seminars, or educational courses, an individual presenting information on IEEE standards shall make it clear that his or her views should be considered the personal views of that individual rather than the formal positi

18、on of IEEE. Comments on standards Comments for revision of IEEE Standards documents are welcome from any interested party, regardless of membership affiliation with IEEE. However, IEEE does not provide consulting information or advice pertaining to IEEE Standards documents. Suggestions for changes i

19、n documents should be in the form of a proposed change of text, together with appropriate supporting comments. Since IEEE standards represent a consensus of concerned interests, it is important that any responses to comments and questions also receive the concurrence of a balance of interests. For t

20、his reason, IEEE and the members of its societies and Standards Coordinating Committees are not able to provide an instant response to comments or questions except in those cases where the matter has previously been addressed. For the same reason, IEEE does not respond to interpretation requests. An

21、y person who would like to participate in revisions to an IEEE standard is welcome to join the relevant IEEE working group. Comments on standards should be submitted to the following address: Secretary, IEEE-SA Standards Board 445 Hoes Lane Piscataway, NJ 08854 USA Laws and regulations Users of IEEE

22、 Standards documents should consult all applicable laws and regulations. Compliance with the provisions of any IEEE Standards document does not imply compliance to any applicable regulatory requirements. Implementers of the standard are responsible for observing or referring to the applicable regula

23、tory requirements. IEEE does not, by the publication of its standards, intend to urge action that is not in compliance with applicable laws, and these documents may not be construed as doing so. Copyrights IEEE draft and approved standards are copyrighted by IEEE under U.S. and international copyrig

24、ht laws. They are made available by IEEE and are adopted for a wide variety of both public and private uses. These include both use, by reference, in laws and regulations, and use in private self-regulation, standardization, and the promotion of engineering practices and methods. By making these doc

25、uments available for use and adoption by public authorities and private users, IEEE does not waive any rights in copyright to the documents. Photocopies Subject to payment of the appropriate fee, IEEE will grant users a limited, non-exclusive license to photocopy portions of any individual standard

26、for company or organizational internal use or individual, non-commercial use only. To arrange for payment of licensing fees, please contact Copyright Clearance Center, Customer Service, 222 Rosewood Drive, Danvers, MA 01923 USA; +1 978 750 8400. Permission to photocopy portions of any individual sta

27、ndard for educational classroom use can also be obtained through the Copyright Clearance Center. IEEE Std C37.100.5-2018 IEEE Standard for Definitions of High-Voltage Circuit Breakers Above 1000 Vac and 3200 Vdc, and Reclosers and Other Distribution Equipment from 1000 Vac to 38 000 Vac 5 Copyright

28、2018 IEEE. All rights reserved. Updating of IEEE Standards documents Users of IEEE Standards documents should be aware that these documents may be superseded at any time by the issuance of new editions or may be amended from time to time through the issuance of amendments, corrigenda, or errata. A c

29、urrent IEEE document at any point in time consists of the current edition of the document together with any amendments, corrigenda, or errata then in effect. Every IEEE standard is subjected to review at least every ten years. When a document is more than ten years old and has not undergone a revisi

30、on process, it is reasonable to conclude that its contents, although still of some value, do not wholly reflect the present state of the art. Users are cautioned to check to determine that they have the latest edition of any IEEE standard. In order to determine whether a given document is the curren

31、t edition and whether it has been amended through the issuance of amendments, corrigenda, or errata, visit the IEEE-SA Website at http:/ieeexplore.ieee.org/xpl/standards.jsp or contact IEEE at the address listed previously. For more information about the IEEE-SA or IEEEs standards development proces

32、s, visit the IEEE-SA Website at http:/standards.ieee.org. Errata Errata, if any, for all IEEE standards can be accessed on the IEEE-SA Website at the following URL: http:/standards.ieee.org/findstds/errata/index.html. Users are encouraged to check this URL for errata periodically. Patents Attention

33、is called to the possibility that implementation of this standard may require use of subject matter covered by patent rights. By publication of this standard, no position is taken by the IEEE with respect to the existence or validity of any patent rights in connection therewith. If a patent holder o

34、r patent applicant has filed a statement of assurance via an Accepted Letter of Assurance, then the statement is listed on the IEEE-SA Website at http:/standards.ieee.org/about/sasb/patcom/patents.html. Letters of Assurance may indicate whether the Submitter is willing or unwilling to grant licenses

35、 under patent rights without compensation or under reasonable rates, with reasonable terms and conditions that are demonstrably free of any unfair discrimination to applicants desiring to obtain such licenses. Essential Patent Claims may exist for which a Letter of Assurance has not been received. T

36、he IEEE is not responsible for identifying Essential Patent Claims for which a license may be required, for conducting inquiries into the legal validity or scope of Patents Claims, or determining whether any licensing terms or conditions provided in connection with submission of a Letter of Assuranc

37、e, if any, or in any licensing agreements are reasonable or non-discriminatory. Users of this standard are expressly advised that determination of the validity of any patent rights, and the risk of infringement of such rights, is entirely their own responsibility. Further information may be obtained

38、 from the IEEE Standards Association. IEEE Std C37.100.5-2018 IEEE Standard for Definitions of High-Voltage Circuit Breakers Above 1000 Vac and 3200 Vdc, and Reclosers and Other Distribution Equipment from 1000 Vac to 38 000 Vac Copyright 2018 IEEE. All rights reserved. 6 Participants At the time th

39、is standard was completed, the Working Group had the following membership: Tom Mulcahy, Chair Chris Ambrose, Vice Chair Chih C. Chow Keith Flowers Todd Irwin Joe Jasinski Mike Skidmore Tony Ricciuti The following members of the individual balloting committee voted on this standard. Balloters may hav

40、e voted for approval, disapproval, or abstention. William Ackerman Roy Alexander Chris Ambrose Ficheux Arnaud Charles Ball Thomas Barnes W. J. (Bill) Bergman Steven Bezner Jean-Marc Biasse Wallace Binder Antone Bonner Anne Bosma Arben Bufi Rachel Bugaris William Byrd Eldridge Byron Thomas Callsen Pa

41、ul Cardinal Stephen Cary Chih C. Chow Robert Cohn Lucas Collette Stephen Conrad Stephen DeRoche Gary Donner Louis Doucet Denis Dufournet Douglas J. Edwards Donald Elliott Ronald Esco Sergio Flores Keith Flowers Paul Forquer Marcel Fortin Paul Found Dale Fredrickson Paul Gingrich Mietek Glinkowski Ro

42、bert Goodin Edwin Goodwin Lou Grahor Paul Grein Randall Groves Ajit Gwal Gary Haynes Victor Hermosillo Lee Herron Werner Hoelzl James Houston Todd Irwin Richard Jackson Jose Jarque Song Jin Travis Johnson Laszlo Kadar Yuri Khersonsky Boris Kogan Peter Kowalik Jim Kulchisky Marc Lacroix Chung-Yiu Lam

43、 John Leach Yuan Liao Hua Liu R. Long Frank Mayle John McClelland Jeffrey Mcelray Peter Meyer C. Michael Miller David Mitchell Daleep Mohla Charles Morse Darryl Moser Jerry Murphy Dennis Neitzel Arthur Neubauer Joe Nims T. W. Olsen Lorraine Padden Mirko Palazzo Shawn Patterson Branimir Petosic Jim P

44、hillips Iulian Profir Samala Santosh Reddy Carl Reigart Anthony Ricciuti Charles Rogers Thomas Rozek Ryandi Ryandi Bartien Sayogo Daniel Schiffbauer Ted Schoenberg Carl Schuetz Robert Seitz Nikunj Shah Harish Sharma John Shullaw Michael Skidmore Jerry Smith James Stage Wayne Stec Kyle Stechschulte Paul Sullivan Donald Swing David Tepen Wayne Timm Marcelo Valdes James Van De Ligt Roger Verdolin John Vergis Michael Wactor Mark Waldron William Walter John Wang John Webb Jan Weisker Steven Whalen Matthew Williford James Wilson Terry Woodyard Iain Wright Dean Yager Larry Yonce Jian Yu