IEEE 45.3-2015 - IEEE Recommended Practice for Shipboard Electrical Installations -- Systems Engineering.pdf

《IEEE 45.3-2015 - IEEE Recommended Practice for Shipboard Electrical Installations -- Systems Engineering.pdf》由会员分享，可在线阅读，更多相关《IEEE 45.3-2015 - IEEE Recommended Practice for Shipboard Electrical Installations -- Systems Engineering.pdf（74页珍藏版）》请在麦多课文档分享上搜索。

1、 IEEE Recommended Practice for Shipboard Electrical Installations Systems Engineering Sponsored by the Petroleum & Chemical Industry Committee IEEE 3 Park Avenue New York, NY 10016-5997 USA IEEE Industry Applications Society IEEE Std 45.3-2015 IEEE Std 45.3-2015 IEEE Recommended Practice for Shipboa

2、rd Electrical InstallationsSystems Engineering Sponsor Petroleum & Chemical Industry Committee of the IEEE Industry Applications Society Approved 11 June 2015 IEEE-SA Standards Board Recognized as an American National Standard Abstract: Recommendations for systems engineering, design, and integratio

3、n of electrical power systems at the total ship level from concept design through the establishment of the design baseline prior to detail design are provided in this document. Recommendations for ac power systems, dc power systems, emergency power systems, shore power, quality of service, power qua

4、lity and harmonics, electric propulsion and maneuvering systems, motors and drives, thrusters, and steering systems onboard ships are established by this document. These recommendations reflect the present-day technologies, engineering methods, and engineering practices. This document is intended to

5、 be used in conjunction with the IEEE 45 series of documents. Keywords: baselines, concept of operations, IEEE 45.3, radial design, systems engineering, zonal design The Institute of Electrical and Electronics Engineers, Inc. 3 Park Avenue, New York, NY 10016-5997, USA Copyright 2015 by The Institut

6、e of Electrical and Electronics Engineers, Inc. All rights reserved. Published 27 July 2015. Printed in the United States of America. IEEE is a registered trademark in the U.S. Patent & Trademark Office, owned by The Institute of Electrical and Electronics Engineers, Incorporated. National Electrica

7、l Code and NEC are both registered trademarks of the National Fire Protection Association. Inc. PDF: ISBN 978-0-7381-9724-1 STD20230 Print: ISBN 978-0-7381-9725-8 STDPD20230 IEEE prohibits discrimination, harassment, and bullying. For more information, visit http:/www.ieee.org/web/aboutus/whatis/pol

8、icies/p9-26.html. No part of this publication may be reproduced in any form, in an electronic retrieval system or otherwise, without the prior written permission of the publisher. Important Notices and Disclaimers Concerning IEEE Standards Documents IEEE documents are made available for use subject

9、to important notices and legal disclaimers. These notices and disclaimers, or a reference to this page, appear in all standards and may be found under the heading “Important Notice” or “Important Notices and Disclaimers Concerning IEEE Standards Documents.” Notice and Disclaimer of Liability Concern

10、ing the Use of IEEE Standards Documents IEEE Standards documents (standards, recommended practices, and guides), both full-use and trial-use, are developed within IEEE Societies and the Standards Coordinating Committees of the IEEE Standards Association (“IEEE-SA”) Standards Board. IEEE (“the Instit

11、ute”) develops its standards through a consensus development process, approved by the American National Standards Institute (“ANSI”), which brings together volunteers representing varied viewpoints and interests to achieve the final product. Volunteers are not necessarily members of the Institute an

12、d participate without compensation from IEEE. While IEEE administers the process and establishes rules to promote fairness in the consensus development process, IEEE does not independently evaluate, test, or verify the accuracy of any of the information or the soundness of any judgments contained in

13、 its standards. IEEE does not warrant or represent the accuracy or content of the material contained in its standards, and expressly disclaims all warranties (express, implied and statutory) not included in this or any other document relating to the standard, including, but not limited to, the warra

14、nties of: merchantability; fitness for a particular purpose; non-infringement; and quality, accuracy, effectiveness, currency, or completeness of material. In addition, IEEE disclaims any and all conditions relating to: results; and workmanlike effort. IEEE standards documents are supplied “AS IS” a

15、nd “WITH ALL FAULTS.” Use of an IEEE standard is wholly voluntary. The existence of an IEEE standard does not imply that there are no other ways to produce, test, measure, purchase, market, or provide other goods and services related to the scope of the IEEE standard. Furthermore, the viewpoint expr

16、essed at the time a standard is approved and issued is subject to change brought about through developments in the state of the art and comments received from users of the standard. In publishing and making its standards available, IEEE is not suggesting or rendering professional or other services f

17、or, or on behalf of, any person or entity nor is IEEE undertaking to perform any duty owed by any other person or entity to another. Any person utilizing any IEEE Standards document, should rely upon his or her own independent judgment in the exercise of reasonable care in any given circumstances or

18、, as appropriate, seek the advice of a competent professional in determining the appropriateness of a given IEEE standard. IN NO EVENT SHALL IEEE BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO: PROCUREMENT OF SUBSTITUTE GOO

19、DS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE PUBLICATION, USE OF, OR RELIANCE UPON ANY STANDARD, EVEN IF ADVISED

20、 OF THE POSSIBILITY OF SUCH DAMAGE AND REGARDLESS OF WHETHER SUCH DAMAGE WAS FORESEEABLE. Translations The IEEE consensus development process involves the review of documents in English only. In the event that an IEEE standard is translated, only the English version published by IEEE should be consi

21、dered the approved IEEE standard. Official statements A statement, written or oral, that is not processed in accordance with the IEEE-SA Standards Board Operations Manual shall not be considered or inferred to be the official position of IEEE or any of its committees and shall not be considered to b

22、e, or be relied upon as, a formal position of IEEE. At lectures, symposia, seminars, or educational courses, an individual presenting information on IEEE standards shall make it clear that his or her views should be considered the personal views of that individual rather than the formal position of

23、IEEE. Comments on standards Comments for revision of IEEE Standards documents are welcome from any interested party, regardless of membership affiliation with IEEE. However, IEEE does not provide consulting information or advice pertaining to IEEE Standards documents. Suggestions for changes in docu

24、ments should be in the form of a proposed change of text, together with appropriate supporting comments. Since IEEE standards represent a consensus of concerned interests, it is important that any responses to comments and questions also receive the concurrence of a balance of interests. For this re

25、ason, IEEE and the members of its societies and Standards Coordinating Committees are not able to provide an instant response to comments or questions except in those cases where the matter has previously been addressed. For the same reason, IEEE does not respond to interpretation requests. Any pers

26、on who would like to participate in revisions to an IEEE standard is welcome to join the relevant IEEE working group. Comments on standards should be submitted to the following address: Secretary, IEEE-SA Standards Board 445 Hoes Lane Piscataway, NJ 08854 USA Laws and regulations Users of IEEE Stand

27、ards documents should consult all applicable laws and regulations. Compliance with the provisions of any IEEE Standards document does not imply compliance to any applicable regulatory requirements. Implementers of the standard are responsible for observing or referring to the applicable regulatory r

28、equirements. IEEE does not, by the publication of its standards, intend to urge action that is not in compliance with applicable laws, and these documents may not be construed as doing so. Copyrights IEEE draft and approved standards are copyrighted by IEEE under U.S. and international copyright law

29、s. They are made available by IEEE and are adopted for a wide variety of both public and private uses. These include both use, by reference, in laws and regulations, and use in private self-regulation, standardization, and the promotion of engineering practices and methods. By making these documents

30、 available for use and adoption by public authorities and private users, IEEE does not waive any rights in copyright to the documents. Photocopies Subject to payment of the appropriate fee, IEEE will grant users a limited, non-exclusive license to photocopy portions of any individual standard for co

31、mpany or organizational internal use or individual, non-commercial use only. To arrange for payment of licensing fees, please contact Copyright Clearance Center, Customer Service, 222 Rosewood Drive, Danvers, MA 01923 USA; +1 978 750 8400. Permission to photocopy portions of any individual standard

32、for educational classroom use can also be obtained through the Copyright Clearance Center. Updating of IEEE Standards documents Users of IEEE Standards documents should be aware that these documents may be superseded at any time by the issuance of new editions or may be amended from time to time thr

33、ough the issuance of amendments, corrigenda, or errata. An official IEEE document at any point in time consists of the current edition of the document together with any amendments, corrigenda, or errata then in effect. Every IEEE standard is subjected to review at least every ten years. When a docum

34、ent is more than ten years old and has not undergone a revision process, it is reasonable to conclude that its contents, although still of some value, do not wholly reflect the present state of the art. Users are cautioned to check to determine that they have the latest edition of any IEEE standard.

35、 In order to determine whether a given document is the current edition and whether it has been amended through the issuance of amendments, corrigenda, or errata, visit the IEEE-SA Website at http:/ieeexplore.ieee.org/xpl/standards.jsp or contact IEEE at the address listed previously. For more inform

36、ation about the IEEE SA or IEEEs standards development process, visit the IEEE-SA Website at http:/standards.ieee.org. Errata Errata, if any, for all IEEE standards can be accessed on the IEEE-SA Website at the following URL: http:/standards.ieee.org/findstds/errata/index.html. Users are encouraged

37、to check this URL for errata periodically. Patents Attention is called to the possibility that implementation of this standard may require use of subject matter covered by patent rights. By publication of this standard, no position is taken by the IEEE with respect to the existence or validity of an

38、y patent rights in connection therewith. If a patent holder or patent applicant has filed a statement of assurance via an Accepted Letter of Assurance, then the statement is listed on the IEEE-SA Website at http:/standards.ieee.org/about/sasb/patcom/patents.html. Letters of Assurance may indicate wh

39、ether the Submitter is willing or unwilling to grant licenses under patent rights without compensation or under reasonable rates, with reasonable terms and conditions that are demonstrably free of any unfair discrimination to applicants desiring to obtain such licenses. Essential Patent Claims may e

40、xist for which a Letter of Assurance has not been received. The IEEE is not responsible for identifying Essential Patent Claims for which a license may be required, for conducting inquiries into the legal validity or scope of Patents Claims, or determining whether any licensing terms or conditions p

41、rovided in connection with submission of a Letter of Assurance, if any, or in any licensing agreements are reasonable or non-discriminatory. Users of this standard are expressly advised that determination of the validity of any patent rights, and the risk of infringement of such rights, is entirely

42、their own responsibility. Further information may be obtained from the IEEE Standards Association. Copyright 2015 IEEE. All rights reserved. vi Participants At the time this IEEE recommended practice was completed, the Electrical Installations on Shipboards Working Group had the following membership

43、: Dwight Alexander, Chair Norbert Doerry, Vice Chair John Amy Dushan Boroyevich Terry Ericsen Omar Farique Lyndsay Garrett Herb Ginn Nari Hingorani Akhter Hossain Moni Islam Boris Jacobson Yuri Khersonsky Steven Ly Mike Roa Donald Schmucker Cali Schoder Zareh Soghomanian Michael Steurer Joseph Sulli

44、van Albert Tucker Fred Wang The following members of the individual balloting committee voted on this recommended practice. Balloters may have voted for approval, disapproval, or abstention. William Ackerman John Amy Tirloch Bhat Thomas Bishop Bill Brown Carl Bush William Bush William Byrd Paul Card

45、inal Weijen Chen Keith Chow Davide de Luca Norbert Doerry Gary Donner Neal Dowling Donald Dunn Keith Flowers J. Travis Griffith Randall Groves Chris Heron Lee Herron Werner Hoelzl Shahid Jamil Ben C. Johnson Piotr Karocki Yuri Khersonsky Robert Konnik Michael Lauxman George Cristian Lazaroiu Steven

46、Liggio Arturo Maldonado William McBride John Merando Daleep Mohla Dennis Neitzel Michael Newman Richard Paes Sergio Panetta Joseph Piff Iulian Profir Vincent Saporita Robert Seitz Nikunj Shah Michael Steurer Kenneth White James Wolfe Copyright 2015 IEEE. All rights reserved. vii When the IEEE-SA Sta

47、ndards Board approved this recommended practice on 11 June 2015, it had the following membership: John D. Kulick, Chair Jon Walter Rosdahl, Vice Chair Richard H. Hulett, Past Chair Konstantinos Karachalios, Secretary Masayuki Ariyoshi Ted Burse Stephen Dukes Jean-Philippe Faure J. Travis Griffith Ga

48、ry Hoffman Michael Janezic Joseph L. Koepfinger* David J. Law Hung Ling Andrew Myles T. W. Olsen Glenn Parsons Ronald C. Petersen Annette D. Reilly Stephen J. Shellhammer Adrian P. Stephens Yatin Trivedi Phillip Winston Don Wright Yu Yuan Daidi Zhong *Member Emeritus Catherine Berger IEEE-SA Content

49、 Production and Management Lisa Perry IEEE-SA Technical Program Operations Special recognition is given to Paul Bishop, the former chair and founder of IEEE P45.3 who actively participated in the working group until his untimely death in December 2014. Copyright 2015 IEEE. All rights reserved. viii Introduction This introduction is not part of IEEE Std 45.3-2015, IEEE Recommended Practice for Shipboard Electrical InstallationsSystems Engineering. The IEEE 45 Series comprises nine recommended p