FORD U-MB098-8006-02-1996 SALT - SODIUM CHLORIDE (Shown on U-MB098-8006-01)《盐类 氯化钠 列于标准U-MB098-8006-01上》.pdf

《FORD U-MB098-8006-02-1996 SALT - SODIUM CHLORIDE (Shown on U-MB098-8006-01)《盐类 氯化钠 列于标准U-MB098-8006-01上》.pdf》由会员分享，可在线阅读，更多相关《FORD U-MB098-8006-02-1996 SALT - SODIUM CHLORIDE (Shown on U-MB098-8006-01)《盐类 氯化钠 列于标准U-MB098-8006-01上》.pdf（1页珍藏版）》请在麦多课文档分享上搜索。

1、Manufacturing Standards NIB 1. 2. 3. 4. 4.1 4.2 4.3 4.4 Salt - Sodium Chloride Scope The materids defined by this Ford Manufacturing Standard are the specific grades of Salt, Sodium Chloride. -. Application - U-MB098-8006-01 Generally used in water softening processes and other applications U-MB098-

2、8006-02 For use in salt spray test apparatuses in laboratories and paint shop U-MB098-8006-03 For spreading on roads etc. before or during snow, ice or frost. Re&rements . , I - ,I I . . , I . -01 grade It shall consist of not less than 99,6% crystalline sodium chloride. In FOB: Dried Vacuum Salt to

3、 BS 998. -02 grade It shall be undenatured sodium chloride (NaCI) substantially free of Nickel and Copper and containing on the dry basis not more than 0.1% sodium iodide (Nd) and not more than 0.3% of total impurities meeting the requirements of AS“ B 117. -03 grade It shall be a commercially avail

4、able grade of rock salt. In FOB: Rock Salt to BS 3247. where this grade is acceptable. areas. Substance restrictions Substance restrictions imposed by law, regulations or Ford, apply to the items addressed by this document. The restrictions are defined in Ford Engineering Materials Specification: “S

5、ubstance Use Restrictions“-WSS-M99F9999-A 1. Silicone Exclusion See: Ford Manufacturing Standard: “Standard Requirements Applicable to Procurement of Non-Production Materials, Machines and Equipment“ - W-MXX. All non-production materials used directly in vehicle painting operations shall be silicone

6、 free, including but not limited to filters, hoses, masking paper and tape, polishing and aero- sol products. The test for silicone contamination would be determined by using Ford Laboratory Test Method BI 125-01. User Information - Storage, Disposal and Use Empty containers shall not be pierced or

7、disposed of with general rubbish that may be incin- erated. Disposal of full (obsolete) / panially used containers must be in accordance with Company Procedures / legal requirements which is dependent upon composition classification - haz- ardous / non-hazardous. Environmental Control The -03 grade should only be used when alternatives are not available or due to safety requirements alternatives are not considered as effective. Manufacturing Administration October 1996 Maintenance Materials Chemicals, Inorganic U-MB098-8006-0 1 -03 -03 Page 1 of 1