EN ISO 3262-6-1998 en Extenders for Paints - Specifications and Methods of Test - Part 6 Precipitated Calcium Carbonate《涂料填充剂 规范和试验方法 第6部分 沉淀碳酸钙ISO 3262-6-1998》.pdf

《EN ISO 3262-6-1998 en Extenders for Paints - Specifications and Methods of Test - Part 6 Precipitated Calcium Carbonate《涂料填充剂 规范和试验方法 第6部分 沉淀碳酸钙ISO 3262-6-1998》.pdf》由会员分享，可在线阅读，更多相关《EN ISO 3262-6-1998 en Extenders for Paints - Specifications and Methods of Test - Part 6 Precipitated Calcium Carbonate《涂料填充剂 规范和试验方法 第6部分 沉淀碳酸钙ISO 3262-6-1998》.pdf（12页珍藏版）》请在麦多课文档分享上搜索。

1、- STDmBSI BS EN IS0 32bZ-b-ENGL 1998 m LbZLibbS 0727370 8Ob BRITISH STANDARD Extenders for paints - Specifications and methods of test - Part 6: Precipitated calcium carbonate * * u) The European Standard EN IS0 3262-6: 1998 has the status of a British Standard ICs 87.060.10 NO COPYING WITHOUT BSI P

2、ERMISSION EXCEPT AS PERMITTED BY COPRIGH LAW BS EN IS0 3262-61998 i STD-BSI BS EN IS0 32b2-b-ENGL 1998 Lb24bb9 0727171 742 BS EN IS0 3262-6:1998 This British Standard, having been prepared under the direction of the Sector Board for Materials and Chemicals, was published under the authority of the S

3、tandards Board and comes into effect on 15 October 1998 O BSI 1998 ISBN O 580 30498 1 National foreword This British Standard is the English language version of EN IS0 3262-6: 1998. It is identical with IS0 3262-61998. Together with the other Parts of BS EN IS0 3262, it will supersede BS 17951976 wh

4、ich is declared obsolescent. The UK participation in its preparation was entrusted to Technical Committee SW1, Pigments, which has the responsibility to: - aid enquirers to understand the text; - present to the responsible inte * rn * m, is the mass, in grams, of the dried membrane filter; m2 is the

5、 mass, in grams, of the dried membrane filter plus the residue. 7 Testreport The test report shall contain at least the following information: a) all details necessary to identify the product tested; b) a reference to this part of IS0 3262 (IS0 3262-6); c) the results of the tests and whether or not

6、 the product complies with the relevant specification limits; d) any deviation from the test methods specified; e) the dates of the tests. 3 STD.BSI BS EN IS0 32b2-b-ENGL 1778 1b29bbS 0727380 755 EN IS0 3262-6:1998 Annex ZA (normative) Normative references to international publications with their re

7、levant European publications This European Standard incorporates by dated or undated reference, provisions from other publications. These normative references are cited at the appropriate places in the text and the publications are listed hereafter. For dated references, subsequent amendments to or

8、revisions of any of these publications apply to this European Standard only when incorporated in it by amendment or revision. For undated references the latest edition of the publication referred to applies. Publication Year IS0 787-2 IS0 787-3 IS0 787-8 IS0 787-9 IS0 787-1 8 IS0 3262-1 IS0 3696 198

9、1 1979 1979 1981 1983 1997 1987 - Title - EN General methods of test for pigments and extenders - Part 2: Determination of matter volatile at 105 degrees C EN IS0 787-2 General methods of test for pigments and extenders - Part 3: Determination of matter soluble in water - Hot extraction method EN IS

10、0 787-3 General methods of test for pigments and extenders - Part 8: Determination of matter soluble in water - Cold extraction EN IS0 787-8 General methods of test for pigments and extenders - Part 9: Determination of pH value of aqueous suspension EN IS0 787-9 General methods of test for pigments

11、and extenders - Part 18: Determination of residue on sieve - Mechanical flushing procedure EN IS0 787-18 Extenders for paints - Specifications and EN IS0 3262-1 methods of test - Part 1 : Introduction and general test methods - Y ear 1995 1995 1995 1995 1995 1998 Water for analytical laboratory use

12、- Specification and test methods EN IS0 3696 1995 STD.BS1 BS EN IS0 32b2-b-ENGL 1798 1b2Libb 0727383 by3 BS EN IS0 3262-6:1998 BSI 389 Chiswick High Road London w4 4AL BSI - British Standards Institution IS1 is the independent national body responsible for preparing British Standards. It resents the

13、 UK view on standards in Europe and at the international level. It is ncorporated by Royal Charter. tevisions 3ritish Standards are updated by amendment or revision. Users of British Standards ;hould make sure that they possess the kst amendments or editions. t is the constant aim of BSI to improve

14、the quality of our products and services. We Mould be grateful if anyone hing an inaccuracy or ambiguity while using this 3ritish Standard would inform the Secretary of the technical committee responsible, he identity of which can be found on the inside front cover. Tel 0181 996 9ooo. ?ax: 0181 996

15、7400. 3SI offers members an individual upcialing service called PLUS which ensures that wbscribers automatidy receive the latest editions of standards. Buying standards aders for ali BSI, international and foreign standards publications should be addressed to Customer Services. Tel: 0181 996 7000. F

16、ax: 0181 996 7001. in response to orders for intemational standards, it is BSI policy to supply the BSI implementation of those that have been published as British Standards, unless otherwise requested. information on standards BSI provides a wide range of information on national, European and inter

17、national standards through its Library and its Technical Help to Exporters Service. Various BSI electronic information services are also available which give details on all its products and services. Contact the Information Cenh-e. Tel: 0181 996 7111. Fax: 0181 996 7048. Subscribing members of BSI a

18、re kept up to date with standards developments and receive substantial discounts on the purchase price of standards. For details of these and other benefits contact Membership Adminisiration. Tel 0181 996 7002. Fax: 0181 996 7001. Copyright Copyright subsists in all BSI publications. BSI also holds

19、the copyright, in the UK, of the publications of the international standardization bodies. Except as permitted under the Copyright, Designs and Patents Act 1988 no extract may be reproduced, stored in a retrieval system or tsansmitted in any form or by any means - electronic, photocopying, recording

20、 or otherwise - without prior written permission from BSI. This does not preclude the free use, in the course of implementing the standard, of necessary details such as symbols, and size, type or grade designations. If these details are to be used for any other purpose than implementaion then the prior written permission of BSI must be obtained If permission is granted, the terms may include royalty payments or a licensing agreement. Details and advice can be obtained from the Copynght Manager. Tel 0181 996 7070.