EN 43-1985 en Methods of Testing Doors Behaviour Under Humidity Variations of Door Leaves Placed in Successive Uniform Climates (Remains Current)《门的试验方法 连续稳定气候湿度变化条件下的门扇的性能》.pdf

《EN 43-1985 en Methods of Testing Doors Behaviour Under Humidity Variations of Door Leaves Placed in Successive Uniform Climates (Remains Current)《门的试验方法 连续稳定气候湿度变化条件下的门扇的性能》.pdf》由会员分享，可在线阅读，更多相关《EN 43-1985 en Methods of Testing Doors Behaviour Under Humidity Variations of Door Leaves Placed in Successive Uniform Climates (Remains Current)《门的试验方法 连续稳定气候湿度变化条件下的门扇的性能》.pdf（5页珍藏版）》请在麦多课文档分享上搜索。

1、1 CEN EN*g3 85 3YOY587 OOOYOb9 5 EUROPEAN STANDARD EN 43 June1985 NORME EUROPENNE EUROPISCHE NORM UDC 692.81 : 620.193.23 Supersedes EN 43, October 1975 Key words : doors, tests, artificial weathering tests, humidity, surface defects, flatness, deterioration, testing conditions English version Metho

2、ds of testing doors Behaviour under humidity variations of door leaves placed in successive uniform climates Mthodes dessais des portes-Comportement aux variations dhumidit des vantaux de portes placs dans des climats uniformec successifs Prfverfahren fr Tren; Verhalten von Trblttern unter verschied

3、enen Feuchtigkeitsbedingungen in aufeinanderfolgenden allseitig einheitlich einwirkenden konstanten klimatischen Verhltnissen This European Standard was accepted by CEN on 20 September 1984. CEN members are bound to comply with the requirements of the CEN Internal Regulations which stipulate the con

4、ditions for giving this European Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such national standards may be obtained on application to the CEN Central Secretariat or to any CEN member. This European Standard exists in

5、three official versions (English, French, German). A version in any other language made by translation under the responsibility of a CEN member into its own language and notified to CEN Central Secretariat has the same status as the official versions. CEN members are the national national standards

6、organizations of Austria, Belgium, Denmark, Finland, France, Germany, Greece, Ireland, Italy, Netherlands, Norway, Portugal, Spain, Sweden, Switzerland and United Kingdom. - CEN European Committee for Standardization Comit Europen de Normalisation Europisches Komitee fr Normung Central Secretariat:

7、rue Brderode 2, B- I000 Brussels O CEN 1985. Copyright reserved to ali CEN members Ref. No. EN 43 : 1985 E EN 43 CEN EN*43 85 340q589 0004070 L m Contents Page National foreword Inside front cover Brief history 2 National appendix A Inside back cover National appendix B Inside back cover Cooperating

8、 organizations Back cover National foreword This British Standard has been prepared under the direction of the Elements and Components (of Diverse Materials) for Buildings Standards Committee and is a revision of the 1076 edition of BS 5369 which is now withdrawn. BS 5369 is the English language ver

9、sion of EN 43 Methods of testing doors. Behaviour under humidity variations of door leaves placed in successive uniform climates published by the European Committee for Stanclarditation (CEN). Method 1 Object 2 Field of application 3 References 4 Principle of the test 5 Procedure 6 Expression of res

10、ults Page The revision of EN 43 was produced as a result of international discussion in which the UK took an active part and it amends the test temperatures to conform with IS0 554 Standard atmospheres for conditioning and/or testing - Specifications, published by the International Organization for

11、Standardization (ISO). Other minor amendments have also been made. Terminology and conventions. The text of the European Standard may use some terminology and conventions that differ from those commonly used in British Standards. Compliance with a British Standard does not of itself confer immunity

12、from legal obligations. 1 EN 43 Page 2 CEN EN*k43 85 m 340Y587 OOOYO7L 3 m Brief history This European Standard was drawn up by the Technical Committee CEN/TC 33 Technological tests for doors, windows, shutters and building hardware, the Secretariat of which is held by AFNOR, This European Standard

13、was adopted by CEN on the strength of its acceptance by the following Member countries: Austria, Belgium, France, Germany, Greece, Italy, Netherlands, Norway, Switzerland, United Kingdom. CEN EN*43 85 3404589 0004072 5 1 Object This standard describes the method which is to be used to test the behav

14、iour, under humidity variations, of door leaves placed in successive uniform climates. 2 Field of application This standard can be applied to all doors which are nominally flat and rigid, and which contain a sufficient quantity of hygroscopic materials that might influence their behaviour during thi

15、s test. 3 References EN 24 : 1974 Doors. Measurement of defects of general flatness of door leaves 4 Principle of the fest The test consists of placing the door leaves for a determined duration in successive uniform climates and measuring any changes in general flatness and noting damage which resul

16、ts. 5 Procedure 5.1 After storage in non-detrimental conditions) (relative humidity between 40 % and 75 %), measure the genera1 flatness (EN 24) of the door leaf and then place it first in a climate defined by: Nominal values Regulation deviations Temperature 23 OC f2OC Relative humidity 85 % 15% 5.

17、2 Remeasure the general flatness. EN 43 Page 3 5.3 Next, place the door leaf in a climate defined by: Nominal values Regulation deviations Temperature 23 OC +2“c Relative humidity 30 % t5% 5.4 Remeasure the general flatness once more. 5.5 The average values of temperature and relative humidity shall

18、 be maintained as close as possible to the nominal values. 5.6 The duration of exposure in each of the two climates shall be 7 days for unfinished doors and 21 days for all other doors. If the test house considers that the test can be stopped at a shorter duration, it shall justify its decision. 6 E

19、xpression of results The following information and results shall be recorded in the test report: . type, dimensions, shape and constructional details of the door leaf which shall include any machining to receive hardware and any finish applied, method of mounting the door leaf during the test, durat

20、ion of the preliminary storage in non-detrimental conditions and the characteristics of the conditions when they differ from clause 5, justification for the duration of exposure in the two ci i mates, successive measurements of general flatness, changes that have occurred in the measured values betw

21、een 5.2 and 5.4, damage which has occurred duripg the test, date of the test. 1 Specific standards on the materials of doors can, if necessary, specify the relative humidity and temperature values to be applied for storing in non-detrimental conditions. CEN ENmlt3 85 340Y589 0004073 7 - -. -_ - - EN

22、 fiz?- - National appendix A The United Kingdom participation in the preparation of this European Standard was entrsted by the Elements and Components (of Diverse Materials) for Buildings Standards Committee (ECB/-) to Technical Gommittee ECB/17 upon which the following bodies were represented: Alum

23、inium Window Association British Plastics Federation British Woodworking Federation Consumer Policy Committee of BSi Department of the Environment (Building Research Establishment, Princes Ricborough Laboratory) Department of the Environment (Property Services Agency) Fibre Building Board Organizati

24、on Fibre Cement Manufacturers Association Ltd. Flat Glass Manufacturers Association Greater London Council Guild of Architectural ironmongers Incorporated Association of Architects and Surveyors Institution of Fire Engineers London Housing Consortium Nationai House-Building Council Royal Institute o

25、f British Architects Timber Research and Development Association National appendix B The British Standard corresponding to the European Standard referred to in the text is as follows: EN 24 : 1974 European Standard British Standard BS 5277 : 1976 Doors. Measurement of defects of general flatness of door leaves.