BS EN 2985-1996 Nickel-cadmium batteries of format A type《A型规格的镍镉电池》.pdf

《BS EN 2985-1996 Nickel-cadmium batteries of format A type《A型规格的镍镉电池》.pdf》由会员分享，可在线阅读，更多相关《BS EN 2985-1996 Nickel-cadmium batteries of format A type《A型规格的镍镉电池》.pdf（12页珍藏版）》请在麦多课文档分享上搜索。

1、BRITISH STANDARD AEROSPACE SERIES BS EN 2985:1996 Nickel-cadmium batteries of format Atype The European Standard EN 2985:1996 has the status of a British Standard ICS 29.220.30; 49.060BSEN 2985:1996 This British Standard, having been prepared under the direction of the Engineering Sector Board, was

2、published under the authority of the Standards Board and comes intoeffect on 15 November 1996 BSI 11-1998 The following BSI references relate to the work on this standard: Committee reference ACE/6 Draft for comment 92/83152 DC ISBN 0 580 26325 8 Committees responsible for this British Standard The

3、preparation of this British Standard was entrusted to Technical Committee ACE/6, Aerospace batteries, upon which the following bodies were represented: British Airways British Cable Makers Confederation British Rubber Manufacturers Association Civil Aviation Authority (Airworthiness Division) Federa

4、tion of the Electronics Industry Ministry of Defence Society of British Aerospace Companies Ltd. Amendments issued since publication Amd. No. Date CommentsBSEN 2985:1996 BSI 11-1998 i Contents Page Committees responsible Inside front cover National foreword ii Foreword 2 1 Scope 3 2 Normative refere

5、nces 3 3 Characteristics 3 4 Designation 5 5 Marking 5 6 Log book 5 7 Technical specification 5 Figure 1 3 Table 1 4 Table 2 4 Table 3 5 Table 4 5 Table 5 5 List of references Inside back coverBSEN 2985:1996 ii BSI 11-1998 National foreword This British Standard has been prepared by Technical Commit

6、tee ACE/6 and is the English language version of EN 2985:1996 Aerospace series Nickel-cadmium batteries of format A type published by the European Committee for Standardization (CEN). EN 2985 was produced as a result of international discussion in which the UnitedKingdom took an active part. A Briti

7、sh Standard does not purport to include all the necessary provisions of a contract. Users of British Standards are responsible for their correct application. Compliance with a British Standard does not of itself confer immunity from legal obligations. Cross-reference Publication referred to Correspo

8、nding British Standard EN 2570:1996 BS EN 2570:1996 Nickel-cadmium batteries Technical specification Summary of pages This document comprises a front cover, an inside front cover, pages i and ii, the EN title page, pages 2 to 6, an inside back cover and a back cover. This standard has been updated (

9、see copyright date) and may have had amendments incorporated. This will be indicated in the amendment table on theinside front cover.EUROPEAN STANDARD NORME EUROPENNE EUROPISCHE NORM EN 2985 July 1996 ICS 49.060 Descriptors: Aircraft industry, aircraft equipment, electric batteries, storage batterie

10、s, nickel cadmium batteries, specifications, dimensions English version Aerospace series Nickel-cadmium batteries of format A type Srie arospatiale Batteries daccumulateurs au nickel-cadmium du type de format A Luft- und Raumfahrt Nickel-Cadmium-Batterien Bauart der Grenausfhrung A This European Sta

11、ndard was approved by CEN on 1995-06-29. CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning suc

12、h national standards may be obtained on application to the Central Secretariat or to any CEN member. This European Standard exists in three official versions (English, French, German). A version in any other language made by translation under the responsibility of a CEN member into its own language

13、and notified to the Central Secretariat has the same status as the official versions. CEN members are the national standards bodies of Austria, Belgium, Denmark, Finland, France, Germany, Greece, Iceland, Ireland, Italy, Luxembourg, Netherlands, Norway, Portugal, Spain, Sweden, Switzerland and Unite

14、d Kingdom. CEN European Committee for Standardization Comit Europen de Normalisation Europisches Komitee fr Normung Central Secretariat: rue de Stassart 36, B-1050 Brussels 1996 Copyright reserved to CEN members Ref. No. EN 2985:1996 EEN2985:1996 BSI 11-1998 2 Foreword This European Standard has bee

15、n prepared by the European Association of Aerospace Manufacturers (AECMA). After inquiries and votes carried out in accordance with the rules of this Association, this Standard has received the approval of the National Associations and the Official Services of the member countries of AECMA, prior to

16、 its presentation to CEN. This European Standard shall be given the status of a national standard, either by publication of an identical text or by endorsement, at the latest by January 1997 and conflicting national standards shall be withdrawn at the latest by January 1997. According to the CEN/CEN

17、ELEC Internal Regulations, the national standards organizations of the following countries are bound to implement this European Standard: Austria, Belgium, Denmark, Finland, France, Germany, Greece, Iceland, Ireland, Italy, Luxembourg, Netherlands, Norway, Portugal, Spain, Sweden, Switzerland and th

18、e United Kingdom.EN 2985:1996 BSI 11-1998 3 1 Scope This standard specifies the characteristics of nickel-cadmium batteries of format A type. NOTEFormat A type makes it possible to differentiate between the title of the present standard and those of the other product standards for nickel-cadmium bat

19、teries. 2 Normative references This European Standard incorporates by dated or undated reference provisions from other publications. These normative references are cited at the appropriate places in the text and the publications are listed hereafter. For dated references, subsequent amendments to or

20、 revisions of any of these publications apply to this European Standard only when incorporated in it by amendment or revision. For undated references the latest edition of the publication referred to applies. EN 2570, Aerospace series Nickel-cadmium batteries Technical specification. 3 Characteristi

21、cs 3.1 Dimensions See Figure 1. Figure 1EN 2985:1996 4 BSI 11-1998 3.2 Physical characteristics See Table 1. Table 1 3.3 Electrical characteristics See Table 2. Table 2 Characteristics Requirements Mass (with accessories) Accessories a Marking Acceleration Electrolyte spillage Seal of lid a Minimum

22、air flow rate of ventilation Resistance to salt spray 40 kg max. See 5. See EN 2570 (for crash no ignition). See EN 2570. See EN 2570. 0,027 m 3 /min See EN 2570. a Verify if required by the designation. Characteristics Test conditions Requirements Batterie s Normal High power Rated capacity C 1 34

23、Ah 34 Ah Number of cells According to code a 1 to 4 According to code a 5 to 7 Rated voltage 1,2 V per cell Available capacities See EN 2570. See EN 2570. Charge at - 18 C See EN 2570. 30 min 1 h 3 h As % of C 1Ah 4 to 6 8 to 12 15 to 20 Charge recovered in 30 min See EN 2570. 23 C 50 C % of recharg

24、ed capability 70 72 70 72 Prolonged charge at high temperature See EN 2570. See EN 2570. Starting capability Temperature See EN 2570. I at the 10th s 5 C 1A 10 C 1A I from the 11th to the 30th s b U at the 15th s 14 V 14 V Endurance See EN 2570. 5 C 1A 10 C 1A Short-circuit See EN 2570. I min.: 1 20

25、0 A U min.: 2,5 V a See Table 3. b Value fixed by the manufacturerEN 2985:1996 BSI 11-1998 5 4 Designation EXAMPLE: NOTEIf necessary, the code I9005 shall be placed between the description block and the identity block. Table 3 Table 4 Table 5 5 Marking In addition to the identity block (see 4), each

26、 battery shall bear the following information: provisioning number (for military aircraft only); name of manufacturer; manufacturers reference; country and location of manufacture; modification index where applicable; serial number; date of manufacture (month, year or code); safety instructions; pol

27、arity (see EN 2570); nominal voltage; rated capacity; number of cells. Unless otherwise indicated, the position of these markings is left to the manufacturers discretion. 6 Log book It shall contain the information of 5, information required by EN 2570 and that concerning any special particulars. 7

28、Technical specification EN 2570 Code Cells Electrolyte Number Power 1 20 Normal Normal 2 19 Normal 3 20 Reserve 4 10 Normal 5 20 High Normal 6 19 Normal 7 20 Reserve Code Case and lid 1 Sealed lid 2 Code 1 + forced ventilation 3 Code 1 + aerobatic flights 4 Lid not sealed 5 Apertures in case and lid

29、 Code Accessories 1 No accessories 2 With handles 3 With temperature sensor 4 With temperature sensor and handles6 blankBSEN 2985:1996 BSI 11-1998 List of references See national foreword.BSI 389 Chiswick High Road London W4 4AL | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | |

30、 | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | BSI British Standards Institution BSI is the independent national body responsible for preparing British Standards. I

31、t presents the UK view on standards in Europe and at the international level. It is incorporated by Royal Charter. Revisions British Standards are updated by amendment or revision. Users of British Standards should make sure that they possess the latest amendments or editions. It is the constant aim

32、 of BSI to improve the quality of our products and services. We would be grateful if anyone finding an inaccuracy or ambiguity while using this British Standard would inform the Secretary of the technical committee responsible, the identity of which can be found on the inside front cover. Tel: 020 8

33、996 9000. Fax: 020 8996 7400. BSI offers members an individual updating service called PLUS which ensures that subscribers automatically receive the latest editions of standards. Buying standards Orders for all BSI, international and foreign standards publications should be addressed to Customer Ser

34、vices. Tel: 020 8996 9001. Fax: 020 8996 7001. In response to orders for international standards, it is BSI policy to supply the BSI implementation of those that have been published as British Standards, unless otherwise requested. Information on standards BSI provides a wide range of information on

35、 national, European and international standards through its Library and its Technical Help to Exporters Service. Various BSI electronic information services are also available which give details on all its products and services. Contact the Information Centre. Tel: 020 8996 7111. Fax: 020 8996 7048.

36、 Subscribing members of BSI are kept up to date with standards developments and receive substantial discounts on the purchase price of standards. For details of these and other benefits contact Membership Administration. Tel: 020 8996 7002. Fax: 020 8996 7001. Copyright Copyright subsists in all BSI

37、 publications. BSI also holds the copyright, in the UK, of the publications of the international standardization bodies. Except as permitted under the Copyright, Designs and Patents Act 1988 no extract may be reproduced, stored in a retrieval system or transmitted in any form or by any means electro

38、nic, photocopying, recording or otherwise without prior written permission from BSI. This does not preclude the free use, in the course of implementing the standard, of necessary details such as symbols, and size, type or grade designations. If these details are to be used for any other purpose than implementation then the prior written permission of BSI must be obtained. If permission is granted, the terms may include royalty payments or a licensing agreement. Details and advice can be obtained from the Copyright Manager. Tel: 020 8996 7070.