BS 770-5-1976 Methods for chemical analysis of cheese - Determination of pH value《奶酪的化学分析法 第5部分 pH值的测定》.pdf

《BS 770-5-1976 Methods for chemical analysis of cheese - Determination of pH value《奶酪的化学分析法 第5部分 pH值的测定》.pdf》由会员分享，可在线阅读，更多相关《BS 770-5-1976 Methods for chemical analysis of cheese - Determination of pH value《奶酪的化学分析法 第5部分 pH值的测定》.pdf（6页珍藏版）》请在麦多课文档分享上搜索。

1、BRITISH STANDARD CONFIRMED FEBRUARY1991 BS 770-5:1976 Methods for Chemical analysis of cheese Part 5: Determination of pH value NOTEThis Part should be read in conjunction with Part 1: General introduction, published separately. UDC 637.322:543.247.1BS770-5:1976 BSI 08-1999 ISBN 0 580 08747 6 A Brit

2、ish Standard does not purport to include all the necessary provisions of a contract. Users of British Standards are responsible for their correct application. Compliance with a British Standard does not of itself confer immunity from legal obligations. Summary of pages This document comprises a fron

3、t cover, an inside front cover, pages i and ii, page 1 and a back cover. This standard has been updated (see copyright date) and may have had amendments incorporated. This will be indicated in the amendment table on the inside front cover. Amendments issued since publication Amd. No. Date CommentsBS

4、770-5:1976 BSI 08-1999 i Contents Page 1 Scope 1 2 References 1 3 Definition 1 4 Principle 1 5 Buffer solutions 1 6 Apparatus 1 7 Procedure 1 8 Expression of result 1 9 Repeatability 1 10 Test report 1ii blankBS770-5:1976 BSI 08-1999 1 1 Scope This Part of BS 770 describes a method for the determina

5、tion of pH value applicable to all cheeses and to processed cheese products made from cheese with the addition of emulsifying salts only. 2 References The following British Standards are referred to in this Part: BS 1647, pH scale. BS 2586, Glass electrodes for measurement of pH. 3 Definition For th

6、e purposes of this Part the following definition applies: pH value the result of the pH measurement made according to the procedure described 4 Principle A pH meter is used to determine the pH value of the cheese itself, if soft enough, or otherwise of a suspension of the cheese in water: 5 Buffer s

7、olutions Use at lease two buffer solutions, one with a higher pH value and one with a lower pH value than that of the sample under test. NOTESuitable buffer solutions are described in BS 1647. 6 Apparatus Usual laboratory apparatus is required and, in particular, the following. 6.1 pH meter, with a

8、suitable glass electrode complying with BS 2586, and with a saturated calomel or other standard reference electrode. The pH meter shall be capable of being read to the nearest 0.01 pH unit. NOTEThe apparatus shall be operated in accordance with the manufacturers instructions. 7 Procedure 7.1 Calibra

9、tion check. Before carrying out the determination, check the electrodes against two buffers, one higher and one lower in pH than the expected pH range of the samples to be measured. Ensure that the buffers and the cheese suspension are at the same temperature, preferably laboratory temperature. 7.2

10、pH measurement 7.2.1 If the cheese sample consists of cores, plugs, or cut portions of the cheese, determine the pH value as soon as possible and within 6 h of sampling. Proceed as described in 7.2.2 if possible, but if the cheese is too hard to allow this procedure, proceed instead as described in

11、7.2.3. During testing check the pH meter calibration against one of the buffer solution every 30 min, or after testing every six samples (whichever is the most frequent). 7.2.2 Press the electrodes into the cheese and read the pH value to the nearest 0.01 unit, using the pH meter. Note the temperatu

12、re of measurement. 7.2.3 Using non-absorbent apparatus (e.g. a glazed or glass mortar and pestle), mix 10 g of the sample with 6 ml of water to form a fine suspension. Using the pH meter, determine the pH value of the suspension to the nearest 0.01 unit, as soon as possible and within 30 min of prep

13、aring the suspension. Note the temperature of measurement. 7.3 Cleaning of electrodes. Clean the electrodes after each determination with a jet of water from a wash bottle and wipe them with tissue paper. Clean the glass electrode daily by swabbing with a 1 % (V/V) solution of a non-ionic detergent

14、followed by rinsing with water. 8 Expression of result Express the result as the pH value of the cheese, stating the temperature of measurement and whether or not the sample was mixed with water as described in 7.2.3. 9 Repeatability The difference between the results of two determinations carried o

15、ut simultaneously, or in rapid rapid sucession, by the same analyst should not exceed 0.05 pH unit. 10 Test report See Part 1. BS 770-5:1976 BSI 389 Chiswick High Road London W4 4AL BSIBritishStandardsInstitution BSI is the independent national body responsible for preparing BritishStandards. It pre

16、sents the UK view on standards in Europe and at the international level. It is incorporated by Royal Charter. Revisions BritishStandards are updated by amendment or revision. Users of BritishStandards should make sure that they possess the latest amendments or editions. It is the constant aim of BSI

17、 to improve the quality of our products and services. We would be grateful if anyone finding an inaccuracy or ambiguity while using this BritishStandard would inform the Secretary of the technical committee responsible, the identity of which can be found on the inside front cover. Tel:02089969000. F

18、ax:02089967400. BSI offers members an individual updating service called PLUS which ensures that subscribers automatically receive the latest editions of standards. Buying standards Orders for all BSI, international and foreign standards publications should be addressed to Customer Services. Tel:020

19、89969001. Fax:02089967001. In response to orders for international standards, it is BSI policy to supply the BSI implementation of those that have been published as BritishStandards, unless otherwise requested. Information on standards BSI provides a wide range of information on national, European a

20、nd international standards through its Library and its Technical Help to Exporters Service. Various BSI electronic information services are also available which give details on all its products and services. Contact the Information Centre. Tel:02089967111. Fax:02089967048. Subscribing members of BSI

21、 are kept up to date with standards developments and receive substantial discounts on the purchase price of standards. For details of these and other benefits contact Membership Administration. Tel:02089967002. Fax:02089967001. Copyright Copyright subsists in all BSI publications. BSI also holds the

22、 copyright, in the UK, of the publications of the internationalstandardization bodies. Except as permitted under the Copyright, Designs and Patents Act 1988 no extract may be reproduced, stored in a retrieval system or transmitted in any form or by any means electronic, photocopying, recording or ot

23、herwise without prior written permission from BSI. This does not preclude the free use, in the course of implementing the standard, of necessary details such as symbols, and size, type or grade designations. If these details are to be used for any other purpose than implementation then the prior written permission of BSI must be obtained. If permission is granted, the terms may include royalty payments or a licensing agreement. Details and advice can be obtained from the Copyright Manager. Tel:02089967070.