ANSI INCITS ISO IEC 6523-1-1998 Information technology - Structure for the identification of organizations and organization parts - Part 1 Identification of organization identifica.pdf

《ANSI INCITS ISO IEC 6523-1-1998 Information technology - Structure for the identification of organizations and organization parts - Part 1 Identification of organization identifica.pdf》由会员分享，可在线阅读，更多相关《ANSI INCITS ISO IEC 6523-1-1998 Information technology - Structure for the identification of organizations and organization parts - Part 1 Identification of organization identifica.pdf（16页珍藏版）》请在麦多课文档分享上搜索。

1、INCITS/ISO/IEC 6523-1:19982009 (ISO/IEC 6523-1:1998 , IDT) Information technology Structure for the identificationof organizations and organization parts Part 1: Identification of organizationidentification schemesINCITS/ISO/IEC 6523-1:19982009(ISO/IEC 6523-1:1998, IDT)INCITS/ISO/IEC 6523-1:19982009

2、 ii ITIC 2009 All rights reserved PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobes licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the e

3、diting. In downloading this file, parties accept therein the responsibility of not infringing Adobes licensing policy. The ISO Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can

4、be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat

5、at the address given below. Adopted by INCITS (InterNational Committee for Information Technology Standards) as an American National Standard. Date of ANSI Approval: 3/23/2009 Published by American National Standards Institute, 25 West 43rd Street, New York, New York 10036 Copyright 2009 by Informat

6、ion Technology Industry Council (ITI). All rights reserved. These materials are subject to copyright claims of International Standardization Organization (ISO), International Electrotechnical Commission (IEC), American National Standards Institute (ANSI), and Information Technology Industry Council

7、(ITI). Not for resale. No part of this publication may be reproduced in any form, including an electronic retrieval system, without the prior written permission of ITI. All requests pertaining to this standard should be submitted to ITI, 1250 Eye Street NW, Washington, DC 20005. Printed in the Unite

8、d States of America INCITS/ISO/IEC 6523-1:19982009 ISO/IEC 1998All rights reserved. Unless otherwise specified, no part of this publication may be reproduced orutilized in any form or by any means, electronic or mechanical, including photocopying and micro-film, without permission in writing from th

9、e publisher.ISO/IEC Copyright Office Case postale 56 CH-1211 Genve 20 SwitzerlandPrinted in SwitzerlandivContents1 Scope 12 Normative references 13 Definitions 14 Structure for the identification of organizations and organization parts 24.1 Components of the structure. 24.2 The International Code De

10、signator (ICD). 34.3 The identification of an organization within an identification scheme 34.4 The identification of an organization part. 34.5 The Organization Part Identifier Source indicator (OPIS) 44.6 Mechanism for association of the ICD value, the organization identifier, the organization par

11、t identifier and theOPIS value 55 Reserved ICD values. 5Annex A (normative) Specification of attributes of the International Code Designator (ICD) and of the OrganizationPart Identifier Source indicator (OPIS). 6Annex B (informative) Examples of use of the structure 8 ITIC 2009 All rights reservedIN

12、CITS/ISO/IEC 6523-1:19982009vForewordISO (the International Organization for Standardization) and IEC (the International Electrotechnical Commission) form thespecialized system for worldwide standardization. National bodies that are members of ISO or IEC participate in thedevelopment of Internationa

13、l Standards through technical committees established by the respective organization to deal withparticular fields of technical activity. ISO and IEC technical committees collaborate in fields of mutual interest. Otherinternational organizations, governmental and non-governmental, in liaison with ISO

14、 and IEC, also take part in the work.In the field of information technology, ISO and IEC have established a joint technical committee, ISO/IEC JTC 1. DraftInternational Standards adopted by the joint technical committee are circulated to national bodies for voting. Publication as anInternational Sta

15、ndard requires approval by at least 75 % of the national bodies casting a vote.International Standard ISO/IEC 6523-1 was prepared by Joint Technical Committee ISO/IEC JTC 1, Information technology,Subcommittee SC 32, Data management services.This edition, together with ISO/IEC 6523-2:1998, cancels a

16、nd replaces ISO 6523:1984, which has been technically revised.ISO/IEC 6523 consists of the following parts, under the general title Information technology Structure for the identificationof organizations and organization parts: Part 1: Identification of organization identification schemes Part 2: Re

17、gistration of organization identification schemesAnnex A forms an integral part of this part of ISO/IEC 6523. Annex B is for information only. ITIC 2009 All rights reservedINCITS/ISO/IEC 6523-1:19982009viIntroductionThe increased use of data processing and telecommunications capabilities in commerci

18、al, governmental and other applicationshas made possible the interchange of information in an effective machine-processable form. As this type of automatedinterchange increases, the need for International Standards covering data also increases. ISO/IEC 6523 defining a structure fora globally unique

19、and unambiguous identification of organizations and organization parts is one of a number of InternationalStandards that have been developed as a means for improving the accuracy and effectiveness of data processing and datainterchange.In the development of this part of ISO/IEC 6523, it has been rec

20、ognized that a single method for identifying all organizationson an international basis is neither feasible nor practicable. Instead, this part of ISO/IEC 6523 recognizes existing methods ofidentification and provides a means for systematically incorporating these in a uniform structure for the purp

21、oses of informationinterchange. In this part of ISO/IEC 6523 an organization may be identified by more than one identification method.The use of the structure for the identification of organizations and organization parts, for the purpose of interchange ofinformation, will:a) Improve the accuracy of

22、 the identification of organizations and organization parts, and hence of the interchange of data;b) reduce the need for human intervention in the interchange of information in machine-to-machine environments;c) diminish the time required to specify interchange agreements;d) as a consequence of the

23、foregoing, reduce the cost of the interchange of data.Examples illustrating the use of the structure for the identification of organizations and organization parts are given ininformative annex B.The significant changes since the preceding edition of ISO/IEC 6523 (1984) are the following: The standa

24、rd has been split into two parts, according to the ISO/IEC rules for the elaboration of standards; The organization name has been removed from the structure; The format of the ICD has been changed to variable length; The length limit for the organization identifier has been changed to 35 characters;

25、 The restrictions on the types of characters in the organization identifier have been removed; The identification of organization parts, which was only implicit in the preceding version of the standard, through thegeneric definition given for the word “organization“, is now explicit, through a separ

26、ate data element; A component has been added for the specification of the source of the Organization Part identifier. ITIC 2009 All rights reservedAMERICAN NATIONAL STANDARD INCITS/ISO/IEC 6523-1:199820091Information technology Structure for the identification of organizations andorganization parts

27、Part 1:Identification of organization identification schemes1 Scope1.1 This part of ISO/IEC 6523 specifies a structure for globally and unambiguously identifying organizations, and parts thereof,for the purpose of information interchange.This part of ISO/IEC 6523 also makes recommendations regarding

28、 cases where prior agreements may be concluded betweeninterchange partners.1.2 This part of ISO/IEC 6523 does not specify file organization techniques, storage media , languages, etc. to be used in itsimplementation.2 Normative referencesThe following standards contain provisions which, through refe

29、rence in this text, constitute provisions of this part ofISO/IEC 6523. At the time of publication, the editions indicated were valid. All standards are subject to revision, and parties toagreements based on this part of ISO/IEC 6523 are encouraged to investigate the possibility of applying the most

30、recenteditions of the standards indicated below. Members of IEC and ISO maintain registers of currently valid InternationalStandards.ISO/IEC 6523-2:1998, Information technology Structure for the identification of organizations and organization parts Part 2: Registration of organization identificatio

31、n schemes.ISO/IEC 11179-3:1994, Information technology Specification and standardization of data elements Part 3: Basicattributes of data elements.3 DefinitionsFor the purposes of this part of ISO/IEC 6523, the following definitions apply.NOTE 1: When a word or phrase appears in italics within a def

32、inition, this means that a definition exists in this part of ISO/IEC 6523 for thisword or phrase.NOTE 2: The definitions being presented in a logical order, an alphabetic list is included.Alphabetic list of the definitions Subclausecharacter repertoire 3.14data element 3.3data element value 3.4ICD 3

33、.8ICD value 3.9identification scheme 3.6identifier 3.5International Code Designator value, ICD value 3.9International Code Designator, ICD 3.8OPI 3.11OPI source indicator (OPIS) 3.12OPIS value 3.13organization 3.1organization identification scheme 3.7organization identifier 3.10organization part 3.2

34、organization part identifier (OPI) 3.11 ITIC 2009 All rights reservedINCITS/ISO/IEC 6523-1:1998200923.1 organization: A unique framework of authority within which a person or persons act, or are designated to act, towardssome purpose.NOTE 3: The kinds of organizations covered by this part of ISO/IEC

35、 6523 include the following examples:a) an organization incorporated under law;b) an unincorporated organization or activity providing goods and/or services including:1) partnerships;2) social or other non-profit organizations or similar bodies in which ownership or control is vested in a group of i

36、ndividuals;3) sole proprietorships;4) governmental bodies.c) groupings of the above types of organizations where there is a need to identify these in information interchange.3.2 organization part: Any department, service or other entity within an organization, which needs to be identified forinforma

37、tion interchange.3.3 data element: A unit of data for which the definition, identification, representation and permissible values are specified bymeans of a set of attributes (ISO/IEC 11179-3).3.4 data element value: A value out of a set of permissible values pertaining to a data element.3.5 identif

38、ier: A character or group of characters constituting a data element value used to identify or name an object andpossibly to indicate certain properties of that object.3.6 identification scheme: A system allocating identifiers to registered objects.3.7 organization identification scheme: An identific

39、ation scheme dedicated to the unique identification of organizations.3.8 International Code Designator, ICD: The data element used to uniquely identify an organization identification scheme.3.9 International Code Designator value, ICD value: The identifier allocated to a particular organization iden

40、tificationscheme.3.10 organization identifier: The identifier assigned to an organization within an organization identification scheme, andunique within that scheme.3.11 organization part identifier (OPI): An identifier allocated to a particular organization part.3.12 OPI source indicator (OPIS): Th

41、e data element used to specify the source for the organization part identifier.3.13 OPIS value: The particular value (digit or capital letter) taken by the OPIS to designate the source of an organizationpart identifier.3.14 character repertoire: A set of characters, considered independently of its e

42、ncoding.4 Structure for the identification of organizations and organization partsThe purpose of the structure for the identification of organizations and organization parts is to provide a global andunambiguous identification of one organization among all other organizations, and of any part of it

43、as appropriate.4.1 Components of the structureThe structure for the identification of organizations and organization parts consists of the following four components:a) the International Code Designator (ICD);b) the identification of an organization within an identification scheme: a data element con

44、taining an organizationidentifier;c) the identification of an organization part: a data element containing an organization part identifier (OPI);d) the OPI source indicator (OPIS): a data element containing a code value indicating the source of the OPI.The third component, identification of an organ

45、ization part, is optional. It is used when and only when one wants to designate aspecific part within an organization.The fourth component, the OPI source indicator (OPIS), shall not be used if the third component is not used; it is optional whenthe OPI is used. ITIC 2009 All rights reservedINCITS/I

46、SO/IEC 6523-1:199820093The format of these data elements is the following: ICD: integer, variable length, up to 4 digits; Identification of an organization: variable length, up to 35 characters; OPI: variable length, up to 35 characters; OPIS: 1 character.No particular sequence of the four component

47、s is specified in this part of ISO/IEC 6523.The structure is illustrated in figure 1. Examples of use of the structure are given in informative annex B.ICD Identification of an organization within an identification scheme Identification of an organization part OPISVariable Variable length Optional;

48、variable length Optional;length; up to up to 1 character.integer; 35 characters. 35 characters.up to 4digits.(The sequence of the four components is not specified in this part of ISO/IEC 6523: see 4.6)Figure 1 The structure for the identification of organizations and organization parts4.2 The Intern

49、ational Code Designator (ICD)4.2.1 The International Code Designator (ICD) is used to uniquely identify an organization identification scheme.4.2.2 The ICD values are all integers from 1 to 9999. The ICD may be transmitted as a variable-length data element;conversely, if transmitted in a 4 digit fixed length field, leading zeros shall be added to complete the format to 4 digits if theICD value is less than 1000.4.2.3 An Interna