ARI 730-2005 FLOW-CAPACITY RATING OF SUCTION-LINE FILTERS AND SUCTION-LINE FILTER-DRIERS《抽气机过滤器和过滤干燥剂流量等级级别》.pdf

《ARI 730-2005 FLOW-CAPACITY RATING OF SUCTION-LINE FILTERS AND SUCTION-LINE FILTER-DRIERS《抽气机过滤器和过滤干燥剂流量等级级别》.pdf》由会员分享，可在线阅读，更多相关《ARI 730-2005 FLOW-CAPACITY RATING OF SUCTION-LINE FILTERS AND SUCTION-LINE FILTER-DRIERS《抽气机过滤器和过滤干燥剂流量等级级别》.pdf（8页珍藏版）》请在麦多课文档分享上搜索。

1、 4100 N. FAIRFAX DR., SUITE 200 ARLINGTON, VIRGINIA 22203 2005 STANDARD for FLOW- CAPACITY RATING OF SUCTION- LINE FILTERS AND SUCTION-LINE FILTER- DRIERS Standard 730 Copyright Air-Conditioning and Refrigeration Institute Provided by IHS under license with ARI Not for ResaleNo reproduction or netwo

2、rking permitted without license from IHS-,-,-IMPORTANT SAFETY DISCLAIMER ARI does not set safety standards and does not certify or guarantee the safety of any products, components or systems designed, tested, rated, installed or operated in accordance with this standard/guideline. It is strongly rec

3、ommended that products be designed, constructed, assembled, installed and operated in accordance with nationally recognized safety standards and code requirements appropriate for products covered by this standard/guideline. ARI uses its best efforts to develop standards/guidelines employing state-of

4、-the-art and accepted industry practices. ARI does not certify or guarantee that any tests conducted under its standards/guidelines will be non-hazardous or free from risk. Note: This standard supersedes ARI Standard 730-2001. Price $5.00 (M) $10.00 (NM) Copyright 2005, by Air-Conditioning and Refri

5、geration Institute Printed in U.S.A. Registered United States Patent and Trademark Office Copyright Air-Conditioning and Refrigeration Institute Provided by IHS under license with ARI Not for ResaleNo reproduction or networking permitted without license from IHS-,-,-TABLE OF CONTENTS SECTION PAGE Se

6、ction 1. Purpose.1 Section 2. Scope1 Section 3. Definitions .1 Section 4. Test Requirements .2 Section 5. Rating Requirements2 Section 6. Minimum Data Requirements for Published Ratings 3 Section 7. Marking and Nameplate Data 3 Section 8. Conformance Conditions .3 TABLES Table 1. Recommended Pressur

7、e Drop Values for Rating and Selection of Suction-Line Filters and Suction-Line Filter-Driers .3 APPENDICES Appendix A. References - Normative .4 Appendix B. References - Informative4 Copyright Air-Conditioning and Refrigeration Institute Provided by IHS under license with ARI Not for ResaleNo repro

8、duction or networking permitted without license from IHS-,-,-Copyright Air-Conditioning and Refrigeration Institute Provided by IHS under license with ARI Not for ResaleNo reproduction or networking permitted without license from IHS-,-,-ARI STANDARD 730-2005 1FLOW-CAPACITY RATING OF SUCTION-LINE FI

9、LTERS AND SUCTION-LINE FILTER-DRIERS Section 1. Purpose 1.1 Purpose. The purpose of this standard is to establish, for refrigerant Suction-Line Filters and Suction-Line Filter-Driers (which may be referred to herein as “filters“): definitions; test requirements; rating requirements; minimum data req

10、uirements for Published Ratings; marking and nameplate data; and conformance conditions. 1.1.1 Intent. This standard is intended for the guidance of the industry, including manufacturers, engineers, installers, contractors and users. 1.1.2 Review and Amendment. This standard is subject to review and

11、 amendment as technology advances. Section 2. Scope 2.1 Scope. This standard applies to Suction-Line Filters and Suction-Line Filter-Driers, as defined in Section 3. 2.2 Refrigerant. This standard applies to Suction-Line Filters and Suction-Line Filter-Driers for use in systems employing halocarbon

12、refrigerants R-12, R-22, R-134a, R-404A, R-407C, R-410A, R-502, and R-507A, as defined in ANSI/ASHRAE 34 with addenda. Section 3. Definitions All terms in this document follow the standard industry definitions in the current edition of ASHRAE Terminology of Heating, Ventilation, Air Conditioning and

13、 Refrigeration unless otherwise defined in this section. 3.1 Permanent Installation. An installation intended to remain in the system for an indefinite period. 3.2 Published Rating. A statement of the assigned values of those performance characteristics, under stated Rating Conditions, by which a un

14、it may be chosen to fit its application. These values apply to all units of like nominal size and type (identification) produced by the same manufacturer. The term Published Rating includes the rating of all performance characteristics shown on the unit or published in specifications, advertising or

15、 other literature controlled by the manufacturer, at stated Rating Conditions. 3.2.1 Application Rating. A rating based on tests performed at application Rating Conditions (other than Standard Rating Conditions). 3.2.2 Standard Rating. A rating based on tests performed at Standard Rating Conditions.

16、 3.3 Rating Conditions. Any set of operating conditions under which a single level of performance results and which causes only that level of performance to occur. 3.3.1 Standard Rating Conditions. Rating conditions used as the basis of comparison for performance characteristics. 3.4 Refrigerant Flo

17、w Capacity. The flow of refrigerant liquid, expressed as Tons of Refrigeration or mass flow rate, for a given refrigerant under specified conditions, which the filter will pass and not exceed the specified Pressure Drop. 3.4.1 Pressure Drop. The pressure difference between the inlet and outlet of a

18、filter, including its connections expressed in psi kPa. 3.4.2 Ton of Refrigeration. A useful refrigerating effect equal to 12,000 Btu/h 3.5 kW. Copyright Air-Conditioning and Refrigeration Institute Provided by IHS under license with ARI Not for ResaleNo reproduction or networking permitted without

19、license from IHS-,-,-ARI STANDARD 730-2005 2 3.5 “Shall“ or “Should“. “Shall“ or “should“ shall be interpreted as follows: 3.5.1 Shall. Where “shall“ or “shall not“ is used for a provision specified, that provision is mandatory if compliance with the standard is claimed. 3.5.2 Should. “Should“ is us

20、ed to indicate provisions which are not mandatory, but which are desirable as good practice. 3.6 Suction-Line Filter. A manufactured device used in the suction line of a system, for the purpose of removing and retaining solid contaminants from the refrigerant. 3.7 Suction-Line Filter-Drier. A manufa

21、ctured device used in the suction line of a system, whose element is partly or wholly composed of a desiccant. It is intended to remove and retain moisture as well as solid contaminants from the refrigerant. 3.8 Temporary Installation. An installation intended to remain in the system for a short per

22、iod of time with the purpose of cleaning a new or severely contaminated system. Section 4. Test Requirements 4.1 Test Requirements. All filter and filter-drier capacity ratings shall be based on tests in accordance with, or subject to verification by, the test procedure of ANSI/ASHRAE Standard 78. 4

23、.1.1 If the filter capacity depends upon the position of or direction of flow through the filter, the filter shall be tested for all variations for which ratings are published. Section 5. Rating Requirements 5.1 Published Ratings. As used herein, the term Published Ratings includes the ratings shown

24、 on the filter or published in specifications, advertising or other literature controlled by the manufacturer at stated Rating Conditions. Published Ratings shall include Standard Ratings, and may also include Application Ratings (See Table 1). 5.2 Standard Ratings. Standard capacity ratings of filt

25、ers for refrigerant suction-line service shall be stated in Tons of Refrigeration, tons kW and/or mass flow rate, lb/min kg/s. The following specified conditions shall be used to determine the refrigerant flow rate through the filter. 5.2.1 Standard Rating Conditions. Standard Rating Conditions shal

26、l be: Evaporator saturation temperature 40F 4.4C Vapor temperature leaving evaporator 50F 10C Vapor temperature entering filter 65F 18C Liquid temperature entering expansion device 90F 32C Pressure Drop for R-22, R-404A, R-407C, R-410A, R-502 and R-507A 3.0 psi 21 kPa Pressure Drop for R-12 and R-13

27、4a 2.0 psi 14 kPa 5.2.2 Application Rating Conditions. In addition to ARI standard capacity ratings at the conditions specified in 5.2.1, capacity ratings may also be published for other evaporator temperatures or pressure drop values, provided they are specified as such and are based on all the oth

28、er provisions of this section (See Table 1). 5.3 Tolerances. To comply with this standard, published capacity ratings shall be based on the requirements of this section, and shall be such that any production Suction-Line Filter or Suction-Line Filter-Drier selected at random and tested shall have a

29、capacity not less than 95% of its Standard Rating. Copyright Air-Conditioning and Refrigeration Institute Provided by IHS under license with ARI Not for ResaleNo reproduction or networking permitted without license from IHS-,-,-ARI STANDARD 730-2005 3Table 1. Recommended Pressure Drop Values for Rat

30、ing and Selection of Suction-Line Filters and Suction-Line Filter-Driers Permanent Installations1Recommended Application Conditions for Temporary Installation Evaporator Saturated Suction Temperature R-22, R-404A, R-407C, R-410A, R-502, and R-507A R-12, R-134a R-22, R-404A, R-407C, R-410A, R-502, an

31、d R-507A R-12, R-134a F C psi kPa psi kPa psi kPa psi kPa *40 20 0.0 -20 -40 4.4 -6.7 -18 -29 -40 *3.0 2.0 1.5 1.0 0.5 21 14 10 7.0 3.0 *2.0 1.5 1.0 0.5 N/A 14 10 7.0 3.0 N/A 8.0 4.0 3.0 2.0 1.0 55 28 21 14 7.0 6.0 3.0 2.0 1.0 N/A 41 21 14 7.0 N/A *ARI Standard Rating Conditions, Permanent Installat

32、ions only. 1These pressure drop values also represent recommended maximum pressure drop values for selections of filters for Permanent Installation. Section 6. Minimum Data Requirements for Published Ratings 6.1 Minimum Data Requirements for Published Ratings. As a minimum, Published Ratings shall i

33、nclude all Standard Ratings. All claims to ratings within the scope of this standard shall include the statement “Rated in accordance with ARI Standard 730“. All claims to ratings outside the scope of this standard shall include the statement “Outside the scope of ARI Standard 730”. Wherever Applica

34、tion Ratings are published or printed, they shall include a statement of the conditions at which the ratings apply. Section 7. Marking and Nameplate Data 7.1 As a minimum, the nameplate shall display the manufacturers name and model designation. Section 8. Conformance Conditions 8.1 Conformance. Whi

35、le conformance with this standard is voluntary, conformance shall not be claimed or implied for products or equipment within the standards Purpose (Section 1) and Scope (Section 2) unless such product claims meet all of the requirements of the standard and all of the testing and rating requirements

36、are measured and reported in complete compliance with the standard. Any product that has not met all the requirements of the standard shall not reference, state, or acknowledge the standard in any written, oral, or electronic communication. Copyright Air-Conditioning and Refrigeration Institute Prov

37、ided by IHS under license with ARI Not for ResaleNo reproduction or networking permitted without license from IHS-,-,-ARI STANDARD 730-2005 4 APPENDIX A. REFERENCES - NORMATIVE A1 Listed here are all standards, handbooks and other publications essential to the formation and implementation of the sta

38、ndard. All references in this appendix are considered as part of the standard. A.1.1 ANSI/ASHRAE Standard 34-2004 with Addenda, Designation and Safety Classification of Refrigerants, 2004, American National Standards Institute/American Society of Heating, Refrigerating and Air-Conditioning Engineers

39、, Inc., West 43 Street, 4 Floor, New York, NY 10036, U.S.A./1791 Tullie Circle N.E., Atlanta, GA 30329, U.S.A.rd thA.1.2 ANSI/ASHRAE Standard 78-1985 (RA 2003), Method of Testing Flow Capacity of Suction Line Filters and Filter Driers, 2003, American National Standards Institute/American Society of

40、Heating, Refrigerating and Air-Conditioning Engineers, Inc., West 43 Street, 4 Floor, New York, NY 10036, U.S.A./1791 Tullie Circle N.E., Atlanta, GA 30329, U.S.A.rd thA.1.3 ASHRAE Terminology of Heating, Ventilation, Air-Conditioning and Refrigeration, Second Edition, 1991, American Society of Heat

41、ing, Refrigerating and Air-Conditioning Engineers, Inc., 1791 Tullie Circle N.E., Atlanta, GA 30329, U.S.A.APPENDIX B. REFERENCES INFORMATIVE None. Copyright Air-Conditioning and Refrigeration Institute Provided by IHS under license with ARI Not for ResaleNo reproduction or networking permitted without license from IHS-,-,-