AIR FORCE MIL-C-25548 C-1970 CONTROL PUBLIC ADDRESS SET C-1614 AIC-13《C-1614 AIC-13型公共地址控制系统》.pdf

《AIR FORCE MIL-C-25548 C-1970 CONTROL PUBLIC ADDRESS SET C-1614 AIC-13《C-1614 AIC-13型公共地址控制系统》.pdf》由会员分享，可在线阅读，更多相关《AIR FORCE MIL-C-25548 C-1970 CONTROL PUBLIC ADDRESS SET C-1614 AIC-13《C-1614 AIC-13型公共地址控制系统》.pdf（10页珍藏版）》请在麦多课文档分享上搜索。

1、1, SCoflE. 1.1 Ihis specification oovms one ty-pe of control, designaA urePaBnt functions should be obtainrOl shall be a step type, mecharLca3ly The a%huatLon oiltroi sha be between 25 an 35 ounce inches. 3.2.4 Console Cmtrol Panel. The control panel shall be in accordance wia taie requirements of K

2、13rc-5781 for Type 1 control panel eJccept as specified hdo 3.2.6 Service Conditions (E3.ectrical). The equipeross ?lees otherwise specjB.e, the ampJifier sball.be tested under the following conditionsi a. Tenpraizret Roon ambient, plus SOC to plus 35OC b. Pressure: iiormal atmspheric C. Humidity: R

3、oom ambient, up to 90 percent relative humidity d. Primary voltage supply: 27.5 volts d-c ? 1.0 volt 4.3 Preproduction Tests. Preproduction tests shail be performed by the cor,tractm in accordance witn the following: 4.3.1 Prepductior. Test Sam2les. 4.3.1.1 Contractor Teat Samples. %her, specified i

4、n the contract a dinbnun of 10 each C-16.4/UX3 controls chdl be subjected by the corz-bractor ta the pre-,nroductioll testa specified herein. be wed far reliability testing ora. 4.3.1.2 controls not used above in reliability testing shall be submitted to the procuring activity. infomatian inauding t

5、he OOvernment order mimber involved (“EUe Numbe.rl* in contract), if ay, name and address of prime wntractor, and naftie and address of manufacturer. The samples and data will be useci by the procuring activity for: Seven (7) each of these samples Examination of Product 4.5.i 3 Au- All ELectrical Te

6、sts 4.5.2 6 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-C-25598C 58 7979706 0353989 3 W Irqut-autpt characteristic Input-o=tput characteristic test Frequency response characteristic Erequency response Characteristic test parer mtpt Distortion

7、 Distortion Test Internal noise level licropaionic noise circuitry test QwsshalEr Characteristic Crossta test peration test Eiectromagnetic interference Reliability Reliability Test %viromental Tests Temprakcre-Aitiiude Vibr atiofi from cpantities of controls which have passed the individual tests.

8、eubjected to the sampling tests listed in Table IV Sn the quantities shown. The sampes shaU. be 4.4.2.1 ,4ccepAwce Criteria. . The distortion In the output of the oontrol. , and that three (3) each Ccmtro, public &ress Set C-./AIC-U not useci in reliability testhg nha77 be sutmitlied to te procuring

9、 ac.tiVitgr. nie invitation for bids and the contract &di spec. the point of inspection for these tests. 6.3 QUM es Frooa Previous Issue. Asbericks are not used in WS revision to ibWQ chmg es with respect to the previous issue due to %he extenaveness of the eso Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-