IEC 61162-2-1998 Maritime navigation and radiocommunication equipment and systems - Digital interfaces - Part 2 Single talker and multiple listeners high-speed .pdf

《IEC 61162-2-1998 Maritime navigation and radiocommunication equipment and systems - Digital interfaces - Part 2 Single talker and multiple listeners high-speed .pdf》由会员分享，可在线阅读，更多相关《IEC 61162-2-1998 Maritime navigation and radiocommunication equipment and systems - Digital interfaces - Part 2 Single talker and multiple listeners high-speed .pdf（54页珍藏版）》请在麦多课文档分享上搜索。

1、 IEC 61162-2 Edition 1.0 1998-09 INTERNATIONAL STANDARD NORME INTERNATIONALE Maritime navigation and radiocommunication equipment and systems Digital interfaces Part 2: Single talker and multiple listeners, high-speed transmission Matriels et systmes de navigation et de radiocommunication maritimes

2、Interfaces numriques Partie 2: Emetteur unique et rcepteurs multiples, transfert rapide de donnes IEC 61162-2:1998 THIS PUBLICATION IS COPYRIGHT PROTECTED Copyright 1998 IEC, Geneva, Switzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilize

3、d in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either IEC or IECs member National Committee in the country of the requester. If you have any questions about IEC copyright or have an enquiry about obtaining additional

4、rights to this publication, please contact the address below or your local IEC member National Committee for further information. Droits de reproduction rservs. Sauf indication contraire, aucune partie de cette publication ne peut tre reproduite ni utilise sous quelque forme que ce soit et par aucun

5、 procd, lectronique ou mcanique, y compris la photocopie et les microfilms, sans laccord crit de la CEI ou du Comit national de la CEI du pays du demandeur. Si vous avez des questions sur le copyright de la CEI ou si vous dsirez obtenir des droits supplmentaires sur cette publication, utilisez les c

6、oordonnes ci-aprs ou contactez le Comit national de la CEI de votre pays de rsidence. IEC Central Office Tel.: +41 22 919 02 11 3, rue de Varemb Fax: +41 22 919 03 00 CH-1211 Geneva 20 infoiec.ch Switzerland www.iec.ch About the IEC The International Electrotechnical Commission (IEC) is the leading

7、global organization that prepares and publishes International Standards for all electrical, electronic and related technologies. About IEC publications The technical content of IEC publications is kept under constant review by the IEC. Please make sure that you have the latest edition, a corrigenda

8、or an amendment might have been published. Useful links: IEC publications search - www.iec.ch/searchpub The advanced search enables you to find IEC publications by a variety of criteria (reference number, text, technical committee,). It also gives information on projects, replaced and withdrawn publ

9、ications. IEC Just Published - webstore.iec.ch/justpublished Stay up to date on all new IEC publications. Just Published details all new publications released. Available on-line and also once a month by email. Electropedia - www.electropedia.org The worlds leading online dictionary of electronic and

10、 electrical terms containing more than 30 000 terms and definitions in English and French, with equivalent terms in additional languages. Also known as the International Electrotechnical Vocabulary (IEV) on-line. Customer Service Centre - webstore.iec.ch/csc If you wish to give us your feedback on t

11、his publication or need further assistance, please contact the Customer Service Centre: csciec.ch. A propos de la CEI La Commission Electrotechnique Internationale (CEI) est la premire organisation mondiale qui labore et publie des Normes internationales pour tout ce qui a trait llectricit, llectron

12、ique et aux technologies apparentes. A propos des publications CEI Le contenu technique des publications de la CEI est constamment revu. Veuillez vous assurer que vous possdez ldition la plus rcente, un corrigendum ou amendement peut avoir t publi. Liens utiles: Recherche de publications CEI - www.i

13、ec.ch/searchpub La recherche avance vous permet de trouver des publications CEI en utilisant diffrents critres (numro de rfrence, texte, comit dtudes,). Elle donne aussi des informations sur les projets et les publications remplaces ou retires. Just Published CEI - webstore.iec.ch/justpublished Rest

14、ez inform sur les nouvelles publications de la CEI. Just Published dtaille les nouvelles publications parues. Disponible en ligne et aussi une fois par mois par email. Electropedia - www.electropedia.org Le premier dictionnaire en ligne au monde de termes lectroniques et lectriques. Il contient plus

15、 de 30 000 termes et dfinitions en anglais et en franais, ainsi que les termes quivalents dans les langues additionnelles. Egalement appel Vocabulaire Electrotechnique International (VEI) en ligne. Service Clients - webstore.iec.ch/csc Si vous dsirez nous donner des commentaires sur cette publicatio

16、n ou si vous avez des questions contactez-nous: csciec.ch. IEC 61162-2 Edition 1.0 1998-09 INTERNATIONAL STANDARD NORME INTERNATIONALE Maritime navigation and radiocommunication equipment and systems Digital interfaces Part 2: Single talker and multiple listeners, high-speed transmission Matriels et

17、 systmes de navigation et de radiocommunication maritimes Interfaces numriques Partie 2: Emetteur unique et rcepteurs multiples, transfert rapide de donnes INTERNATIONAL ELECTROTECHNICAL COMMISSION COMMISSION ELECTROTECHNIQUE INTERNATIONALE T ICS 47.020.70 PRICE CODE CODE PRIX ISBN 978-2-83220-622-5

18、 Registered trademark of the International Electrotechnical Commission Marque dpose de la Commission Electrotechnique Internationale Warning! Make sure that you obtained this publication from an authorized distributor. Attention! Veuillez vous assurer que vous avez obtenu cette publication via un di

19、stributeur agr. 2 61162-2 IEC:1998 CONTENTS FOREWORD . 3 1 General 4 1.1 Scope 4 1.2 Normative references 4 1.3 Definitions . 5 2 Manufacturers documentation 5 2.1 Standard documents 5 2.2 Additional information 5 3 Hardware specification 5 3.1 Interconnecting wires . 5 3.2 Conductor definitions . 6

20、 3.3 Electrical connection/shield requirements . 6 3.4 Connector 6 3.5 Electrical signal characteristics 6 4 Data transmission . 7 5 Data format protocol . 7 5.1 Characters. 7 5.2 Fields 8 5.3 Sentences . 9 5.4 Error detection and handling 12 6 Data content . 13 7 Applications 13 8 Methods of testin

21、g and required test results 13 8.1 Test preparation 13 8.2 Test sequence . 13 8.3 Standard test signals . 13 8.4 Test of the interface . 13 Annex A (informative) IMO resolutions and ITU recommendations and relevant IEC/ISO standards to which this standard applies for maritime navigation and radiocom

22、munication equipment and systems . 16 Annex B (informative) Glossary 24 Figure 1 Talker/listener connections . 15 Figure 2 Cables Electrical shield requirements . 15 Figure 3 Data transmission format 15 Table A.1 Navigation 16 Table A.2 Radiocommunications for the global maritime distress and safety

23、 system (GMDSS) 17 61162-2 IEC:1998 3 INTERNATIONAL ELECTROTECHNICAL COMMISSION _ MARITIME NAVIGATION AND RADIOCOMMUNICATION EQUIPMENT AND SYSTEMS DIGITAL INTERFACES Part 2: Single talker and multiple listeners, high-speed transmission FOREWORD 1) The IEC (International Electrotechnical Commission)

24、is a worldwide organization for standardization comprising all national electrotechnical committees (IEC National Committees). The object of the IEC is to promote international co-operation on all questions concerning standardization in the electrical and electronic fields. To this end and in additi

25、on to other activities, the IEC publishes International Standards. Their preparation is entrusted to technical committees; any IEC National Committee interested in the subject dealt with may participate in this preparatory work. International, governmental and non-governmental organizations liaising

26、 with the IEC also participate in this preparation. The IEC collaborates closely with the International Organization for Standardization (ISO) in accordance with conditions determined by agreement between the two organizations. 2) The formal decisions or agreements of the IEC on technical matters ex

27、press, as nearly as possible, an international consensus of opinion on the relevant subjects since each technical committee has representation from all interested National Committees. 3) The documents produced have the form of recommendations for international use and are published in the form of st

28、andards, technical reports or guides and they are accepted by the National Committees in that sense. 4) In order to promote international unification, IEC National Committees undertake to apply IEC International Standards transparently to the maximum extent possible in their national and regional st

29、andards. Any divergence between the IEC Standard and the corresponding national or regional standard shall be clearly indicated in the latter. 5) The IEC provides no marking procedure to indicate its approval and cannot be rendered responsible for any equipment declared to be in conformity with one

30、of its standards. 6) Attention is drawn to the possibility that some of the elements of this International Standard may be the subject of patent rights. The IEC shall not be held responsible for identifying any or all such patent rights. International Standard IEC 61162-2 has been prepared by techni

31、cal committee 80: Maritime navigation and radiocommunication equipment and systems. This part of IEC 61162 is based upon NMEA 0183, version 2.30, and it is the intention of IEC and NMEA to maintain this commonality as far as possible. This bilingual version (2013-01) corresponds to the monolingual E

32、nglish version, published in 1998-09. The text of this standard is based on the following documents: FDIS Report on voting 80/189/FDIS 80/206/RVD Full information on the voting for the approval of this standard can be found in the report on voting indicated in the above table. The French version of

33、this standard has not been voted upon. Annexes A and B are for information only. 4 61162-2 IEC:1998 MARITIME NAVIGATION AND RADIOCOMMUNICATION EQUIPMENT AND SYSTEMS DIGITAL INTERFACES Part 2: Single talker and multiple listeners, high-speed transmission 1 General 1.1 Scope This part of IEC 61162 con

34、tains the requirements for data communication between maritime electronic instruments, navigation and radiocommunication equipment when interconnected via an appropriate interface. This standard is intended to support one-way serial data transmission from a single talker to one or more listeners. Th

35、is data is in printable ASCII form and may include any information as specified by approved sentences or information coded according to the rules for proprietary sentences. Typical messages may be from 11 to a maximum of 79 characters in length and generally require repetition rates up to once per 2

36、0 ms. The electrical definitions in this standard are intended to accommodate higher data rates than are specified in IEC 61162-1. Since there is no provision for guaranteed delivery of messages and only limited error-checking capability, this standard should be used with caution in all safety appli

37、cations. Annex A contains a list of relevant IMO resolutions and ITU recommendations to which this standard applies. 1.2 Normative references The following normative documents contain provisions which, through reference in this text, constitute provisions of this part of IEC 61162. At the time of pu

38、blication, the editions indicated were valid. All normative documents are subject to revision, and parties to agreements based on this part of IEC 61162 are encouraged to investigate the possibility of applying the most recent editions of the normative documents indicated below. Members of IEC and I

39、SO maintain registers of currently valid International Standards. IEC 60945:1996, Maritime navigation and radiocommunication equipment and systems General requirements, methods of testing and required test results IEC 61162-1:1995, Maritime navigation and radiocommunication equipment and systems Dig

40、ital interfaces Part 1: Single talker and multiple listeners ITU-T V.11:1996, Electrical characteristics for balanced double-current interchange circuits operating at data signalling rates up to 10 Mbits/s NMEA 0183 Version 2.30:1998, National marine electronics association (USA) Standard for interf

41、acing marine electronic navigational devices EIA 485:1991, Electrical characteristics of generators and receivers for use in balanced digital multipoint systems 61162-2 IEC:1998 5 1.3 Definitions Common terms are defined in the glossary of annex B. Where there is a conflict, terms shall be interpret

42、ed, wherever possible, in accordance with the references in 1.2. For the purposes of this part of IEC 61162, the following definitions apply. talker any device which sends data to other devices. The type of talker is identified by a two- character mnemonic as listed in 6.2 (table 4) of IEC 61162-1.

43、listener any device which receives data from another device latency time interval between an event and its resulting information, including time for processing, transmission and/or reception 2 Manufacturers documentation 2.1 Standard documents Operator manuals or other appropriate literature provide

44、d for equipment that is intended to meet the requirements of this standard shall contain as a minimum the following information: a) identification of the A, B and common (C) signal lines; b) the output drive capability as a talker; c) a list of approved sentences, noting unused fields, proprietary s

45、entences transmitted as a talker, data latency and transmission interval for each sentence; d) the load requirements as a listener; e) a list of sentences and associated data fields that are required by, or are acceptable to, a listener; f) the current software and hardware revision if this is relev

46、ant to the interface; g) an electrical description or schematic of the listener/talker input/output circuits citing actual components and devices used, including connector type and part number; h) the version number and date of update of the standard for which compliance is sought. 2.2 Additional in

47、formation As latency, filtering, error handling and data transmission interval can have a serious influence on the performance of a system, the manufacturer shall give careful consideration to these aspects. Documentation should include such data where applicable. 3 Hardware specification One talker

48、 and multiple listeners may be connected in parallel over interconnecting wires. Because of EMC requirements shielded cables are recommended. The number of listeners depends on the output capability, the input drive requirements of the connected devices, and on the use of termination resistors. 3.1

49、Interconnecting wires Interconnection between devices may be by means of a shielded two-conductor twisted-pair wire (A, B) plus any means to secure common signal ground potential (C) for transmitting and 6 61162-2 IEC:1998 receiving devices. For this purpose, a third wire additional to the twisted pair or the inner shield of double-shielded cable with insulated shields may be used. 3.2 Conductor definitions The conductors