IEC 62498-1-2010 Railway applications - Environmental conditions for equipment - Part 1 Equipment on board rolling stock《轨道交通.设备的环境条件.第1部分 机车车辆上的设备》.pdf

《IEC 62498-1-2010 Railway applications - Environmental conditions for equipment - Part 1 Equipment on board rolling stock《轨道交通.设备的环境条件.第1部分 机车车辆上的设备》.pdf》由会员分享，可在线阅读，更多相关《IEC 62498-1-2010 Railway applications - Environmental conditions for equipment - Part 1 Equipment on board rolling stock《轨道交通.设备的环境条件.第1部分 机车车辆上的设备》.pdf（40页珍藏版）》请在麦多课文档分享上搜索。

1、 IEC 62498-1 Edition 1.0 2010-08 INTERNATIONAL STANDARD NORME INTERNATIONALE Railway applications Environmental conditions for equipment Part 1: Equipment on board rolling stock Applications ferroviaires Conditions denvironnement pour le matriel Partie 1: Equipement embarqu du matriel roulant IEC 62

2、498-1:2010 THIS PUBLICATION IS COPYRIGHT PROTECTED Copyright 2010 IEC, Geneva, Switzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without p

3、ermission in writing from either IEC or IECs member National Committee in the country of the requester. If you have any questions about IEC copyright or have an enquiry about obtaining additional rights to this publication, please contact the address below or your local IEC member National Committee

4、 for further information. Droits de reproduction rservs. Sauf indication contraire, aucune partie de cette publication ne peut tre reproduite ni utilise sous quelque forme que ce soit et par aucun procd, lectronique ou mcanique, y compris la photocopie et les microfilms, sans laccord crit de la CEI

5、ou du Comit national de la CEI du pays du demandeur. Si vous avez des questions sur le copyright de la CEI ou si vous dsirez obtenir des droits supplmentaires sur cette publication, utilisez les coordonnes ci-aprs ou contactez le Comit national de la CEI de votre pays de rsidence. IEC Central Office

6、 3, rue de Varemb CH-1211 Geneva 20 Switzerland Email: inmailiec.ch Web: www.iec.ch About the IEC The International Electrotechnical Commission (IEC) is the leading global organization that prepares and publishes International Standards for all electrical, electronic and related technologies. About

7、IEC publications The technical content of IEC publications is kept under constant review by the IEC. Please make sure that you have the latest edition, a corrigenda or an amendment might have been published. Catalogue of IEC publications: www.iec.ch/searchpub The IEC on-line Catalogue enables you to

8、 search by a variety of criteria (reference number, text, technical committee,). It also gives information on projects, withdrawn and replaced publications. IEC Just Published: www.iec.ch/online_news/justpub Stay up to date on all new IEC publications. Just Published details twice a month all new pu

9、blications released. Available on-line and also by email. Electropedia: www.electropedia.org The worlds leading online dictionary of electronic and electrical terms containing more than 20 000 terms and definitions in English and French, with equivalent terms in additional languages. Also known as t

10、he International Electrotechnical Vocabulary online. Customer Service Centre: www.iec.ch/webstore/custserv If you wish to give us your feedback on this publication or need further assistance, please visit the Customer Service Centre FAQ or contact us: Email: csciec.ch Tel.: +41 22 919 02 11 Fax: +41

11、 22 919 03 00 A propos de la CEI La Commission Electrotechnique Internationale (CEI) est la premire organisation mondiale qui labore et publie des normes internationales pour tout ce qui a trait llectricit, llectronique et aux technologies apparentes. A propos des publications CEI Le contenu techniq

12、ue des publications de la CEI est constamment revu. Veuillez vous assurer que vous possdez ldition la plus rcente, un corrigendum ou amendement peut avoir t publi. Catalogue des publications de la CEI: www.iec.ch/searchpub/cur_fut-f.htm Le Catalogue en-ligne de la CEI vous permet deffectuer des rech

13、erches en utilisant diffrents critres (numro de rfrence, texte, comit dtudes,). Il donne aussi des informations sur les projets et les publications retires ou remplaces. Just Published CEI: www.iec.ch/online_news/justpub Restez inform sur les nouvelles publications de la CEI. Just Published dtaille

14、deux fois par mois les nouvelles publications parues. Disponible en-ligne et aussi par email. Electropedia: www.electropedia.org Le premier dictionnaire en ligne au monde de termes lectroniques et lectriques. Il contient plus de 20 000 termes et dfinitions en anglais et en franais, ainsi que les ter

15、mes quivalents dans les langues additionnelles. Egalement appel Vocabulaire Electrotechnique International en ligne. Service Clients: www.iec.ch/webstore/custserv/custserv_entry-f.htm Si vous dsirez nous donner des commentaires sur cette publication ou si vous avez des questions, visitez le FAQ du S

16、ervice clients ou contactez-nous: Email: csciec.ch Tl.: +41 22 919 02 11 Fax: +41 22 919 03 00 IEC 62498-1 Edition 1.0 2010-08 INTERNATIONAL STANDARD NORME INTERNATIONALE Railway applications Environmental conditions for equipment Part 1: Equipment on board rolling stock Applications ferroviaires Co

17、nditions denvironnement pour le matriel Partie 1: Equipement embarqu du matriel roulant INTERNATIONAL ELECTROTECHNICAL COMMISSION COMMISSION ELECTROTECHNIQUE INTERNATIONALE R ICS 45.060 PRICE CODE CODE PRIX ISBN 978-2-88912-095-6 Registered trademark of the International Electrotechnical Commission

18、Marque dpose de la Commission Electrotechnique Internationale 2 62498-1 IEC:2010 CONTENTS FOREWORD.3 1 Scope.5 2 Normative references .5 3 Terms and definitions .6 4 Environmental conditions7 4.1 General .7 4.2 Altitude7 4.3 Temperature7 4.4 Humidity9 4.5 Air movement 14 4.6 Rain 14 4.7 Snow and hai

19、l14 4.8 Ice.14 4.9 Solar radiation.14 4.10 Lightning .14 4.11 Pollution15 4.12 Vibrations and shocks .15 4.13 Electromagnetic environment 15 4.14 Acoustic noise environment.15 4.15 Supply system characteristics .15 Annex A (informative) Distortion of a.c. supply voltage 17 Bibliography18 Figure 1 Hu

20、midity ranges for temperature classes T1, T4 and TX 10 Figure 2 Humidity ranges for temperature classes T2 and T3.11 Figure 3 Humidity ranges for temperature classes T5.12 Figure 4 Humidity ranges for temperature classes T6.13 Table 1 Classes of altitude range.7 Table 2 Classes of air temperatures.8

21、 Table 3 Classes of reference temperature8 Table A.1 Odd harmonic components compatibility levels 17 Table A.2 Even harmonic components compatibility levels.17 Table A.3 Interharmonic components compatibility levels.17 62498-1 IEC:2010 3 INTERNATIONAL ELECTROTECHNICAL COMMISSION _ RAILWAY APPLICATIO

22、NS ENVIRONMENTAL CONDITIONS FOR EQUIPMENT Part 1: Equipment on board rolling stock FOREWORD 1) The International Electrotechnical Commission (IEC) is a worldwide organization for standardization comprising all national electrotechnical committees (IEC National Committees). The object of IEC is to pr

23、omote international co-operation on all questions concerning standardization in the electrical and electronic fields. To this end and in addition to other activities, IEC publishes International Standards, Technical Specifications, Technical Reports, Publicly Available Specifications (PAS) and Guide

24、s (hereafter referred to as “IEC Publication(s)”). Their preparation is entrusted to technical committees; any IEC National Committee interested in the subject dealt with may participate in this preparatory work. International, governmental and non- governmental organizations liaising with the IEC a

25、lso participate in this preparation. IEC collaborates closely with the International Organization for Standardization (ISO) in accordance with conditions determined by agreement between the two organizations. 2) The formal decisions or agreements of IEC on technical matters express, as nearly as pos

26、sible, an international consensus of opinion on the relevant subjects since each technical committee has representation from all interested IEC National Committees. 3) IEC Publications have the form of recommendations for international use and are accepted by IEC National Committees in that sense. W

27、hile all reasonable efforts are made to ensure that the technical content of IEC Publications is accurate, IEC cannot be held responsible for the way in which they are used or for any misinterpretation by any end user. 4) In order to promote international uniformity, IEC National Committees undertak

28、e to apply IEC Publications transparently to the maximum extent possible in their national and regional publications. Any divergence between any IEC Publication and the corresponding national or regional publication shall be clearly indicated in the latter. 5) IEC itself does not provide any attesta

29、tion of conformity. Independent certification bodies provide conformity assessment services and, in some areas, access to IEC marks of conformity. IEC is not responsible for any services carried out by independent certification bodies. 6) All users should ensure that they have the latest edition of

30、this publication. 7) No liability shall attach to IEC or its directors, employees, servants or agents including individual experts and members of its technical committees and IEC National Committees for any personal injury, property damage or other damage of any nature whatsoever, whether direct or

31、indirect, or for costs (including legal fees) and expenses arising out of the publication, use of, or reliance upon, this IEC Publication or any other IEC Publications. 8) Attention is drawn to the Normative references cited in this publication. Use of the referenced publications is indispensable fo

32、r the correct application of this publication. 9) Attention is drawn to the possibility that some of the elements of this IEC Publication may be the subject of patent rights. IEC shall not be held responsible for identifying any or all such patent rights. International Standard IEC 62498-1 has been

33、prepared by IEC technical committee 9: Electrical equipment and systems for railways. This standard is based on EN 50125-1. The text of this standard is based on the following documents: FDIS Report on voting 9/1402/FDIS 9/1451/RVD Full information on the voting for the approval of this standard can

34、 be found in the report on voting indicated in the above table. A list of all parts of IEC 62498 series, under the general title Railway applications Environmental conditions for equipment, can be found on the IEC website. 4 62498-1 IEC:2010 This publication has been drafted in accordance with the I

35、SO/IEC Directives, Part 2. The committee has decided that the contents of this publication will remain unchanged until the stability date indicated on the IEC web site under “http:/webstore.iec.ch“ in the data related to the specific publication. At this date, the publication will be reconfirmed, wi

36、thdrawn, replaced by a revised edition, or amended. 62498-1 IEC:2010 5 RAILWAY APPLICATIONS ENVIRONMENTAL CONDITIONS FOR EQUIPMENT Part 1: Equipment on board rolling stock 1 Scope This part of IEC 62498 intends to define environmental conditions. The scope of this standard covers the use of on board

37、 electrical, electromechanical and electronic equipment for rolling stock, for the following parameters: altitude, temperature, humidity, air movement, rain, snow and hail, ice, solar radiation, lightning, pollution, vibrations and shocks, electromagnetic interference environment, acoustic noise env

38、ironment, supply system characteristics. In particular the standard defines: interface conditions between the vehicle and its environment; general environmental rules for the equipment of rolling stock, especially for the main sub- systems. In this respect it gives general guidance in order to allow

39、 the fairness of bid assessments. The defined environmental conditions are considered as normal in service; occasionally more severe conditions may be specified. Microclimates surrounding components may be defined by relevant product standards or by special requirements. This standard is not intende

40、d to apply to cranes, mining vehicles, cable cars. Passenger effects on the equipment and equipment effects on the passengers are not considered in this standard. 2 Normative references The following referenced documents are indispensable for the application of this document. For dated references, o

41、nly the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. IEC 60529, Degrees of protection provided by enclosures (IP Code) IEC 60721-1, Classification of environmental conditions Part 1: Environmental parameters and thei

42、r severities IEC 60721-2-3, Classification of environmental conditions Part 2: Environmental conditions appearing in nature Section 3: Air pressure IEC 60721-3-5, Classification of environmental conditions Part 3: Classification of groups of environmental parameters and their severities Section 5: G

43、round vehicle installations IEC 60850, Railway applications Supply voltages of traction systems 6 62498-1 IEC:2010 IEC 61373, Railway applications Rolling stock equipment Shock and vibration tests IEC 62236-3-1, Railway applications Electromagnetic compatibility Part 3-1: Rolling stock Train and com

44、plete vehicle IEC 62236-3-2, Railway applications Electromagnetic compatibility Part 3-2: Rolling stock Apparatus IEC 62497-2, Railway applications Insulation coordination Part 2: Overvoltages and related protection 3 Terms and definitions For the purposes of this document, the following terms and d

45、efinitions apply. 3.1 environmental conditions physical, chemical or biological condition, external to a product to which it is subjected at a certain time 3.2 vehicle compartment compartment of vehicles in which people may enter during normal operation 3.3 vehicle cubicle any enclosure for housing

46、of mechanical, electrical and/or electronic equipment 3.4 environmental parameters one or more physical, chemical or biological properties characterising an environmental factor (e.g. temperature, acceleration) EXAMPLE The environmental factor vibration is characterised by the parameters: type of vi

47、bration (sinusoidal, random), acceleration and frequency. 3.5 severity of environmental parameters a value of each quantity characterising the environmental parameter EXAMPLE The severity of sinusoidal vibration is defined by values of the acceleration (in m/s 2 ) and frequency (in Hz). 3.6 performa

48、nce range the range of parameters in which the equipment works with the specified performance 3.7 operation range the performance range in which the equipment works with the limited performance range 3.8 storage temperature the ambient temperature of storage without damage on the stored goods and/or

49、 equipment in no powered states 62498-1 IEC:2010 7 4 Environmental conditions 4.1 General In the following clauses the environmental parameters are given at which the vehicle and its equipment shall function as specified. In the text, normal environmental conditions are considered as being those of all over the world. They are classified with a suffix