NAVY A-A-50615-1993 BATTERY STORAGE (PORTABLE SEALED MAINTENANCE-FREE LEAD-ACID) 6 VOLT 130 AMPERE-HOUR TYPE 6V-S-130 AH《6V-S-130 AH型6伏130安培小时砣酸免养护密封便携式畜电电池》.pdf

《NAVY A-A-50615-1993 BATTERY STORAGE (PORTABLE SEALED MAINTENANCE-FREE LEAD-ACID) 6 VOLT 130 AMPERE-HOUR TYPE 6V-S-130 AH《6V-S-130 AH型6伏130安培小时砣酸免养护密封便携式畜电电池》.pdf》由会员分享，可在线阅读，更多相关《NAVY A-A-50615-1993 BATTERY STORAGE (PORTABLE SEALED MAINTENANCE-FREE LEAD-ACID) 6 VOLT 130 AMPERE-HOUR TYPE 6V-S-130 AH《6V-S-130 AH型6伏130安培小时砣酸免养护密封便携式畜电电池》.pdf（5页珍藏版）》请在麦多课文档分享上搜索。

1、A-A-50bL5 9999974 OLbL738 bb8 I INCH-POUND 1 A-A-50615 3 December 1993 COMMERCIAL ITEM DESCRIPTION BATTERY, STORAGE (PORTABLE, SEALED, MAINTENANCE-FREE, LEAD-ACID) 6 VOLT, 130 AMPERE-HOUR, TYPE 6V-S-130 AH The General Services Administration has authorized the use of this Commercial Item Description

2、. Abstract. This Commercial Item Description covers a 6 volt (normal and reversed), 130 ampere-hour sealed, valve-regulated lead-acid (VRLA), storage battery with a high rate and shallow discharge duty cycle for use on Naval surface ships. Definition of Normal and Reversed. Looking at the battery to

3、p with the intercell connectors as shown, the positive terminal is located : at top right for Normal (N) at top left for Reversed (R) 0 8 3 I I Beneficial comments (recommendations, additions, deletions) and any pertinent data which may be of use in improving this document should be addressed to: Co

4、mmander, Naval Sea Systems Command, ATTN: 03R42, 2531 Jefferson Davis Hwy, Arlington, VA 22242-5160. FSC 6140 DISTRIBUTION STATEMENT A. Approved for public release; distribution is unlimited. 1 Licensed by Information Handling ServicesA-A-50b15 9 9999974 0161739 5T4 m A-A-506 15 Salient characterist

5、ic. The product shall be a 6 volt (normal or reversed), 130 ampere-hour sealed lead-acid storage battery, meeting the requirements specified below. 1. Dimensions. The maximum dimensions for the battery shall be: length - 16.3 inches width - 7.1 inches height - 9.4 inches 2. Weiqht. The battery weigh

6、t shall be 77 pounds maximum when filled. 3. Terminals. The terminals shall be posts with lugs capable of receiving a round end lug accepting an AWG #O000 cable. 4. Pressure relief valve. The battery shall have sufficient pressure relief valves to prevent rupturing of the battery when internal press

7、ure exceed battery design pressure. 5. Capacity. a. The capacity for the 13 ampere (or 10 hour) rate shall be a minimum of 130 ampere-hours with a cut-off voltage of 5.25 volts in the temperature range of 20“ to 27“ C. b. The capacity for the 42.5 ampere (or 2 hour) rate shall be a minimum of 85 amp

8、ere-hours with a cut-off voltage of 4.8 volts in the temperature range of 20“ to 27“ C. c. The capacity for the 312 ampere (or 5 minute) rate shall be a minimum of 26 ampere-hours with a cut-off voltage of 3.6 volts in the temperature range of 20“ to 27“ C. 6. Reserve capacity. The battery shall del

9、iver 25 amperes for a minimum of 210 minutes at 25C with a cut-off voltage of 5.25 volts. 7. Cold crankinq performance at -18C (0F). The battery shall deliver 965 amperes for a minimum of 30 seconds at -18C with a cut-off voltage of 3.6 volts. 2 Licensed by Information Handling ServicesA-A-50bL5 999

10、9974 OLbL740 2Lb = A-A-50615 8. Retention of charqe. The battery shall retain at least 80% of the 10 hour-rate capacity (130 ampere-hours) 28 days after charge termination when discharged at the 10 h our rate. 9. Cvclina. The battery shall be capable of 90 cycles minimum. The cycles shall consist of

11、 any combination of the requirements listed in paragraphs 5, 7 and 8 with a minimum of 80% capacity at the specified rate. At least one cycle of each capacity check listed in paragraph 5 shall be conducted for verification. Only cycles yielding 80% or greater capacity are to be counted. Charging sha

12、ll be conducted with a constant potential charger set at 7.05 volts with a limiting current of 30 amperes. 10. Each battery shall be provided with a lifting device or system to facilitate manual or mechanical handling. 11. Bid samples. When specified in the solicitation, bid samples shall be furnish

13、ed. Contractor Certification. The contractor shall certify and maintain substantiating evidence that the product offered meets the salient characteristics of this Commercial Item Description, and that the product conforms to the producers own drawings, specifications, standards and quality assurance

14、 practices. The government reserves the right to require proof of such conformance prior to first delivery and thereafter as may be otherwise provided for under the provisions of the contract. Metric Products. Products manufactured to metric dimensions will be considered on an equal basis with those

15、 manufactured using inch-pound units, provided they fall within specified tolerances using conversion tables contained in the latest revision of Federal Standard No. 376 and all other requirements of this Commercial Item Description are met. 0 If a product is manufactured to metric dimensions, the d

16、imensions and tolerances shall not exceed those specified in the inch-pound units, and overall outside dimensions shall remain equal to or less than those stated in inches. The contracting officer has the option of accepting or rejecting the product. 3 Licensed by Information Handling ServicesA-A-50

17、615 W 9999974 0363743 152 9 A-A-506 15 Recrulatory Requirements. The offeror/contractor is encouraged to use recovered materials in accordance with Public Law 94-580 to the maximum extent practicable. Safety. A Material Safety Data Sheet (MSDS) is required in accordance with Code of Federal Regulati

18、ons, 29 CFR 1910-1200 and FED-STD-313. Preservation, Dackauina, P ackins, labelins and markins. The preservation, packaging, packing, labeling and marking shall be as specified in the contract or order. Notes. Purchaser should specify voltage, ampere-hours and size if bid samples are required. FED-S

19、TD-376 is available from the Standardization Documents Order Desk, 700 Robbins Avenue, Building #4, Section D, Philadelphia, PA 19111-5094. Potential sources. Based on information available at the time this document was developed, the following products are believed to comply with the salient charac

20、teristics of this Commercial Item Description. Competition is not limited to the indicated . sources. Manufacturer Concorde Battery Corp. 2009 San Bernadino Ave West Covina, CA 91803 Manufacturers battery code RG-257 Powersafe Standby Batteries Inc. 3VB-17 (160AH) (Chloride Systems) POB 492 Mallard

21、Lane North Haven, CT 06473 4 Licensed by Information Handling ServicesA-A-5 O 6 15 MILITARY INTERESTS: CIVIL AGENCY COORDINATING ACTIVITIES Military Coordinating Activity Navy - SH Custodian Army - ER Air Force - 99 Navy - SH Review GSA - FSS PREPARING ACTIVITY: NAVY - SH PROJECT 6140-0746 Army - AV, MI, AT Air Force - 11, 80 Navy - AS DLA - GS 5 Licensed by Information Handling Services