HOLDEN HN 1986-1990 Adhesive - Hot Melt - Pressure Sensitive《粘接剂 热熔 压敏型》.pdf

《HOLDEN HN 1986-1990 Adhesive - Hot Melt - Pressure Sensitive《粘接剂 热熔 压敏型》.pdf》由会员分享，可在线阅读，更多相关《HOLDEN HN 1986-1990 Adhesive - Hot Melt - Pressure Sensitive《粘接剂 热熔 压敏型》.pdf（2页珍藏版）》请在麦多课文档分享上搜索。

1、A.C.N. 006 893 232Holden LimitedEngineering DepartmentMATERIAL SPECIFICATIONNUMBERSHEETRELEASEREVISION:HN 19861 of 2December, 1989November, 1990NAME: ADHESIVE - HOT MELT - PRESSURE SENSITIVETHIS DOCUMENT MUST NOT BE REPRODUCED. IF USED IN RELATION TOTHE COMPANYS PRODUCTS THE RECIPIENT IS RESPONSIBLE

2、 TOCONFIRM THE DOCUMENT ISSUE DATE IS STILL VALID.FORM : I:LABRTORYFORMSTDMATSPEC.DOC1. SCOPEThe material described in this specification is a Hot Melt Pressure SensitiveAdhesive. It is suitable for the bonding of materials such as synthetic carpets,felts, triflex, etc., to plastics such as ABS, Pol

3、ypropylene etc.,where low tomedium temperature resistance is required.The adhesive may be applied via roller, slot nozzle or hot melt spray equipment.2. PHYSICAL PROPERTIES2.1 Colour - Amber2.2 Application - 150 - 180 C2.3 Viscosity (Brookfield RV8 27/2.5 rpm)at 150 C - 2,700 CPS ) 10%at 180 C - 1,2

4、00 CPS ) 10%2.4 Softening Point (Ring and Ball) 64 C2.5 Shear Adhesion (180 C Application Temperature)Steel/Steel 50 kPaPolypropylene/Polypropylene 50 kPaAssemblies allowed to cool for 4 hours prior to testing.Jaw separation 100mm/minute.2.6 Degradation Point Greater than 200 C.2.7 Flash Point Great

5、er than 290 C.2.8 Storage life Indefinite at 25 C.3. APPROVAL, CERTIFICATION, )INSPECTION AND REJECTION. ) Refer HN 1000, Clauses A,B,C and G.A.C.N. 006 893 232Holden LimitedEngineering DepartmentMATERIAL SPECIFICATIONNUMBERSHEETRELEASEREVISION:HN 19862 of 2December, 1989November, 1990NAME: ADHESIVE

6、 - HOT MELT - PRESSURE SENSITIVETHIS DOCUMENT MUST NOT BE REPRODUCED. IF USED IN RELATION TOTHE COMPANYS PRODUCTS THE RECIPIENT IS RESPONSIBLE TOCONFIRM THE DOCUMENT ISSUE DATE IS STILL VALID.FORM : I:LABRTORYFORMSTDMATSPEC.DOCAPPROVED SUPPLIERS AND MATERIALS SHEETAPPROVED MATERIALS APPROVED SUPPLIERS288-3983 NATIONAL STARCH & CHEMICALHM 0038C H.B. FULLERNOTE: Prior to supply of thismaterial to GMHA, for any purpose including test work, a safety datasheet must beforwarded to theOccupational Hygienist, Medical Centre, General Motors HoldensAutomotive Limited.