FORD U-AB200-1992 DIAMOND HOLDER WITH STRAIGHT SHANK《带直柄的金刚石夹具》.pdf

《FORD U-AB200-1992 DIAMOND HOLDER WITH STRAIGHT SHANK《带直柄的金刚石夹具》.pdf》由会员分享，可在线阅读，更多相关《FORD U-AB200-1992 DIAMOND HOLDER WITH STRAIGHT SHANK《带直柄的金刚石夹具》.pdf（2页珍藏版）》请在麦多课文档分享上搜索。

1、Manufacturing Standards A Diamond holder with straight shank - Dimensions in mm UNDERCUTZrZ DIN509 -3 +FI- IFRD-Standard part no. 0Al B IGfC I D 0E( F I G 1 H I J 1 L I R I Material -1 U AB 20061 O 0000000 U AB 20071 O O00 O000 U AB 20081 O O00 0000 U A6 20091 O OOOOO Ordering examples: a) for a hol

2、der with parallel shank, shank 0 = 14. B = 43, with no diamond b) the same holder incluiing a soldered diamd. 2.5 Kt octahedron shape c) the name holder including a soldercd diimun. 2.5 Kt octdwdron shape UAB2002100000000 UAB2002122500000 U AB200 2 12 250 O ADO and mnatory choine to 2 suppliers. Exc

3、epted are only supplier “A“ and “D“. I mportantr Standard part number must alrnys contain 16 rllnits. Where necessary Insert zeros as shown in the examples. The supp1ier:deslgnation letters must be In alphabetical der. Finish: Supplied with edges broken and rust inhibited. 1- Angle projection to IS0

4、 R 128 Surface finish in Ra pm to manufacturlna standard tolerances for open dimensions on machined surfaces * 0.25 I) me holder is to be replaced if the shank diameter C reduces in size by more than 0,15 nnn due to repeated U - W Oc- lettering to manufacturing staniard U - TX 001 re-working after d

5、iamond resetting. . U-AB 200 Page 1 Manufacturing Administration Dressing took blsy 1991 A Manufacturing Standards c-2 , Diamond holder with parallel Dimensions in mrn 0 shank UAB20052 00000000 12.70 50 6,s 10 4 9SMnPb28 O ftandard-part-llo. must always contain 16 diqits orrl,:;pki o der vith a shan

6、k UM zoo For a diamoud holder with a shank UM 200 Tar a diaaond holder vith a shank the supplier “A* and % only UA8 200 diaaeter of 1l.ll na 420 000 o O00 diaacter of 11.11 m including one 1/2 Kt Oktaeder inserted 422 0% o O00 diameter of 11.11 UNI including one 1/2 Kt Oktaeder inserted to be suppli

7、ed from 422 0% O ABO Finish: Supplied with edges broken and rast inhibitit. 1. Angle projection to IS0 R 128 Surface finish in Ra U. ta anufacturinq standard U-XB 009, lettering to manufacturing standard bTX 001 tolerances for open diaensions 2 0,25. 1) lhe shank is to be replaced if the shank alaieter C redulss in size by more than 0,15 m due to repeated re workina after diamond resettina, Manufacturina U - AB 200 Page. 2 Dressing toots Adrninistratio P1:1y 1y72