FORD ESE-M2C162-A-2009 OIL SYNTHETIC - IMPREGNATING - HIGH TEMPERATURE TO BE USED WITH FORD WSS-M99P1111-A 《耐高温浸渍用合成油 与标准FORD WSS-M99P1111-A一起使用 》.pdf

《FORD ESE-M2C162-A-2009 OIL SYNTHETIC - IMPREGNATING - HIGH TEMPERATURE TO BE USED WITH FORD WSS-M99P1111-A 《耐高温浸渍用合成油 与标准FORD WSS-M99P1111-A一起使用 》.pdf》由会员分享，可在线阅读，更多相关《FORD ESE-M2C162-A-2009 OIL SYNTHETIC - IMPREGNATING - HIGH TEMPERATURE TO BE USED WITH FORD WSS-M99P1111-A 《耐高温浸渍用合成油 与标准FORD WSS-M99P1111-A一起使用 》.pdf（1页珍藏版）》请在麦多课文档分享上搜索。

1、 ENGINEERING MATERIAL SPECIFICATIONDate Action Revisions 2009 10 26 N-STATUS No known use. No Replacement Named D. DiGregorio, NA 2004 05 19 Revised Para 3.0 inserted; para 4 & 5 deleted 1980 09 10 Released CE3K-PR741089-E Printed copies are uncontrolled Copyright 2009, Ford Global Technologies, LLC

2、 Page 1 of 1 OIL, SYNTHETIC - IMPREGNATING - HIGH TEMPERATURE ESE-M2C162-A NOT TO BE USED FOR NEW DESIGN 1. SCOPE The material defined by this specification is a blend of mono-ester and diester-based lubricating oil. 2. APPLICATION This specification was released originally for oil designed for impr

3、egnating sintered distributor bearings. 3. REQUIREMENTS 3.1 VISCOSITY 37.8 C 36 - 43 cSt (mm2/s) (ASTM D 445) 98.9 C 9.05 - 9.45 cSt (mm2/s) 3.2 POUR POINT, max -56 C (ASTM D 97) 3.3 FLASH POINT, min 232 C (ASTM D 92) 3.4 RUST PREVENTION Procedure “A“ No Rust (ASTM D 665) Procedure “B“ No Rust 3.5 COPPER CORROSION, max lb (ASTM D 130) 3.6 EVAPORATION LOSS, max 0.2% (ASTM D 972) 3.7 WATER CONTENT, max 0.05% (ASTM D 95)