DLA MIL-DTL-3933 18 G-2011 ATTENUATORS FIXED SPACE LEVEL NON SPACE LEVEL COAXIAL LINE (SERIES N) FREQUENCY RANGE DC TO 12 4 GHZ AND DC TO 18 GHZ CLASS III LOW POWER.pdf
《DLA MIL-DTL-3933 18 G-2011 ATTENUATORS FIXED SPACE LEVEL NON SPACE LEVEL COAXIAL LINE (SERIES N) FREQUENCY RANGE DC TO 12 4 GHZ AND DC TO 18 GHZ CLASS III LOW POWER.pdf》由会员分享,可在线阅读,更多相关《DLA MIL-DTL-3933 18 G-2011 ATTENUATORS FIXED SPACE LEVEL NON SPACE LEVEL COAXIAL LINE (SERIES N) FREQUENCY RANGE DC TO 12 4 GHZ AND DC TO 18 GHZ CLASS III LOW POWER.pdf(5页珍藏版)》请在麦多课文档分享上搜索。
1、AMSC N/A FSC 5985 MIL-DTL-3933/18G 7 April 2011 SUPERSEDING MIL-DTL-3933/18F 7 November 2002 DETAIL SPECIFICATION SHEET ATTENUATORS, FIXED, SPACE LEVEL, NON SPACE LEVEL, COAXIAL LINE (SERIES N), FREQUENCY RANGE: DC TO 12.4 GHZ AND DC TO 18 GHZ, CLASS III, LOW POWER This specification is approved for
2、 use by all Departments and Agencies of the Department of Defense. The requirements for acquiring the product described herein shall consist of this specification sheet and MIL-DTL-3933. NOTES: 1. Dimensions are in inches. 2. Metric equivalents are given for general information only. 3. Metric equiv
3、alents are in parentheses. FIGURE 1. Dimensions and configuration. INCH-POUND Provided by IHSNot for Resale-,-,-MIL-DTL-3933/18G 2 ENGINEERING DATA: Operating frequency range: DC to 12.4 GHz and DC to 18 GHz. Test frequency ranges for SWR and attenuation measurements, measured or recorded, when usin
4、g an Automatic Network Analyzer (ANA) or equivalent test equipment: 100 MHz (or lower) to 12.4 GHz for dash numbers 01 through 20; 100 MHz (or lower) to 18.0 GHz for dash numbers 21 through 24. Basic test frequencies for sensitive measurements like connector repeatability, temperature sensitivity, p
5、ower sensitivity and any other measurements where a delta specification is imposed: 6.0 GHz for dash numbers 01 through 20; 8.0 GHz for dash numbers 21 through 24. Operating temperature range: -55C to + 125C. Maximum weight: See table I. REQUIREMENTS: Dimensions and configuration: See figure 1 and t
6、able I. Nominal impedance: 50 ohms. Attenuation: See table I. Stability and sensitivity: Maximum change in attenuation after: up to 10 dB, inclusive (dB) over 10 dB (dB/dB) Temperature change or thermal shock 0.05 0.005 Vibration or shock 0.1 0.01 Moisture resistance or salt spray 0.2 0.02 Peak powe
7、r 0.05 0.005 Frequency sensitivity, maximum: 0.1dB/dB/GHz. Temperature sensitivity of attenuation, maximum: 0.0004 dB/dB/C. Power: See table I. Power sensitivity for full input power, maximum: 0.005 dB/dB/Watt. VSWR: See table I. Terminal connectors: The series N connectors shall meet the interface
8、dimensions of MIL-PRF-39012. There shall be a male plug on one end and a female plug on the other end. Connector repeatability, maximum variation in attenuation: 0.02 dB. Part or Identifying Number (PIN): M3933/18- (and dash number from table I with three device level designators are space level (T)
9、, screened (S) and non-screened (N) options). Supersession data: See table III. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHSAMSC N/A FSC 5985 TABLE I. Electrical characteristics. Dash number Attenuation dB Maximum power input VSWR 1/ Maximum Weight (o
- 1.请仔细阅读文档,确保文档完整性,对于不预览、不比对内容而直接下载带来的问题本站不予受理。
- 2.下载的文档,不会出现我们的网址水印。
- 3、该文档所得收入(下载+内容+预览)归上传者、原创作者;如果您是本文档原作者,请点此认领!既往收益都归您。
下载文档到电脑,查找使用更方便
10000 积分 0人已下载
下载 | 加入VIP,交流精品资源 |
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- DLAMILDTL393318G2011ATTENUATORSFIXEDSPACELEVELNONSPACELEVELCOAXIALLINESERIESNFREQUENCYRANGEDCTO124GHZANDDCTO18GHZCLASSIIILOWPOWERPDF

链接地址:http://www.mydoc123.com/p-690742.html