ASTM E1819-2010 Standard Guide for Environmental Monitoring Plans for Decommissioning of Nuclear Facilities《核设备退役的环境监测计划标准指南》.pdf

《ASTM E1819-2010 Standard Guide for Environmental Monitoring Plans for Decommissioning of Nuclear Facilities《核设备退役的环境监测计划标准指南》.pdf》由会员分享，可在线阅读，更多相关《ASTM E1819-2010 Standard Guide for Environmental Monitoring Plans for Decommissioning of Nuclear Facilities《核设备退役的环境监测计划标准指南》.pdf（9页珍藏版）》请在麦多课文档分享上搜索。

1、Designation: E1819 10Standard Guide forEnvironmental Monitoring Plans for Decommissioning ofNuclear Facilities1This standard is issued under the fixed designation E1819; the number immediately following the designation indicates the year oforiginal adoption or, in the case of revision, the year of l

2、ast revision. A number in parentheses indicates the year of last reapproval. Asuperscript epsilon () indicates an editorial change since the last revision or reapproval.1. Scope1.1 This guide covers the development or assessment ofenvironmental monitoring plans for decommissioning nuclearfacilities.

3、 This guide addresses: (1) development of an envi-ronmental baseline prior to commencement of decommission-ing activities; (2) determination of release paths from siteactivities and their associated exposure pathways in the envi-ronment; and (3) selection of appropriate sampling locationsand media t

4、o ensure that all exposure pathways in the envi-ronment are monitored appropriately. This guide also addressesthe interfaces between the environmental monitoring plan andother planning documents for site decommissioning, such asradiation protection, site characterization, and waste manage-ment plans

5、, and federal, state, and local environmental protec-tion laws and guidance. This guide is applicable up to the pointof completing D (2) decontami-nation to reduce radiation levels in support of as low asreasonably achievable (ALARA) objectives; (3) decontamina-tion to limit the spread of radiologic

6、al contamination; (4)decontamination to support the unrestricted release of materialand equipment; and (5) decontamination of personnel.3.1.6 monitoring, vtobserving or taking measurementssystematically over time to determine the status of and to detectsignificant changes in conditions or performanc

7、e of a system,facility, or area.3.1.7 passive phase, ntime of surveillance and mainte-nance from the time plant operations cease untildecontamination/dismantling operations begin, and from theend of active decontamination/dismantling operations until thesite is released for unrestricted use.3.1.8 ra

8、diological release criteria, nlevels of residualradioactivity present at the completion of a decommissioningactivity below which the site may be released to the generalpublic for unrestricted use.3.1.9 hazardous material clean-up criteria, nthe reduc-tion of hazardous contaminants needed to reduce t

9、he riskidentified in the baseline health-based risk assessment to a levelconsistent with Applicable and Relevant or Appropriate Re-quirement (ARAR) values.3.1.10 hazardous substance, nany material identified bythe Environmental Protection Agency (EPA) in 40 CFR 262.3.1.11 restricted use, norganizati

10、onal control is main-tained over a property through physical barricades, signs andnotices, or deed covenants that limit the full use of the propertyby an owner or prospective owner.3.1.12 unrestricted use, ncontrol over the property is fullyreleased for any use desired by the owner.4. Summary of Gui

11、de4.1 Nuclear facilities must have established plans for moni-toring the environment surrounding the site as part of theirlicense or technical specifications. These plans are designed toidentify any release of radioactive or hazardous material and toassess the resulting impacts. Similar plans are re

12、quired duringdecommissioning or site remediations to continue environmen-tal monitoring, although the types of discharges and theaffected pathways may be different from those monitoredduring facility operations.4.2 In addition, limited environmental surveillance mayhave been performed since the faci

13、lity operated. The existingenvironmental monitoring plans should be modified for decom-missioning and reflect the current environment, potential re-lease points, and affected pathways. If no environmentalmonitoring plan exists, one must be developed.4.3 The decommissioning environmental monitoring p

14、lanmust be consistent and complete to ensure the detection andmitigation of off-site impacts caused by radioactive or hazard-ous materials released from decommissioning activities atnuclear facilities.5. Significance and Use5.1 Use of this guide will ensure that the potential impact onthe surroundin

15、g environment from planned decommissioningactivities has been properly assessed.5.2 Use of this guide will ensure that the adequacy ofenvironmental sampling has been assessed for location, fre-quency, analytical techniques, and media type to monitor theenvironment and to detect site-related releases

16、 and theirimpact.6. Organizational Interfaces6.1 The environmental monitoring plan should coordinatewith other decommissioning documents. Guide E1281 recom-mends that certain planning documents and implementationplans will be prepared prior to commencement of dismantle-ment actions. This guide ensur

17、es that the basic environmentalmonitoring planning elements and requirements are identified,examined, and addressed to accomplish the decommissioningactivities. Other project plans and reports guide the operationsand organization for the decommissioning project.6.1.1 Planning and implementation docu

18、ments define theactivities around which the site environmental monitoringprogram will be developed. Documents that should be re-viewed include the following:6.1.1.1 Site Description and Operating History Reports,6.1.1.2 Site Characterization Report,6.1.1.3 Health Based Baseline Risk Assessment,6.1.1

19、.4 Planned Decommissioning Activities Document,6.1.1.5 Licensing and Regulatory Issues Document,6.1.1.6 Quality Assurance Document, and6.1.1.7 Radiation Protection Document.6.1.1.8 Appendix X1 contains brief overviews of thesedocuments, as they contribute to the environmental plan.7. Elements of an

20、Environmental Monitoring Plan7.1 Site environmental monitoring shall comply with awritten plan. This plan must both direct the performance ofmonitoring and inform concerned individuals as to the intentand methodologies used in monitoring the environment. Theplan must clearly define the scope of work

21、 activities, that is,describe the site, area, or room to be decommissioned. Guid-ance on the content and structure of the plan is outlined in7.2-7.10.12. Additional guidance relative to the requirementsfor monitoring of environmental pollutants at facilities beingdecommissioned can be found in such

22、references as , 40 CFR61, and 40 CFR 58. These cover such topics as notification ofthe release of hazardous materials, emission standards for airpollutants, and air monitoring of these materials.7.2 Introduction and ObjectivesThe introduction shouldaddress the history of actions leading to decommiss

23、ioning,E1819 102identify the organizations involved, describe the decommis-sioning process and required documentation, define the objec-tive or purpose of the environmental monitoring program, anddescribe the intended use of the monitoring data.7.2.1 Monitoring ObjectivesBasic objectives should in-c

24、lude the following, as a minimum:7.2.1.1 Assess the actual or potential doses to man fromcontaminants released to the environment as a result ofdecontamination efforts,7.2.1.2 Demonstrate compliance with applicable environ-mental regulations during decommissioning and with estab-lished release crite

25、ria. Chapter 4 of The DecommissioningHandbook7provides an excellent summary of the variousenvironmental regulations that apply to decommissioningwork,7.2.1.3 Evaluate the adequacy and effectiveness of thecontainment and effluent control system during decontamina-tion.7.2.2 Calibration and Measuremen

26、t System Performance:7.2.2.1 Provisions must be made when planning environ-mental monitoring activities at decommissioning sites to en-sure that all data are obtained using instruments and instru-mentation systems capable of producing accurate and validdata. This requires the use of instruments and

27、equipmenthaving valid and current calibration certificates. It also meansthat careful consideration should be given to the appropriateuse of spiked samples, blanks, and split samples as qualityassurance principles are incorporated into the environmentalmonitoring program.7.2.3 Data Quality Objective

28、sThe DQOs impact statisti-cal sampling design, sampling techniques, analytical proce-dures, and documentation procedures. The elements for adecommissioning monitoring plan will be prepared with con-cern for the DQO process. Technical monitoring objectives willbe established to support the data quali

29、ty objectives in themonitoring plan. The objectives will be specified in terms ofprecision, accuracy, representativeness, completeness, compa-rability, and detection limit. For further information on DQOs,see Ref (1).87.3 Background Information:7.3.1 LocationThe plan should specify the location andd

30、escribe the site and surrounding area.7.3.2 Source of Contaminants and Transport PathwaysThe source term from the site characterization data should becomplete enough to identify the types of radionuclides andhazardous materials on site, their quantities, and the physicalconditions in which they are

31、found. The plan should specify thechemical composition and condition of the material, extent ofcontamination, and whether the material is in soil or ground-water, or on buildings and equipment surfaces.7.3.3 Information SourcesSources of information on thesite should be identified, searched for pert

32、inent information,and summarized, including previous sampling, facility wasteplans, environmental characterizations, radiation surveys, andlocal sampling problems.7.3.4 Impact DataAvailable environmental impact datashould be summarized.7.3.5 Background Evaluation Requirements:7.3.5.1 Requirements go

33、verning the decommissioning ac-tivities and release of the site may be based on levels abovebackground; therefore, careful evaluation of background con-ditions at the decommissioning site should be considered whenplanning the environmental monitoring program.7.4 Evaluation of Existing Data:7.4.1 Sou

34、rce Term ExaminationOnce all contaminantspresent at the site are identified, those contaminants thatpotentially could be released to the environment during decom-missioning should be identified specifically and included in thetransport model, as discussed in 7.4.2.7.4.2 Pathways Modeling for Monitor

35、ing System DesignThe decommissioning activities specified in the decommis-sioning plan should be reviewed to identify activities that couldrelease hazardous materials to the off-site environment. Theenvironmental transport pathways will then be identified,including critical environmental components

36、and receptors.Using the strength of the source and the model, the mostsignificant pathways and receptors will be identified for eachcontaminant.7.4.2.1 The pathways model (conceptual or mathematical)for transport of material to the environment should establishthe critical population and the most pro

37、bable locations foraccumulation of radioactivity or hazardous material. Pathwayswith potentially high accumulation rates should be selected forsampling to provide a means of detecting releases at the earliestopportunity. Likewise, exposure pathways to humans definedin the site release criteria (that

38、 is, milk, fish, and groundwaterconsumption, and dust ingestion and inhalation) should bespecifically considered for sampling. These pathways to hu-mans provide a means of comparing site releases and resultantenvironmental levels with calculated doses to individuals. Themodel must consider the trans

39、port of each contaminant sepa-rately, since their sources and environmental fates may bedifferent.7.5 Sampling and Analytical Design:7.5.1 Statistical DesignA variety of statistical monitoringdesigns are available to meet monitoring objectives, includingstratified, systematic, and random with grab o

40、r compositesampling. The statistical design chosen must account for thesource of statistical variability in the samples, such as space,time, sampling procedures, sample handling, sample process-ing including subsampling, sample extraction, and analyticalmeasurements. The parameters include several s

41、ources ofstatistical error. The development of data quality objectivesrequires consideration of these sources of error, an estimate oftheir magnitude, and, if necessary, a review of methods toreduce the overall variability in a cost-effective manner. Forfurther information on statistical sampling de

42、sign and datainterpretation, see Refs (2) and (3). In addition, the Multi-Agency Radiation Survey and Site Investigation Manual7Taboas, A. L., Moghissi, A. A., and LaGuardia, T. S., Eds., The Decommis-sioning Handbook, Chapter 4, Environmental and Related Requirements, ASME,Three Park Ave., New York

43、, NY, 2004.8The boldface numbers in parentheses refer to a list of references at the end ofthis guide.E1819 103(MARSSIM) provides excellent guidance on sampling designfor these projects. See NUREG CR-2082 for additional guid-ance.7.5.2 Initial Baseline ConditionsThe site description andoperating his

44、tory should be reviewed to identify any previousenvironmental sampling plans and the resultant data. Alllicensed sites and sites operated by the government shouldhave a documented baseline prior to the initial start ofoperations. These data should be reviewed, and those samplepoints used to establis

45、h the previous background should betrended through subsequent environmental reports to updatethe background value of these locations before decommission-ing operations begin. This documentation should be supportedby new samples taken from the original baseline samplinglocations and new locations for

46、 pathways resulting fromdecommissioning activities. The long-term sampling datashould depict the status of the environment at the start ofdecommissioning operations.7.5.2.1 If the existing documentation or current samplingindicates that contamination has been deposited off-site, thequantity and loca

47、tion of this material must be characterized.Contaminants existing in the environment before decommis-sioning may be transported as a plume or slug and could resultin increasing environmental levels. Without adequate data, theincrease could be attributed incorrectly to decommissioningactivities.7.5.2

48、.2 Sites with no previous environmental monitoringprogram should establish a baseline. Many state environmentalor radiation protection programs maintain environmental sam-pling locations that can provide baseline information fornormal air activity, radon levels, external beta/gamma radiationvalues,

49、or trace element levels in ambient air. The baselinesampling activity should account for fluctuations in data takenby other programs, such as radon emanation rates and airactivity levels.7.5.3 Sampling RationaleSelect the media to sample ac-cording to the results of pathways modeling (see 7.3.2). Thosepathways deemed significant for their possible dose to thepublic or release to the environment (both accidental andplanned) should be monitored. For decontamination activities,the most important pathways to the off-site environment aretypically atmospheric and surface wa