ARMY MIL-DTL-15665 67-1996 DETAIL SPECIFICATION SHEET nINSIGNIA SERVICE HAT OFFICERS FEMALE ARMY《陆军女性军官陆军便帽徽章》.pdf

《ARMY MIL-DTL-15665 67-1996 DETAIL SPECIFICATION SHEET nINSIGNIA SERVICE HAT OFFICERS FEMALE ARMY《陆军女性军官陆军便帽徽章》.pdf》由会员分享，可在线阅读，更多相关《ARMY MIL-DTL-15665 67-1996 DETAIL SPECIFICATION SHEET nINSIGNIA SERVICE HAT OFFICERS FEMALE ARMY《陆军女性军官陆军便帽徽章》.pdf（2页珍藏版）》请在麦多课文档分享上搜索。

1、MIL-DTL-LSbbS/b7 9iOb 201b77 511 D I NOT MEASUREMENT SENSITIVE I MIL-DTL-15665/67 27 June 1996 SUPERSEDING 22 March 1996 MIL-DTL-3575/43H DETAIL SPECIFICATION SHEET INSIGNIA, SERVICE HAT, OFFICERS, FEMALE, ARMY This specification is approved for use by all Departments and Agencies of the Department

2、of Defense. The requirements for acquiring the product described herein shall consist of this specification sheet and the issue of MIL-DTL-15665 listed in that issue of the Department of Defense Index of Specifications and Standards (DoDISS) specified in the solicitation. PIERCED PIERCED MATERIAL: R

3、ed Brass FINISH: Gold Plated, Matte Finish, Polished Highlights and shall match TIOH Metal Finish Chip Number 8. DIMENSIONS : HEIGHT (Overall) : 1-5/8 inch (4.13 cm) (REF) WIDTH (Overall) : 1-1/2 inch (3.81 cm) (REF) THICKNESS (At Wing Tip and Tail Feather Tips): 0.047 inch + 0.016 inch - O (0.119 c

4、m + 0.04 cm -0) AMSC N/A FSC 8455 NT A. Approved for public release; distribution is unlimited. 1 of 2 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-DTL-L5bb5/b7 m 9Ob 20Lb78 458 m MIL-DTL-15665/67 NOTES : furnished hub or die. 1. The term (REF

5、) refers to measurements taken from the Government 2. Pierced areas shall be as indicated 3. A forcer may be used to bring up the design provided the use of the forcer does not result in a thickness through the shield of less than 0.060 inch 0.152 cm). 4. Attaching device shall be prong and clutch t

6、ype as indicated. 5. Insignia shall be dapped in the horizontal direction along a 4 inch f 1/64 inch (10.16 cm f 0.04 cm) radius. 6. Reverse and edges shall be clean. 7. Insignia may be manufactured for commercial sale only using 22 karat gold plate with nickel underplating, matte finish, polished h

7、ighlights which shall match TIOH Metal Finish Chip Number 11. CHANGES FROM PREVIOUS ISSUE: Marginal notations are not used in this revision to identify changes with respect to the previous issue due to the extent of the changes. Custodian: Army - IH Review activities: DLA - CT Preparing activity: Army - IH (Project No. 8455-0844) 2 of 2 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-