AIR FORCE A-A-50766-1984 BUS MOTOR 16 PASSENGER《16座汽车巴士》.pdf

《AIR FORCE A-A-50766-1984 BUS MOTOR 16 PASSENGER《16座汽车巴士》.pdf》由会员分享，可在线阅读，更多相关《AIR FORCE A-A-50766-1984 BUS MOTOR 16 PASSENGER《16座汽车巴士》.pdf（5页珍藏版）》请在麦多课文档分享上搜索。

1、A-A-507bb 23 7777774 0033377 5 c-3-10 A-A 50766 12 Mar 84 BUS, MOTOR, 16 PASSENGER The General Services Administration has authorized the use of this commercial item description. Scope This Commercial Item Description (CID) describes a diesel powered, surrey-type bus for transporting passengers and

2、their luggage on short-haul operations on base, and trips off base such as to and from airports. ADDicabe documents The following documents, of the issue in effect on date of invitation for bids or request for proposal, form a part of this commercial item description to the extent specified herein:

3、Standards Military MIL-STD-1178 - Standard Safety Devices for Administrative Automotive Vehicles Other publications. item description. invitation for bids or request for proposal shall apply. The following documents form a part of this commercial Unless otherwise indicated, the issue in effect on da

4、te of DEPARTMENT OF TRANSPORTATION (DOT) Compliance with Interstate Motor Carrier Noise Emission Standards. Federal Motor Carrier Safety Regulations. Federal Motor Vehicle Safety Standards. ENVIRONMENTAL PROTECTION AGENCY (EPA) Control of Air Pollution from New Motor Vehicles and New Motor Vehicle E

5、ngines. (Application for copies should reference the Code of Federal Regulations, 40 CFR, and the Federal Register and should be addressed to the Superintendent of Documents, U.S. Government Printing Office, Washington, D.C. 20402.) SAE, INC. SAE Standards and Recommended Practices. 5381 -Windshield

6、 Defrosting Systems Test Procedure - Trucks, Buses, and Multipurpose Vehicles. 5382 -Windshield Defrosting Systems Performance Requirements - Trucks, Buses, and Multipurpose Vehicles. 5551 -Limits and Methods of Measurement of Radio Interference Characteristics of Vehicles and Devices (20-1000 MHz).

7、 5552 External Electromagnetic Radiation Suppressors. 5588 -Turn Signal Lamps. FSC 2310 y- THIS DOCUMENT CONTAINS 5 PAGES. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-A-A-50766 23 9977774 l3178- 7 W A-A- 50766 5589 5816 51349 -Turn Signal Switch.

8、 -Engine Test Code - Spark Ignition and Diesel. -Engine Rating Code - Spark Ignition and Diesel. (SAE Standards and Recommended Practices are available from SM, Inc., 400 Commonwealth Drive, Warrendale, PA 15096.) (Technical society and technical association specifications and standards are generall

9、y available for reference from libraries. distributed among technical groups and using Federal Agencies.) They are also Salient characteristics. comfortable, economical and highly maneuverable with a no-stoop entry for passenger and carry-on luggage. Vehicle must be procureable as an “off-the-shelf“

10、, commercially produced, readily available item (as evidenced by the manufacturers brochure). documents or their respective commercial counterparts. The vehicle described by this CID is roomy, Vehicle must comply with listed applicable 1. Roomy. Seating configuration must be perimeter type in order

11、to provide maximum passenger comfort. provided. Passenger compartment width to be not less than 93 inches with head room at interior aisle to be not less than 74 inches. minimum dimensions for the required 16 adult capacity. An interior luggage storage rack shall be (Above are considered 2. Economic

12、al. taking into account the passenger miles traveled at normal speeds (approximatedly 35 miles per hour on base; and 55 mph off base). The engine furnished must allow for maximum fuel economy when 3. wheel base chassis, or 24.0 ft with 125 inch chassis. Maneuverability. The turning radius must not e

13、xceed 29.0 ft with 157 inch 4. Passenger Comfort and Safety. a. Seating must provide maximum passenger comfort within state of the art seating construction for perimeter seating. b. Heating and air conditioning (for both driver and passenger compartments) will be provided. C. Windows. Rear windows t

14、o be provided with AS-2 clear tempered safety sheet glass. Side window to be furnished meeting escape opening, performance, and operational requirements of Federal Motor Vehicle Safety Standard 217. (Emergency operation decals are to be included). d. Passenger compartment shall meet DOI noise emmiss

15、ion standards. e. Driver and passenger compartments shall meet the requirements of the Federal Motor Vehicle standards and regulations as listed above. 5. to entrance header with clear entrance width not less than 28 inches. Passenger entry door to be at least 73 inches high from top 0f first step 2

16、 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-A-A- 50766 Door(s) to be readily accessable to, and operated by, the driver. Door to have “saf-latch“ type handle to prevent accidental opening. 6. Floor. The floor is to be covered with exterior plywo

17、od (BC) at least 112 inch thick with sealed edges. Stepwell, entrance area and center aisle floor to be overlayed with 3/16 ribbed rubber. Wheelhouse end underseating areas to be covered with 118 inch, smooth anti-skid rubber. trim to be installed so as to provide maximum ease in cleaning. Floor cov

18、ering moulding and 7. thick, mounted to chassis frame with double A-frame bracing at each corner to resist blows from both side and rear. manufacturer. Bumpers. Rear bumper to be a minimum 8 inch die-formed, 3/16 (minimum) Front bumpers to be supplied by chassis 8. Mirror. An interior mirror 5“ x 16

19、“ minimum shall be provided to enable driver to view the passengers. rounded corners and protected edges. Mirror to be backed with metal and framed with 9. Drivers seat to be of high back design, bucket type equipped with retractable seat/shoulder belt. 10. Heating. manual controls to permit outside

20、 air recirculated air, or variable mixtures as desired (to circulate through at least the main heater core), to provide and maintain comfortable temperatures to drivers and passenger compartments, so that no objectionable flow is directed toward any passenger. Heater hoses shall be shielded from the

21、 passenger compartment and located in protected positions. assure passenger comfort. A hot water heating system shall be installed with adjustable Auxiliary recirculating heater(s) shall be provided if required to 11. Air conditioning. a. Drivers forward area air conditioning shall be supplied by Ch

22、assis manufacturer. Capacity to be approximately 14,000 BTU/hr. b. Passenger compartment air conditioning shall be provided by the manufacturer to assure a minimum cooling capacity of 40,000 BTU/hr total for passenger compartment and drivers area combined. passenger compartment and equipped with out

23、lets with shut off provisions to enable individual passenger controls. Cooling air to be ducted to 12. Wiring. and all body circuits are to be protected by resetting circuit breakers. Electrical controls shall be mounted above drivers line of vision and be illuminated. All body wiring shall be color

24、 coded and routed inside the body; 13. Chassis. a. Wheelbase to be 125 inch minimum. b. Unless otherwise specified, engine to be compression ignition two stroke or four-stroke cycle diesel, with not less than four cylinders. 3 Provided by IHSNot for ResaleNo reproduction or networking permitted with

25、out license from IHS-,-,-I - .- _-_ .- A-A-507bb 23 W 7777774 OOL3200 L A-A- 50766 Engine net horsepower used in performance prediction calculations shall be determined in accordance with SAE 5816. and 51349. A fan clutch to reduce fan speed automatically, when not required for engine cooling, shall

26、 be provided. c. Automatic transmission. A continuous drive, automatic transmission shall be provided. and not less than three forward and one reverse gears. select or position shall provide not less than three forward gear ratios without movement of the selector. The transmission shall include a hy

27、draulic torque converter Normal driving range 14. Needle type gauges. follows will be installed so as to be easily monitored by the driver: Gauges (lights in lieu of gauges not acceptable) as a. Voltmeter. b. Oil pressure gauge. C. Water temperature gauge. d, Fuel quantity gauge. 15. Wipers. supplie

28、d by the chassis manufacturers. Two speed electric windshield wipers and dual jet washers will be 16. Windshield Defroster. Defroster outlets with suitable connections and blower(s) shall be furnished to provide an adequate flow of air to both halves of the windshield, The windshield defrosting syst

29、ems shall conform to SAE 5381 and SAE 3382. 17. Turn signals. Turn signal lamps shall be installed conforming to SAE 5588. Operating units shall conform to SAE 5589, class A, and shall be mounted on the steering column. signal units or single-faced front signal units in conjunction with armored, amb

30、er turn signals over the front wheelwells, and with single-faced rear signal units. Signal units shall be installed in accordance with SAE 5588, except that turn signals shall not be mounted on the engine compartment hood. Operating units shall be provided with a visible and audible flash indicator.

31、 Turn signals shall be of the self-cancelling type. Vehicle shall be provided with double-faced front 18. A warranty for 12,000 miles, or one year minimum on chassis and one year body construction and add-on components shall be provided. Warranty period shall start the date the vehicle is placed int

32、o operation by the purchaser. Certification. The contractor shall certify that the product offered meets the salient characteristics of this description, and that the product conforms to the producers own drawings, specifications, standards, and quality assurance practices and is the same product of

33、fered for sale in the commercial marketplace. The government reserves the right to required proof of such conformance prior to first delivery and thereafter as may be otherwise provided for under the provisions of the contract. 4 Provided by IHSNot for ResaleNo reproduction or networking permitted w

34、ithout license from IHS-,-,-r A-A-507bb 23 m 777777q 0033203 3 m A-A- 50766 Packaging: Packing and marking. Preparation for shipment will be per manufacturers standard commercial practice. Custodians: Air Force - 99 Army - AT Navy - YD PREPARING ACTIVITY: Air Force - 84 (Project: 2310-F430) FSC 2310 5 U.C. GOVERNMENT PRINTING OFFICE 1984-705-040/A1747 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-