IEEE 386-2016 en Separable Insulated Connector Systems for Power Distribution Systems Rated 2 5 kV through 35 kV《额定2 5千伏至35千伏配电系统用可分离绝缘连接器系统》.pdf

《IEEE 386-2016 en Separable Insulated Connector Systems for Power Distribution Systems Rated 2 5 kV through 35 kV《额定2 5千伏至35千伏配电系统用可分离绝缘连接器系统》.pdf》由会员分享，可在线阅读，更多相关《IEEE 386-2016 en Separable Insulated Connector Systems for Power Distribution Systems Rated 2 5 kV through 35 kV《额定2 5千伏至35千伏配电系统用可分离绝缘连接器系统》.pdf（81页珍藏版）》请在麦多课文档分享上搜索。

1、IEEE Standard for Separable Insulated Connector Systems for Power Distribution Systems Rated 2.5 kV through 35 kV IEEE Std 386-2016 (Revision of IEEE Std 386-2006) IEEE Power and Energy Society Sponsored by the Insulated Conductors Committee IEEE 3 Park Avenue New York, NY 10016-5997 USAIEEE Std 386

2、-2016 (Revision of IEEE Std 386-2006) IEEE Standard for Separable Insulated Connector Systems for Power Distribution Systems Rated 2.5 kV through 35 kV Sponsor Insulated Conductors Committee of the IEEE Power and Energy Society Approved 30 June 2016 IEEE-SA Standards BoardAbstract: Keywords: IEEE pr

3、ohibits discrimination, harassment, and bullying. For more information, visit http:/www.ieee.org/web/aboutus/whatis/policies/p9-26.html. No part of this publication may be reproduced in any form, in an electronic retrieval system or otherwise, without the prior written permission of the publisher.3

4、Important Notices and Disclaimers Concerning IEEE Standards Documents IEEE documents are made available for use subject to important notices and legal disclaimers. These notices and disclaimers, or a reference to this page, appear in all standards and may be found under the heading “Im- portant Noti

5、ce” or “Important Notices and Disclaimers Concerning IEEE Standards Documents.” Notice and Disclaimer of Liability Concerning the Use of IEEE Standards Documents IEEE Standards documents (standards, recommended practices, and guides), both full-use and trial-use, are developed within IEEE Societies

6、and the Standards Coordinating Committees of the IEEE Standards Asso- ciation (“IEEE-SA”) Standards Board. IEEE (“the Institute”) develops its standards through a consensus de- velopment process, approved by the American National Standards Institute (“ANSI”), which brings together - sarily members o

7、f the Institute and participate without compensation from IEEE. While IEEE administers the process and establishes rules to promote fairness in the consensus development process, IEEE does not inde- pendently evaluate, test, or verify the accuracy of any of the information or the soundness of any ju

8、dgments contained in its standards. IEEE does not warrant or represent the accuracy or content of the material contained in its standards, and expressly disclaims all warranties (express, implied and statutory) not included in this or any other document purpose; non-infringement; and quality, accura

9、cy, effectiveness, currency, or completeness of material. In addition, IEEE disclaims any and all conditions relating to: results; and workmanlike effort. IEEE standards documents are supplied “AS IS” and “WITH ALL FAULTS.” Use of an IEEE standard is wholly voluntary. The existence of an IEEE standa

10、rd does not imply that there are no other ways to produce, test, measure, purchase, market, or provide other goods and services related to the scope of the IEEE standard. Furthermore, the viewpoint expressed at the time a standard is approved and issued is subject to change brought about through dev

11、elopments in the state of the art and comments received from users of the standard. In publishing and making its standards available, IEEE is not suggesting or rendering professional or other services for, or on behalf of, any person or entity nor is IEEE undertaking to perform any duty owed by any

12、other person or entity to another. Any person utilizing any IEEE Standards document, should rely upon his or her own independent judgment in the exercise of reasonable care in any given circumstances or, as appropri- ate, seek the advice of a competent professional in determining the appropriateness

13、 of a given IEEE standard. - - Translations The IEEE consensus development process involves the review of documents in English only. In the event that an IEEE standard is translated, only the English version published by IEEE should be considered the approved IEEE standard.4 A statement, written or

14、oral, that is not processed in accordance with the IEEE-SA Standards Board Operations not be considered to be, or be relied upon as, a formal position of IEEE. At lectures, symposia, seminars, or educational courses, an individual presenting information on IEEE standards shall make it clear that his

15、 or her views should be considered the personal views of that individual rather than the formal position of IEEE. Comments on standards Comments for revision of IEEE Standards documents are welcome from any interested party, regardless of - ing to IEEE Standards documents. Suggestions for changes in

16、 documents should be in the form of a proposed change of text, together with appropriate supporting comments. Since IEEE standards represent a consensus of concerned interests, it is important that any responses to comments and questions also receive the concur- rence of a balance of interests. For

17、this reason, IEEE and the members of its societies and Standards Coordi- nating Committees are not able to provide an instant response to comments or questions except in those cases where the matter has previously been addressed. For the same reason, IEEE does not respond to interpretation requests.

18、 Any person who would like to participate in revisions to an IEEE standard is welcome to join the relevant IEEE working group. Comments on standards should be submitted to the following address: Secretary, IEEE-SA Standards Board 445 Hoes Lane Laws and regulations Users of IEEE Standards documents s

19、hould consult all applicable laws and regulations. Compliance with the provisions of any IEEE Standards document does not imply compliance to any applicable regulatory require- ments. Implementers of the standard are responsible for observing or referring to the applicable regulatory requirements. I

20、EEE does not, by the publication of its standards, intend to urge action that is not in compliance with applicable laws, and these documents may not be construed as doing so Copyrights IEEE draft and approved standards are copyrighted by IEEE under US and international copyright laws. They are made

21、available by IEEE and are adopted for a wide variety of both public and private uses. These include both use, by reference, in laws and regulations, and use in private self-regulation, standardization, and the pro- motion of engineering practices and methods. By making these documents available for

22、use and adoption by public authorities and private users, IEEE does not waive any rights in copyright to the documents. Photocopies Subject to payment of the appropriate fee, IEEE will grant users a limited, non-exclusive license to photocopy portions of any individual standard for company or organi

23、zational internal use or individual, non-commercial use only. To arrange for payment of licensing fees, please contact Copyright Clearance Center, Customer Ser- any individual standard for educational classroom use can also be obtained through the Copyright Clearance Center.5 Updating of IEEE Standa

24、rds documents Users of IEEE Standards documents should be aware that these documents may be superseded at any time by the issuance of new editions or may be amended from time to time through the issuance of amendments, corri- together with any amendments, corrigenda, or errata then in effect. and ha

25、s not undergone a revision process, it is reasonable to conclude that its contents, although still of some the latest edition of any IEEE standard. In order to determine whether a given document is the current edition and whether it has been amended through the issuance of amendments, corrigenda, or

26、 errata, visit the IEEE-SA Website at http:/www.ieee.org/publica- tions_standards/index.html or contact IEEE at the address listed previously. For more information about the IEEE-SA or IEEEs standards development process, visit the IEEE-SA Website at http:/standards.ieee.org. Errata http:/ Patents A

27、ttention is called to the possibility that implementation of this standard may require use of subject matter covered by patent rights. By publication of this standard, no position is taken by the IEEE with respect to the existence or validity of any patent rights in connection therewith. If a patent

28、 holder or patent applicant has SA Website at http:/standards.ieee.org/about/sasb/patcom/patents.html. Letters of Assurance may indicate whether the Submitter is willing or unwilling to grant licenses under patent rights without compensation or under reasonable rates, with reasonable terms and conditions that are demonstrably free of any unfair discrim- ination to applicants desiring to obtain such licenses. -