IEEE 1668-2017 en Recommended Practice for Voltage Sag and Short Interruption Ride- Through Testing for End-Use Electrical Equipment Rated Less than 1000 V.pdf

《IEEE 1668-2017 en Recommended Practice for Voltage Sag and Short Interruption Ride- Through Testing for End-Use Electrical Equipment Rated Less than 1000 V.pdf》由会员分享，可在线阅读，更多相关《IEEE 1668-2017 en Recommended Practice for Voltage Sag and Short Interruption Ride- Through Testing for End-Use Electrical Equipment Rated Less than 1000 V.pdf（85页珍藏版）》请在麦多课文档分享上搜索。

1、IEEE Recommended Practice for Voltage Sag and Short Interruption Ride- Through Testing for End-Use Electrical Equipment Rated Less than 1000 V IEEE Std 1668-2017 (Revision of IEEE Std 1668-2014) IEEE Industry Applications Society Sponsored by the Power Systems Engineering Committee IEEE 3 Park Avenu

2、e New York, NY 10016-5997 USAIEEE Std 1668-2017 (Revision of IEEE Std 1668-2014) IEEE Recommended Practice for Voltage Sag and Short Interruption Ride- Through Testing for End-Use Electrical Equipment Rated Less than 1000 V Sponsor Power Systems Engineering Committee of the IEEE Industry Application

3、s Society Approved 14 June 2017 IEEE-SA Standards BoardAbstract: A non-industry-specific recommended practice for voltage sag and short interruption ride- through performance and compliance testing for all electrical and electronic equipment connected to low-voltage power systems that can experience

4、 malfunction or shutdown as a result of reductions in supply voltage lasting less than one minute is detailed in this document. Testing procedures and requirements for test equipment are clearly defined within this document to reflect this electrical environment, including single-phase, two-phase, a

5、nd three-phase balanced and unbalanced voltage sags. Requirements for certification and test reporting, including characterization of voltage- sag ride-through equipment are also defined. Keywords: equipment testing, IEEE 1668, immunity, power quality, ride-through, voltage dip, voltage sag, voltage

6、-sag characteristics The Institute of Electrical and Electronics Engineers, Inc. 3 Park Avenue, New York, NY 10016-5997, USA Copyright 2017 by The Institute of Electrical and Electronics Engineers, Inc. All rights reserved. Published 27 November 2017. Printed in the United States of America. IEEE is

7、 a registered trademark in the U.S. Patent fitness for a particular purpose; non-infringement; and quality, accuracy, effectiveness, currency, or completeness of material. In addition, IEEE disclaims any and all conditions relating to: results; and workmanlike effort. IEEE standards documents are su

8、pplied “AS IS” and “WITH ALL FAULTS.” Use of an IEEE standard is wholly voluntary. The existence of an IEEE standard does not imply that there are no other ways to produce, test, measure, purchase, market, or provide other goods and services related to the scope of the IEEE standard. Furthermore, th

9、e viewpoint expressed at the time a standard is approved and issued is subject to change brought about through developments in the state of the art and comments received from users of the standard. In publishing and making its standards available, IEEE is not suggesting or rendering professional or

10、other services for, or on behalf of, any person or entity nor is IEEE undertaking to perform any duty owed by any other person or entity to another. Any person utilizing any IEEE Standards document, should rely upon his or her own independent judgment in the exercise of reasonable care in any given

11、circumstances or, as appropriate, seek the advice of a competent professional in determining the appropriateness of a given IEEE standard. IN NO EVENT SHALL IEEE BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO: PROCUREMENT O

12、F SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE PUBLICATION, USE OF, OR RELIANCE UPON ANY STANDARD,

13、 EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE AND REGARDLESS OF WHETHER SUCH DAMAGE W AS FORESEEABLE.4 Copyright 2017 IEEE. All rights reserved. Translations The IEEE consensus development process involves the review of documents in English only. In the event that an IEEE standard is translated

14、, only the English version published by IEEE should be considered the approved IEEE standard. Official statements A statement, written or oral, that is not processed in accordance with the IEEE-SA Standards Board Operations Manual shall not be considered or inferred to be the official position of IE

15、EE or any of its committees and shall not be considered to be, or be relied upon as, a formal position of IEEE. At lectures, symposia, seminars, or educational courses, an individual presenting information on IEEE standards shall make it clear that his or her views should be considered the personal

16、views of that individual rather than the formal position of IEEE. Comments on standards Comments for revision of IEEE Standards documents are welcome from any interested party, regardless of membership affiliation with IEEE. However, IEEE does not provide consulting information or advice pertaining

17、to IEEE Standards documents. Suggestions for changes in documents should be in the form of a proposed change of text, together with appropriate supporting comments. Since IEEE standards represent a consensus of concerned interests, it is important that any responses to comments and questions also re

18、ceive the concurrence of a balance of interests. For this reason, IEEE and the members of its societies and Standards Coordinating Committees are not able to provide an instant response to comments or questions except in those cases where the matter has previously been addressed. For the same reason

19、, IEEE does not respond to interpretation requests. Any person who would like to participate in revisions to an IEEE standard is welcome to join the relevant IEEE working group. Comments on standards should be submitted to the following address: Secretary, IEEE-SA Standards Board 445 Hoes Lane Pisca

20、taway, NJ 08854 USA Laws and regulations Users of IEEE Standards documents should consult all applicable laws and regulations. Compliance with the provisions of any IEEE Standards document does not imply compliance to any applicable regulatory requirements. Implementers of the standard are responsib

21、le for observing or referring to the applicable regulatory requirements. IEEE does not, by the publication of its standards, intend to urge action that is not in compliance with applicable laws, and these documents may not be construed as doing so. Copyrights IEEE draft and approved standards are co

22、pyrighted by IEEE under US and international copyright laws. They are made available by IEEE and are adopted for a wide variety of both public and private uses. These include both use, by reference, in laws and regulations, and use in private self-regulation, standardization, and the promotion of en

23、gineering practices and methods. By making these documents available for use and adoption by public authorities and private users, IEEE does not waive any rights in copyright to the documents.5 Copyright 2017 IEEE. All rights reserved. Photocopies Subject to payment of the appropriate fee, IEEE will

24、 grant users a limited, non-exclusive license to photocopy portions of any individual standard for company or organizational internal use or individual, non-commercial use only. To arrange for payment of licensing fees, please contact Copyright Clearance Center, Customer Service, 222 Rosewood Drive,

25、 Danvers, MA 01923 USA; +1 978 750 8400. Permission to photocopy portions of any individual standard for educational classroom use can also be obtained through the Copyright Clearance Center. Updating of IEEE Standards documents Users of IEEE Standards documents should be aware that these documents

26、may be superseded at any time by the issuance of new editions or may be amended from time to time through the issuance of amendments, corrigenda, or errata. An official IEEE document at any point in time consists of the current edition of the document together with any amendments, corrigenda, or err

27、ata then in effect. Every IEEE standard is subjected to review at least every 10 years. When a document is more than 10 years old and has not undergone a revision process, it is reasonable to conclude that its contents, although still of some value, do not wholly reflect the present state of the art

28、. Users are cautioned to check to determine that they have the latest edition of any IEEE standard. In order to determine whether a given document is the current edition and whether it has been amended through the issuance of amendments, corrigenda, or errata, visit the IEEE Xplore at http:/ ieeexpl

29、ore .ieee .or g/ or contact IEEE at the address listed previously. For more information about the IEEE-SA or IEEEs standards development process, visit the IEEE-SA Website at http:/ standards .ieee .or g. Errata Errata, if any, for all IEEE standards can be accessed on the IEEE-SA Website at the fol

30、lowing URL: http:/ standards .ieee .org/ findstds/ errata/ index .html. Users are encouraged to check this URL for errata periodically. Patents Attention is called to the possibility that implementation of this standard may require use of subject matter covered by patent rights. By publication of th

31、is standard, no position is taken by the IEEE with respect to the existence or validity of any patent rights in connection therewith. If a patent holder or patent applicant has filed a statement of assurance via an Accepted Letter of Assurance, then the statement is listed on the IEEE- SA Website at

32、 http:/ standards .ieee .or g/ about/ sasb/ patcom/ patents .html. Letters of Assurance may indicate whether the Submitter is willing or unwilling to grant licenses under patent rights without compensation or under reasonable rates, with reasonable terms and conditions that are demonstrably free of

33、any unfair discrimination to applicants desiring to obtain such licenses. Essential Patent Claims may exist for which a Letter of Assurance has not been received. The IEEE is not responsible for identifying Essential Patent Claims for which a license may be required, for conducting inquiries into th

34、e legal validity or scope of Patents Claims, or determining whether any licensing terms or conditions provided in connection with submission of a Letter of Assurance, if any, or in any licensing agreements are reasonable or non-discriminatory. Users of this standard are expressly advised that determ

35、ination of the validity of any patent rights, and the risk of infringement of such rights, is entirely their own responsibility. Further information may be obtained from the IEEE Standards Association.6 Copyright 2017 IEEE. All rights reserved. Participants At the time this IEEE recommended practice

36、 was completed, the V oltage Sag Ride-through Working Group had the following membership: Doug Dorr, Chair Scott Anderson, Vice Chair Y ves Allard William Brumsickle Math Bollen Jack Caufield John Coffman Sasa Djokic Brian Fortenbery Robert Gettier Gary Malhoit Brad Martin John Mentzer Mark Minzlaff

37、 Melinda Norris Gregory Olson Greg Rieder James Rossman Mark Rucker Salman Sabbah Mark Stephens Rick Temple Chuck Thomas Alden Wright John-Carl Zarella The following members of the individual balloting committee voted on this recommended practice. Balloters may have voted for approval, disapproval,

38、or abstention. Mihaela Albu Dwight Alexander Roy Alexander Mohammed Ashraf Ali Saleman Alibhay Curtis Ashton Thomas Barnes Frank Basciano Thomas Bishop William Bloethe Math Bollen Kenneth Bow Gustavo Brunello William Bush William Byrd Paul Cardinal Wen-Kung Chang Stephen Conrad Dieter Dohnal Gary Do

39、nner Douglas Dorr Neal Dowling Robert Durham Rostyslaw Fostiak Carl Fredericks Dale Frederickson Mietek Glinkowski Jalal Gohari Edwin Goodwin Stephen Grier Randall Groves Robert Hanna Lee Herron Werner Hoelzl Philip Hopkinson Richard Jackson Laszlo Kadar Yuri Khersonsky James Kinney Jim Kulchisky Mi

40、khail Lagoda Thomas La Rose Theo Laughner Albert Livshitz Walter McCannon Thomas McCarthy James Michalec C. Michael Miller William Moylan Jerry Murphy R. Murphy Bruce Muschlitz Michael Newman Joe Nims Gearold O. H. Eidhin Carl Orde Lorraine Padden Bansi Patel Christopher Petrola K. James Phillips Iu

41、lian Profir John Rama Charles Rogers James Rossman Thomas Rozek Don Russell Ryandi Ryandi Donald Sabin Steven Sano Bartien Sayogo Robert Schuerger Kenneth Sedziol Xu She Veselin Skendzic Jerry Smith Gary Smullin Wayne Stec Mark Stephens K. Stump David Tepen James V an De Ligt James V ergis William Walter Daniel Ward Kenneth White Jian Y u David Zech