FORD FLTM BV 151-3-2001 DETERMINATION OF FLOW PROPERTIES OF SPRAYED UNDERBODY COATINGS (Replaces FLTM EU-BV 051-03).pdf

《FORD FLTM BV 151-3-2001 DETERMINATION OF FLOW PROPERTIES OF SPRAYED UNDERBODY COATINGS (Replaces FLTM EU-BV 051-03).pdf》由会员分享，可在线阅读，更多相关《FORD FLTM BV 151-3-2001 DETERMINATION OF FLOW PROPERTIES OF SPRAYED UNDERBODY COATINGS (Replaces FLTM EU-BV 051-03).pdf（3页珍藏版）》请在麦多课文档分享上搜索。

1、 FORD LABORATORY TEST METHOD BV 151-03 Date Action Revisions 2001 03 28 Revised Editorial no technical change A. Cockman 1990 05 24 Printed copies are uncontrolled Page 1 of 3 Copyright 2000, Ford Global Technologies, Inc. DETERMINATION OF FLOW PROPERTIES OF SPRAYED UNDERBODY COATINGS Application Th

2、is method is used to determine the flow properties of underbody coatings applied by spraying. Apparatus Required Fixture See Figure 1. Mechanical Convection Oven Capable of maintaining a temperature of 105 +/- 2 C. Materials Required Test Panels Steel body skin panels; thickness approximately 0.85 m

3、m, surface finish 0.9 - 1.8 micrometre CLA, dimensions 300 x 300 mm; prepared according to the applicable Engineering Material Specification. Tape Pressure-sensitive paperbacked such as M-3G25A or U-MG003-8001 (Grade 01). Conditioning and Test Conditions All test values indicated herein are based on

4、 material conditioned in a controlled atmosphere of 23 +/- 2 C and 50 +/- 5 % relative humidity for not less than 24 h prior to testing and tested under the same conditions unless otherwise specified. Procedure 1. The closed container of underbody coating shall be conditioned for 24 h minimum at 23

5、+/- 2 C prior to application. 2. Apply tape strips on 2 prepared test panels at distance of 80 mm from the edge (refer to Figure 1). FORD LABORATORY TEST METHOD BV 151-03 Page 2 of 3 Copyright 2000, Ford Global Technologies, Inc. 3. Spray the test panels with the material under test to a wet film th

6、ickness as required in the applicable Engineering Material Specification. Place panels immediately in a vertical position on the fixture, then remove the tape from both panels. 4. a) Measure the maximum flow of material on 1st panel under test after 30 minutes at 23 +/- 2 C. b) Condition second pane

7、l for 15 minutes at 23 +/- 2 C, measure the maximum flow of the material, then place in the oven at 105 +/- 2 C for 15 minutes, and measure the maximum flow of material. Evaluation After removal of test specimen from the oven, measure the flow of sealer and express results in mm. Chemicals, material

8、s, parts, and equipment referenced in this document must be used and handled properly. Each party is responsible for determining proper use and handling in its facilities. FORD LABORATORY TEST METHOD BV 151-03 Page 3 of 3 Copyright 2000, Ford Global Technologies, Inc. DETERMINATION OF FLOW PROPERTIES OF SPRAYED UNDERBODY COATINGS Figure 1