DLA MIL-PRF-23419 4 H-2012 FUSES CARTRIDGE INSTRUMENT TYPE STYLE FM04 (NONINDICATING).pdf
《DLA MIL-PRF-23419 4 H-2012 FUSES CARTRIDGE INSTRUMENT TYPE STYLE FM04 (NONINDICATING).pdf》由会员分享,可在线阅读,更多相关《DLA MIL-PRF-23419 4 H-2012 FUSES CARTRIDGE INSTRUMENT TYPE STYLE FM04 (NONINDICATING).pdf(5页珍藏版)》请在麦多课文档分享上搜索。
1、AMSC N/A FSC 5920 INCH-POUND MIL-PRF-23419/4H 28 March 2012 SUPERSEDING MIL-PRF-23419/4G 21 June 2005 PERFORMANCE SPECIFICATION SHEET FUSES, CARTRIDGE, INSTRUMENT TYPE, STYLE FM04, (NONINDICATING) This specification is approved for use by all Departments and Agencies of the Department of Defense. Th
2、e requirements for acquiring the product described herein shall consist of this specification sheet and MIL-PRF-23419. Inches mm .06 1.52 .103 2.62 .311 7.90 1.50 38.1 NOTES: 1. Dimensions are in inches. 2. Metric equivalents are given for general information only. FIGURE 1. Style FM04 fuses. MARKIN
3、G Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-PRF-23419/4H 2 REQUIREMENTS: Interface and physical dimensions: See figure 1. Applicable fuseholder: Grayhill type 2-42, ultra miniature test clip (or equivalent). For 7 Ampere (A), 10A, and 15A f
4、uses, use Grayhill pushpost number 29-100 or equivalent. Case material: Ceramic or glass. Terminals: Materials: Caps, 90/10, commercial bronze; leads, copper. Finish: Caps, silver or bright alloy plate; leads solder coated. Strength: 5 pounds along terminal axis. Current rating: See table I. Charact
5、eristic: See table I. Voltage rating: See table I. Current carrying capacity: 100 percent at +25C; 110 percent at -55C; 80 percent at +125C. The temperature of the case, body, or terminals shall, at no point, rise more than +70C above the ambient air temperature. The maximum temperature rise for 10A
6、 and 15A fuses shall be +85C. Resistance: See table I. Cold resistance is measured at 10 percent or less of rated current. Overload interrupt: Percentage of nominal rating, interrupt time -55C through +125C, 200 percent in 0 second to 5 seconds; 300 percent in 0 second to 0.1 second. Interrupt time
7、for 15A fuses shall be 10 seconds maximum at 200 percent of rated current and .3 second maximum at 300 percent of rated current. Short circuit interrupt: 300 amperes at maximum voltage dc. Shock: Method I of MIL-PRF-23419. Thermal shock: Method 107, MIL-STD-202, test condition B. Extent of qualifica
8、tion: Qualification may be extended to style FM04 fuses to those qualified for style FM08 fuses. Group C inspection and retention of qualification may be extended from MIL-PRF-23419/8, provided they are all the same design and construction. Solderability: Fuses shall be tested in accordance with MIL
9、-PRF-23419. Gold plated leads shall have the gold removed by single or double dipping into a flowing or nonflowing hot solder of sufficient volume to assure complete gold removal. Resistance to soldering heat: Fuses shall be tested in accordance with MIL-PRF-23419. Marking: Fuses shall be marked wit
10、h the manufacturers name or trademark and current rating only. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-PRF-23419/4H 3 Part or Identifying Number (PIN): The PIN is derived from table I and shall be as shown in table IV. TABLE I. Style FM04
- 1.请仔细阅读文档,确保文档完整性,对于不预览、不比对内容而直接下载带来的问题本站不予受理。
- 2.下载的文档,不会出现我们的网址水印。
- 3、该文档所得收入(下载+内容+预览)归上传者、原创作者;如果您是本文档原作者,请点此认领!既往收益都归您。
下载文档到电脑,查找使用更方便
10000 积分 0人已下载
下载 | 加入VIP,交流精品资源 |
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- DLAMILPRF234194H2012FUSESCARTRIDGEINSTRUMENTTYPESTYLEFM04NONINDICATINGPDF

链接地址:http://www.mydoc123.com/p-692630.html