ASTM F2654-2014 Standard Specification for Low Energy Air Gun &40 LEAG&41 Warnings《低能气铆钉枪 (LEAG) 警告用标准规范》.pdf
《ASTM F2654-2014 Standard Specification for Low Energy Air Gun &40 LEAG&41 Warnings《低能气铆钉枪 (LEAG) 警告用标准规范》.pdf》由会员分享,可在线阅读,更多相关《ASTM F2654-2014 Standard Specification for Low Energy Air Gun &40 LEAG&41 Warnings《低能气铆钉枪 (LEAG) 警告用标准规范》.pdf(5页珍藏版)》请在麦多课文档分享上搜索。
1、Designation: F2654 07F2654 14 An American National StandardStandard Specification forLow Energy Air Gun (LEAG) Warnings1This standard is issued under the fixed designation F2654; the number immediately following the designation indicates the year oforiginal adoption or, in the case of revision, the
2、year of last revision. A number in parentheses indicates the year of last reapproval. Asuperscript epsilon () indicates an editorial change since the last revision or reapproval.1. Scope1.1 This specification covers low energy air guns (LEAG), commonly referred to as airsoft guns, air soft guns, or
3、soft air guns,or any combination thereof, which propel a low energy air gun projectile, as defined in 3.1.2. and meeting the requirements inSpecification F2748.1.2 LimitationsThis specification does not cover the following categories of gun products: Products covered by SpecificationsF589 (non-powde
4、r guns), F2272 (paintball markers), F2573 (toy products), and F2574 (non-recreational guns such as those usedby law enforcement, scientific, or military agencies).1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.1.4 This s
5、tandard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibilityof the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatorylimitations prior to use.2. Referenced Documents2.1
6、ASTM Standards:2F589 Consumer Safety Specification for Non-Powder GunsF2272 Specification for Paintball MarkersF2573 Specification for Low Velocity Resilient Material ProjectileF2574 Specification for Low Velocity Projectile MarkerF2679 Specification for 6 mm Projectiles Used with Low Energy Air Gun
7、sF27483. Terminology3.1 Definitions of Terms Specific to This Standard:3.1.1 low energy air gun (LEAG), ncommonly referred to as airsoft gun, air soft gun, or soft air gun, or any combinationthereof, is a device specifically designed to expel a low energy air gun projectile, by the release of energy
8、 by compressed air,compressed gas, mechanical springs, battery, or a combination thereof, at energies commonly lower than 1.5 joule.thereof.3.1.2 low energy air gun projectile, nis spherical, commonly between 6 mm (.24 cal) and 8 mm (.32) and in diameter,non-metallic and non-liquid filled projectile
9、 to be used in a low energy air gun. gun meeting the requirements in SpecificationF2679.4. Significance and Use4.1 This specification addresses the appropriate warnings and instructions that are to be provided for literature, labels, packages,and procedures for safe use of low energy air guns.5. Con
10、formance5.1 Low energy air guns shall not, either by label or other means, indicate conformance with this specification unless theyconform with the applicable requirements contained herein.1 This specification is under the jurisdiction of ASTM Committee F08 on Sports Equipment, Playing Surfaces, and
11、 Facilities and is the direct responsibility ofSubcommittee F08.27 on Airsoft.Current edition approved May 1, 2007May 1, 2014. Published June 2007May 2014. Originally approved in 2007. Last previous edition approved in 2007 as F2654 07.DOI: 10.1520/F2654-07.10.1520/F2654-14.2 For referencedASTM stan
12、dards, visit theASTM website, www.astm.org, or contactASTM Customer Service at serviceastm.org. For Annual Book of ASTM Standardsvolume information, refer to the standards Document Summary page on the ASTM website.This document is not an ASTM standard and is intended only to provide the user of an A
13、STM standard an indication of what changes have been made to the previous version. Becauseit may not be technically possible to adequately depict all changes accurately, ASTM recommends that users consult prior editions as appropriate. In all cases only the current versionof the standard as publishe
14、d by ASTM is to be considered the official document.Copyright ASTM International, 100 Barr Harbor Drive, PO Box C700, West Conshohocken, PA 19428-2959. United States16. General Requirements6.1 LiteratureLiterature shall be provided with each low energy air gun and shall include, as applicable, the i
15、nstructions andcautionary statements specified in Section 7.6.2 PackagingPackaging shall be labeled in a prominent and conspicuous manner in accordance with the provisions ofSection 7.7. Instructions, Labeling, and Marking7.1 GeneralPackaging and literature for low energy air guns with energy under
16、two joule shall contain a cautionary statementas prescribed in this specification.7.2 Safety disclaimers shall not be used which dilute or negate the effectiveness of the warnings provided for in theseinstructions, labeling, and marking requirements.7.3 Packaging:7.3.1 The packaging for low energy a
17、ir guns with energy under two joule shall contain a cautionary statement. The statementshall be placed prominently on the package and set distinctively apart from other wording or designs.7.3.2 Prominence of the statement shall be achieved by placement within the borders of a rectangle and by use of
18、 a suitablecontrasting background. The statement may be in a combination of upper and lower case letters of a size not less than 8-point type.The letters in the signal word shall be least 50 % larger than the letters in the other words in the cautionary statement. The signalword shall be in upper ca
19、se letters and preceded by a safety alert symbol. It is composed of an equilateral triangle surrounding anexclamation mark. The base of the safety alert symbol shall be on the same horizontal line as the base of the letters of the signalword. The height of the safety alert symbol shall equal or exce
20、ed the signal word height. The signal word shall be in black letterson an orange background. The solid triangle of the safety alert symbol shall be black and the exclamation point shall be orange.The cautionary statement shall have either black lettering on a white background or white lettering on a
21、 black background. Whenspecial circumstances limit the use of the warning to two colors, the colors assigned to the signal word background may also beused for the cautionary statement letters, provided that they contrast with the background color of the product. When specialcircumstances preclude th
22、e use of safety colors on base materials such as wood, cardboard, metal, plastic, and so forth, the markingused should (when feasible) contrast with the background color of the base material.7.3.3 The cautionary statement on packaging of all low energy air guns with energy under two joule shall conv
23、ey the followinginformation at a minimum:7.3.3.1 A signal word “WARNING.”7.3.3.2 A warning that this is not a toy.7.3.3.3 A warning that misuse may cause serious injury, especially to the eye.7.3.3.4 A warning that eye protection designed for low energy air guns must be worn by the user and any pers
24、on within range.7.3.3.5 Instructions to read operation manual before using.7.3.3.6 The following cautionary statement may be used:“WARNINGThis is not a toy. Misuse may cause serious injury, especially to the eye. Eye protection designed for air soft gunsmust be worn by the user and any person within
- 1.请仔细阅读文档,确保文档完整性,对于不预览、不比对内容而直接下载带来的问题本站不予受理。
- 2.下载的文档,不会出现我们的网址水印。
- 3、该文档所得收入(下载+内容+预览)归上传者、原创作者;如果您是本文档原作者,请点此认领!既往收益都归您。
下载文档到电脑,查找使用更方便
5000 积分 0人已下载
下载 | 加入VIP,交流精品资源 |
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- ASTMF26542014STANDARDSPECIFICATIONFORLOWENERGYAIRGUN40LEAG41WARNINGS 低能 铆钉枪 LEAG 警告 标准规范 PDF

链接地址:http://www.mydoc123.com/p-539199.html