ASTM F1558-1994(2015) Standard Guide for Characteristics for Adjunct Cervical Spine Immobilization Devices (ACSID)《辅助颈椎固定装置 (ACSID) 的标准特征指南》.pdf

《ASTM F1558-1994(2015) Standard Guide for Characteristics for Adjunct Cervical Spine Immobilization Devices (ACSID)《辅助颈椎固定装置 (ACSID) 的标准特征指南》.pdf》由会员分享，可在线阅读，更多相关《ASTM F1558-1994(2015) Standard Guide for Characteristics for Adjunct Cervical Spine Immobilization Devices (ACSID)《辅助颈椎固定装置 (ACSID) 的标准特征指南》.pdf（2页珍藏版）》请在麦多课文档分享上搜索。

1、Designation: F1558 94 (Reapproved 2015)Standard Guide forCharacteristics for Adjunct Cervical Spine ImmobilizationDevices (ACSID)1This standard is issued under the fixed designation F1558; the number immediately following the designation indicates the year oforiginal adoption or, in the case of revi

2、sion, the year of last revision. A number in parentheses indicates the year of last reapproval. Asuperscript epsilon () indicates an editorial change since the last revision or reapproval.INTRODUCTIONThe objective of this guide is to begin to address the recognized need to support and immobilize the

3、components of the spine or spinal cord. Although this guide does not quantitatively addressperformance standards for this device, it does address the characteristics of the device(s) used toprovide support and immobilization of the components of the central nervous system for the patientsuspected of

4、 receiving trauma to that body system.1. Scope1.1 This guide establishes minimum standards for devicesdesignated here as adjunct cervical spine immobilization de-vice (ACSID); a lateral stabilizer for the head is an example ofthis type of device. The ACSID is designed to be used to assistin the immo

5、bilization of the cervical spine, by emergencymedical services personnel.1.2 This guide does not identify specific degrees of limita-tion of motion achieved by placement of an ACSID on apatient. Definitive requirements for immobilization of thespine, and, in particular, the degree of limitation asso

6、ciatedwith the use of an ACSID, have not been established in themedical literature.1.3 This standard does not purport to address all of thesafety concerns, if any, associated with its use. It is theresponsibility of the user of this standard to establish appro-priate safety and health practices and

7、determine the applica-bility of regulatory limitations prior to use.2. Referenced Documents2.1 ASTM Standards:2F1177 Terminology Relating to Emergency Medical Ser-vices2.2 OSHA Standard:20 CFR 1910.1030 Occupational Exposure to BloodbornePathogens; Final Rule32.3 Centers for Disease Control Standard

8、:Guidelines for Prevention of Transmission of HIV and HBVto Healthcare and Public Safety Workers43. Terminology3.1 Definitions:3.1.1 retention systeman adjunct to or an integral part ofthe primary platform that allows the patient to be securelyattached to that platform used in whatever configuration

9、 andsize necessary to accomplish the goal while still allowingreasonable and necessary access to the patient.3.1.2 spinal immobilizationimmobilization of the entirespine and its contiguous structures, the pelvis and skull.3.1.3 spinethe spine shall include the cervical, thoracic,lumbar, and sacral v

10、ertebrae.3.2 Definitions of Terms Specific to This Standard:3.2.1 directions of movementdirections include flexion,extension, rotation, distraction, lateral motion, and axial com-pression motion.3.2.2 immobilizationlimitation of motion.3.3 For definitions of other terms used in this guide, refer toT

11、erminology F1177.4. Significance and Use4.1 The intent of this guide is to identify characteristics thatan ACSID shall possess.1This guide is under the jurisdiction of ASTM Committee F30 on EmergencyMedical Services and is the direct responsibility of Subcommittee F30.01 on EMSEquipment.Current edit

12、ion approved June 1, 2015. Published July 2015. Originally approvedin 1994. Last previous edition approved in 2007 as F1558 94(2007). DOI:10.1520/F1558-94R15.2For referenced ASTM standards, visit the ASTM website, www.astm.org, orcontact ASTM Customer Service at serviceastm.org. For Annual Book of A

13、STMStandards volume information, refer to the standards Document Summary page onthe ASTM website.3Available from Superintendent of Documents, U.S. Government PrintingOffice, Washington, DC 20402.4Available from Centers for Disease Control spinal cord; spineASTM International takes no position respec

14、ting the validity of any patent rights asserted in connection with any item mentionedin this standard. Users of this standard are expressly advised that determination of the validity of any such patent rights, and the riskof infringement of such rights, are entirely their own responsibility.This sta

15、ndard is subject to revision at any time by the responsible technical committee and must be reviewed every five years andif not revised, either reapproved or withdrawn. Your comments are invited either for revision of this standard or for additional standardsand should be addressed to ASTM Internati

16、onal Headquarters. Your comments will receive careful consideration at a meeting of theresponsible technical committee, which you may attend. If you feel that your comments have not received a fair hearing you shouldmake your views known to the ASTM Committee on Standards, at the address shown below

17、.This standard is copyrighted by ASTM International, 100 Barr Harbor Drive, PO Box C700, West Conshohocken, PA 19428-2959,United States. Individual reprints (single or multiple copies) of this standard may be obtained by contacting ASTM at the aboveaddress or at 610-832-9585 (phone), 610-832-9555 (fax), or serviceastm.org (e-mail); or through the ASTM website(www.astm.org). Permission rights to photocopy the standard may also be secured from the Copyright Clearance Center, 222Rosewood Drive, Danvers, MA 01923, Tel: (978) 646-2600; http:/ 94 (2015)2