ASTM D7197-2013 red 8750 Standard Table of Body Measurements for Misses Maternity Sizes Two to Twenty-Two (2-22)《尺寸规格为2至22 (2-22) 的女性孕妇的人体测量标准表》.pdf
《ASTM D7197-2013 red 8750 Standard Table of Body Measurements for Misses Maternity Sizes Two to Twenty-Two (2-22)《尺寸规格为2至22 (2-22) 的女性孕妇的人体测量标准表》.pdf》由会员分享,可在线阅读,更多相关《ASTM D7197-2013 red 8750 Standard Table of Body Measurements for Misses Maternity Sizes Two to Twenty-Two (2-22)《尺寸规格为2至22 (2-22) 的女性孕妇的人体测量标准表》.pdf(6页珍藏版)》请在麦多课文档分享上搜索。
1、Designation: D7197 06D7197 13Standard Table ofBody Measurements for Misses Maternity Sizes Two toTwenty-Two (2-22)1This standard is issued under the fixed designation D7197; the number immediately following the designation indicates the year oforiginal adoption or, in the case of revision, the year
2、of last revision. A number in parentheses indicates the year of last reapproval. Asuperscript epsilon () indicates an editorial change since the last revision or reapproval.1. Scope1.1 This standard table lists the body measurements of pregnant women from misses size two to twenty-two. Although thes
3、eare body measurements, they can be used in designing apparel for women in this size range when such factors as fabric type, easeof body movement, styling, and fit are taken into account.1.2 The values stated in either SI units or in inch-pound units shall be regarded separately as standard. The val
4、ues stated in eachsystem may not be exact equivalents; therefore, each system must be used independently of the other, without combining valuesin any way.2. Referenced Documents2.1 ASTM Standards:2D123 Terminology Relating to TextilesD5219 Terminology Relating to Body Dimensions for Apparel Sizing2.
5、2 ISO Standard:Size Designation of Clothes, Definitions and Body Measurements Procedures for Apparel Sizes33. Terminology3.1 Definitions:3.1.1 Refer to Terminologies D123 and D5219.4. Significance and Use4.1 The use of the body measurement information in Table 1 will assist manufacturers in the deve
6、lopment of patterns andgarments that are consistent with the current anthropometric characteristics of the population of interest. This practice in turnshould reduce or minimize consumer confusion and dissatisfaction related to apparel sizing. (Also refer to ISO Size Designationstandards.)5. Apparat
7、us5.1 All apparatus are calibrated for accuracy.5.2 Tape Measure, dimensionally stable and approximately 1.5 cm (12 in.) wide and graduated accurately in centimetres (116in.).5.3 Scale (Calibrated for Standard Body Weight).6. Procedures Used for Taking Measurements6.1 General Procedure:6.1.1 For all
8、 vertical and most horizontal measurements, subject is to be standing erect without shoes and with feetapproximately 15 cm (6 in.) apart.1 This table is under the jurisdiction of ASTM Committee D13 on Textiles and is the direct responsibility of Subcommittee D13.55 on Body Measurement for ApparelSiz
9、ing.Current edition approved Jan. 1, 2006Jan. 1, 2013. Published February 2006February 2013. Originally approved in 2006. Last previous edition approved in 2006 asD7197-06. DOI: 10.1520/D7197-06.10.1520/D7197-13.2 For referencedASTM standards, visit theASTM website, www.astm.org, or contactASTM Cust
10、omer Service at serviceastm.org. For Annual Book of ASTM Standardsvolume information, refer to the standards Document Summary page on the ASTM website.3 Available from American National Standards Institute (ANSI), 25 W. 43rd St., 4th Floor, New York, NY 10036.This document is not an ASTM standard an
11、d is intended only to provide the user of an ASTM standard an indication of what changes have been made to the previous version. Becauseit may not be technically possible to adequately depict all changes accurately, ASTM recommends that users consult prior editions as appropriate. In all cases only
12、the current versionof the standard as published by ASTM is to be considered the official document.Copyright ASTM International, 100 Barr Harbor Drive, PO Box C700, West Conshohocken, PA 19428-2959. United States1TABLE 1 New ASTM Maternity Measurement TableMISSES MATERNITY(SIZES 222)GIRTH MEASUREMENT
- 1.请仔细阅读文档,确保文档完整性,对于不预览、不比对内容而直接下载带来的问题本站不予受理。
- 2.下载的文档,不会出现我们的网址水印。
- 3、该文档所得收入(下载+内容+预览)归上传者、原创作者;如果您是本文档原作者,请点此认领!既往收益都归您。
下载文档到电脑,查找使用更方便
5000 积分 0人已下载
下载 | 加入VIP,交流精品资源 |
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- ASTMD71972013RED8750STANDARDTABLEOFBODYMEASUREMENTSFORMISSESMATERNITYSIZESTWOTOTWENTYTWO222 尺寸 规格 22222

链接地址:http://www.mydoc123.com/p-524787.html