ARMY MIL-PRF-32271 11-2008 BATTERY NON-RECHARGEABLE LITHIUM《不可充电锂电池》.pdf

《ARMY MIL-PRF-32271 11-2008 BATTERY NON-RECHARGEABLE LITHIUM《不可充电锂电池》.pdf》由会员分享，可在线阅读，更多相关《ARMY MIL-PRF-32271 11-2008 BATTERY NON-RECHARGEABLE LITHIUM《不可充电锂电池》.pdf（6页珍藏版）》请在麦多课文档分享上搜索。

1、AMSC N/A Page 1 of 6 FSC 6135 DISTRIBUTION STATEMENT A: Approved for public release; distribution is unlimited INCH-POUND MIL-PRF-32271/11 30 October 2008 PERFORMANCE SPECIFICATION SHEET BATTERY, NON-RECHARGEABLE, LITHIUM This specification is approved for use by all Departments and Agencies of the

2、Department of Defense. The requirements for acquiring the product herein shall consist of this specification and MIL-PRF-32271. Figure 1 General View, M32271/11 Battery Shape REQUIREMENTS (see 1.2 for Type, Class, and Features descriptions): Type I Class 1 Features A PIN M32271/11-11A Approved chemi

3、stry: Lithium manganese dioxide (Li/MnO2) Specification requirements: The following requirements of MIL-PRF-32271, identified therein as “when specified”, are applicable as indicated below: See NOTES for nominal dimensions; see applicable drawing for dimensional requirements. Copyright Communication

4、s - Electronics Command Provided by IHS under license with CRAINot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-PRF-32271/11 2 Requirement Specification Reference Applicability Parallel cell arrangements 3.4 No Connectors13.4.5 Yes Battery charger connection 3.4

5、.5.1 No Connection integrity 3.4.5.2 No Terminal integrity 3.4.6 No Complete discharge device 3.4.7 No State of charge device 3.4.8 No State of charge data output 3.4.8e No Cell charging 3.5.3 No Nail penetration 3.5.4 No Cell series string short circuit 3.5.6 No Parallel string charge protection 3.

6、5.6.1 No Charge protection 3.5.11 No Over-current protection 3.5.13.1 No Over-temperature protection 3.5.14 No Surface temperature 3.6h No Capacity tests LR and LRT No Immersion 3.7.8 Yes Watertight integrity 3.7.9 No DO NOT CHARGE! marking 3.8.1.2b No Complete discharge device 3.8.4 No marking/labe

7、l State of charge marking 3.8.5 No Dimensions, marking and configuration Battery - Drawing A3315888 Battery Connector Drawing A3315888 Mating Connector P/N SDU-5/E or equal Battery Charger Connector Not applicable Battery voltages (3.4.4 insertion and withdrawal measurements not required for this ba

8、ttery Copyright Communications - Electronics Command Provided by IHS under license with CRAINot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-PRF-32271/11 4 Connector (4.6.1.7): This test required to prove continuity only. Insertion and withdrawal force measureme

9、nts are not required. Continuity can be demonstrated by the batterys ability to power the SDU-5/E in lieu of voltage measurements. Abuse test, pre-discharge: When tested as specified in 4.6.2.12a, discharge with a load of 45 milli-amperes for 11 hours. Abuse test, pulse discharge: When tested as spe

10、cified in 4.6.2.12i, discharge with a load of 90 milli-amperes for 1 minute followed by 40 milli-amperes for 4 minutes, cycled continuously to 4.0 volts. Immersion: When tested as specified in 4.7.5.8, apply a load of 45 milli-amperes during the storage and immersion time periods specified. Capacity

11、 tests (4.6.4): Test Discharge Rate Duty Cycle I 45 milli-amperes Continuous discharge to zero volts, followed by 45 milli-amperes forced discharge for 5 minutes. L 45 milli-amperes Continuous discharge to cut-off voltage H 45 milli-amperes Continuous discharge to cut-off voltage IT 45 milli-amperes

12、 Continuous discharge to cut-off voltage LT 45 milli-amperes Continuous discharge to cut-off voltage HT 45 milli-amperes Continuous discharge to cut-off voltage NOTES: (This section contains information of a general nature which may be helpful, but is not mandatory) Intended use: This battery is int

13、ended for use in an emergency strobe light. 3Nominal ratings: The following are the nominal ratings for the battery described by this specification sheet. They are provided for information purposes. 3Capacity and energy delivered by a battery are significantly affected by usage conditions, such as t

14、emperature and loads applied. If you have any questions about use of this battery in a particular device or circumstance, please visit the following web site (contact info is posted): http:/www.cerdec.army.mil/c2d/armypower. Copyright Communications - Electronics Command Provided by IHS under licens

15、e with CRAINot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-PRF-32271/11 5 Battery PIN: M32271/11-11A (Li/MnO2) Overall Dimensions: 3.1 in L x 0.665 in DIA (DIA for battery, not flange) MAX Weight: 2.5 ounces (70.9 grams) Voltage Range: 4.0-6.6 Nominal Capacity:

16、(in ampere-hours) 1.0 Amp-hr Nominal Energy:(in watt-hours) 5.0 Watt-hrs MAX rated power output: 225 milli-watts MAX continuous load rating: 45 milli-amperes MAX pulse load rating: 90 milli-amperes Instantaneous trip rating: Not applicable Operating temperature range: -20 to 130F (-29 to 55C) Storag

17、e temperature range: -40 to 160F (-40 to 71C) MAX abusive temperature: (non-operating) 195F (91C) Other data: Military Type Designations. The military type designation that relates to the PIN covered by this specification sheet is as follows: The BA-5374()/U designation has been used for the Type I

18、PIN. This is a replacement for the BA-1574/U mercury battery, which is no longer available. This battery was exempt from the transportation requirements of 49 CFR 173.185 until January 2008; now it is subject to the test requirements therein beginning in October 2009. Class 9 shipping labels typical

19、ly wont be needed; consult with 49 CFR 173.185 for package quantity/size limitations. It has solid cathodes and contains less than 1.0 gram of lithium per cell and less than 2.0 grams of lithium per battery. It should be noted that all non-rechargeable lithium batteries are restricted from shipment

20、as cargo aboard passenger aircraft within, entering, or leaving the US. This battery does not have a complete discharge device. It is considered Non-Hazardous Solid Waste per the Resource Conservation and Recovery Act (RCRA). However, it is considered Hazardous Waste in states using Bioassay rules.

21、Check with your local disposal office for rules that apply. Navy safety tests of NAVSEA S9310-AQ-SAF-010 are required for this battery during first article testing. The test data provided from the testing will be used to evaluate applications for specific using devices and Navy platforms. Devices us

22、ing this battery may require US Navy Safety Approval prior to use by Department of Navy users unless such approval has already been granted. Please consult with NAVSEA Instruction 9310.1 for further information. Copyright Communications - Electronics Command Provided by IHS under license with CRAINo

23、t for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-PRF-32271/11 6 Custodians: Preparing activity: Army CR Army CR Navy NW (Project Number 6135-2006-014) Air Force 99 DLA GS Review activities: Navy SH, AS, MC Air Force 71 NOTE: The activities listed above were intere

24、sted in this document as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST Online database at http:/assist.daps.dla.mil or http:/assist.daps.dla.mil/quicksearch/. Copyright Communications - Electronics Command Provided by IHS under license with CRAINot for ResaleNo reproduction or networking permitted without license from IHS-,-,-