ITU-T E 453-1994 Facsimile Image Quality as Corrupted by Transmission-Induced Scan Line Errors - Telephone Network and ISDN Quality of Service Network Management and Traffic Engine.pdf

《ITU-T E 453-1994 Facsimile Image Quality as Corrupted by Transmission-Induced Scan Line Errors - Telephone Network and ISDN Quality of Service Network Management and Traffic Engine.pdf》由会员分享，可在线阅读，更多相关《ITU-T E 453-1994 Facsimile Image Quality as Corrupted by Transmission-Induced Scan Line Errors - Telephone Network and ISDN Quality of Service Network Management and Traffic Engine.pdf（10页珍藏版）》请在麦多课文档分享上搜索。

1、ITU-T RECMN*E=453 94 Lid62591 0595559 405 INTERNATIONAL TELECOMMUNICATION UNION ITU-T TELECOMMUNICATION STANDARDIZATION SECTOR OF ITU E.453 (08/94) TELEPHONE NETWORK AND ISDN QUALITY OF SERVICE, NETWORK MANAGEMENT AND TRAFFIC ENGINEERING FACSIMILE IMAGE QUALITY AS CORRUPTED SCAN LINE ERRORS BY TRANS

2、MISSION-INDUCED ITU-T Recommendation E.453 (Previously “CCITT Recommendation”) FOREWORD The IT-T (Telecommunication Standardization Sector) is a permanent organ of the International Telecommunication Union. The ITU-T is responsible for studying technical, operating and tariff questions and issuing R

3、ecommendations on them with a view to standardizing telecommunications on a worldwide basis. The World Telecommunication Standardization Conference (WTSC), which meets every four years, establishes the topics for study by the ITU-T Study Groups which, in their turn, produce Recommendations on these

4、topics. The approval of Recommendations by the Members of the IT-T is covered by the procedure laid down in WTSC Resolution No. 1 (Helsinki, March 1-12, 1993). IT-T Recommendation E.453 was prepared by the ITU-T Study Group 2 (1993-1996) and was approved under the WTSC Resolution No. 1 procedure on

5、the 12th of August 1994. NOTE In this Recommendation, the expression “Administration” is used for conciseness to indicate both a telecommunication administration and a recognized operating agency. O ITU 1995 All rights reserved. No part of this publication may be reproduced or utilized in any form o

6、r by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from the ITU. ITU-T RECNNUE.453 94 4862591 0595561 Ob3 CONTENTS 1 Introduction 2 Definitions 2.1 Error definitions 2.2 Standard test transactions 2.3 Image quality categories . 2.4 Transacti

7、on metncs . 2.5 Page mettics Processing the scan line error distribution . 3 4 5 Remarks Facility-type sensitive performance criteria . Page 1 2 2 2 2 3 4 4 5 5 Recommendation E.453 (08194) 1 ITU-T RECflN*E-453 94 9 48b259L 0595562 TTT SUMMARY Transmission-induced scan line errors are one of the imp

8、ortant impairments perceived by customers in non-Error Correction Mode (see Recommendations T.4 and T.30) Group 3 facsimile. This proposed text develops a set of scan line related performance metncs that can help benchmark the performance of transmission networks with respect to Group 3 facsimile. I

9、n this text, certain criteria are developed for declaring a received facsimile page Error-Free, Errored, and Severely- Errored. These criteria are based on the number and distribution of errored scan lines and were developed based on customer perception studies of facsimile images. 11 Recommendation

10、 E.453 (OW94) ITU-T RECHNUE-453 94 m 4862593 0595563 93b m Recommendation E.453 FACSIMILE IMAGE QUALITY AS CORRUPTED BY TRANSMISSION-INDUCED SCAN LINE ERRORS (Geneva, 1994) 1 Introduction Transmission-induced scan line errors are one of the important impairments perceived by customers in non-Error C

11、orrection Mode (see Recommendations T.4 and T.30) Group 3 facsimile. The purpose of this Recommendation is to develop a set of scan line related metrics that can help benchmark performance of transmission networks with respect to Group 3 facsimile. Scan line errors occur when voiceband modem data st

12、ream is corrupted during transmission, causing errors in the received facsimile image data. The receiving facsimile machine may be unable to decode the received scan line data, or the scan line data may not decode into the required number of pels, e.g. 1728. For the purposes of image quality evaluat

13、ion, an errored scan line is one which fails to produce (e.g. through printing) an identical copy of the original (transmitted) scan line. The receiving machine may employ one of several strategies to deal with errored scan lines. These strategies include: a) delete; b) print previous; c) print whit

14、e; d) combination of above in case of consecutive errored scan lines; and e) some other form of error concealment. The distribution of errored scan lines is the primary factor in determining the quality of the received image. The strategy used in the receiving machine is a lesser factor which is mit

15、igated further by the points discussed below. This Recommendation contains image transmission quality metrics that are independent of the particular strategy used for errored scan lines. Metric development was aided by knowledge of how well the various concealment strategies work and the approximate

16、 extent of each strategys deployment. The goal was to develop a reasonable set of image quality metrics and to monitor network performance with them. These metrics have a good correlation with user quality measures, are reasonably implementable, and retain utility for the intended audience. This Rec

17、ommendation is primarily intended for a fixed network environment. Facsimile service quality metrics for PLMN are for further study. The following points are to be noted: - The metrics presented here are developed primarily from the customer-perceived impact of scan line errors on Roman text, Japane

18、se text, Arabic numerical information, although a limited set of graphs such as line graphs, pie charts and other graphics were considered. Several limited studies have shown that text and numerical information are likely to be the most frequently transmitted material on international facsimile call

19、s. - Image quality metrics based on Recommendation T.30 HDLC messages such as RTP and RT and also ECM messages can be developed. Certain additional complexities are known, such as the wide range of decision criteria for sending RTP and RTN. This subject is for further study. Recommendation E.453 (OW

20、94) 1 2 Definitions 2.1 Error definitions 2.1.1 process of decoding and printing) an identical copy (pel for pel) of the original scan line. errored scan line: An errored scan line is one whose received data stream fails to produce (e.g. through the The intent of this definition is to quantify trans

21、mission errors within the context of the facsimile page information bit stream. Some examples of errored scan lines follow: 1) 2) 3) A line whose encoded representation contains one or more bit errors. A line whose preceding end-of-line code (EOL) contains one or more bit errors. A line that cannot

22、be correctly decoded to produce the original line, because of some corruption in a previously received line that was used as an encoding reference. This example can only occur with two-dimensional (e.g. modified READ) encoding. This definition is not intended to include image degradation confined to

23、 the printing or display process. The subject of manipulation of fill bits is for further study. 2.1.2 consecutive scan lines in error: Scan lines errors are defined as occurring in a consecutive configuration, when two or more scan line errors are received with no intervening error-free lines. The

24、instance of consecutive errored lines is always preceded and followed by at least one error-free line (except if the instance occurs at the beginning or end of the page). 2.1.3 least one error-free scan line (except if the instance occurs at the beginning or end of the page). single scan line error:

25、 A single scan line error is defined as one errored scan line preceded and followed by at 2.2 Standard test transactions Standard test transactions have been defined in Recommendation E.456. 2.3 Image quality categories This subclause defines the method to collect information on the distribution of

26、errored scan lines within a page. It also defines the image quality categories for assignment of received pages to perform transmission performance assessment. Given that: - there exists a pair of transmitting and receiving test machines that operate in the standard mode and do not have any known co

27、mpatibility problems; the speed of the initial TCF (Si, as defined in Recommendation E.452) is known; the test transaction is completed (all pages are received), - - the following definitions apply. 2.3.1 the transmitted original page. error-free page: A page is considered error-free if it has no er

28、rored scan lines and contains all scan lines of Pages delivered with error-free quality will retain all of their original information content, as though the facsimile operation were a lossless encoding-transmission-decoding process. The communication service provider has not added to, nor subtracted

29、 from the original information content. 2.3.2 required to declare the page severely-errored (see 2.3.3). Pages received with this level of quality contain some degradation to the original image, but are very likely to retain their intended utility. The page contains some errors, but based on subject

30、ive studies, it remains acceptable in most applications. For example, a typical page of 10-point text will still be readable, and a page of graphics will convey the intended information. errored page: A page is considered errored if it has one or more scan line errors but less than the number 2 Reco

31、mmendation E.453 (08/94) ITU-T RECMN*E=453 74 4862571 05955b5 707 There are some less-frequency applications of facsimile which demand error-free or near error-free image quality to retain their utility, such as very small point size text or other fine detail, or legal documents where errors could r

32、ender the document useless in court. When considering the performance of these stressful facsimile applications, network planners should focus on the error-free category as a measure of useful delivery. 2.3.3 in Recommendation T4. severely-errored page: The following definitions apply to the Standar

33、d Resolution (3.85 lines/mm) as defined A page is considered severely-errored if it has: a) b) c) at least N4 instances of four or more consecutive scan line errors; and/or at least NS total scan line errors in single consecutive instances; and/or at least N23 instances of consecutive errored scan l

34、ines with two and/or three consecutive scan lines in each instance. N4, NS and N23 define the threshold values over a range of scan line error event types. The value of expressing the distribution of scan line errors in this way has been demonstrated through subjective testing. Pages received with t

35、his level of quality contain Substantial deviation from the original image bit-map and, based on subjective studies, are considered unacceptable. It is likely that they no longer convey some part of their original information, or contain distortion that significantly detracts from their usefulness.

36、Some small fraction of pages may retain their utility, such as when the original image contains substantial redundancy, or in the unlikely event that all degradation is confined to “white” space. TABLE 1B.453 Thresholds for a severely-errored page for standard resolution Page is severely-errored whe

37、n count is at least I Criteria I N4 l 1 I NS 12 I NOTE - Thresholds for a Severely-Errored Page of Optional Higher I Resolution (7.7 lineslmm) are to be added in future. 2.4 Transaction metria Calls with error-free pages: - - CEF is the number of completed transactions which had all error-free pages

38、. Then, represented as a percentage of Tc, where Tc is the number of completed transactions in the test: Calls with errored pages: - CE is the number of completed transactions which had one or more errored pages, but no severely-errored pages. Then, represented as a percentage of Tc: - %CE = (c/Tc)

39、x 100 Recommendation E.453 (OW94) 3 ITU-T RECMN*E.453 94 4862591 0595566 645 Calls with severely-errored pages: - - CSE is the number of completed transactions which had one or more severely-errored pages. Then, represented as a percentage of Tc: %CSE = (CSE/TC) X 100 For exchanging network performa

40、nce data, there is often a need to define the percentage of calls that contain no severely-errored pages. This is defined as %CNSE and is the complement of %CSE, Le.: Note that the number of completed transactions (used in the denominator) determines the sample size and therefore the confidence inte

41、rval for these measures. When preparing for a series of test calls, some transaction failure rate should be assumed. Failed transactions shall be excluded from the sample. The total test calls should be increased by an appropriate amount to attain the desired confidence in the measurement. 2.5 Page

42、metrics Page based metrics have definitions similar to transaction metrics. Let the test transaction be of N pages, where the value of N is given in Recommendation E.456. Number of error-free pages: - - PEF is the total number of error-free pages in TC completed transactions. Then, represented as a

43、percentage of the total number of pages of Tc completed transactions: %Pw = PEF/(N X TC) X 100 Number of errored pages: - - PE is the total number of errored pages in Tc completed transactions. Then, represented as a percentage of pages in TC completed transactions: %PE = PE/ (N x Tc) x 100 Number o

44、f severely-errored pages: - - PSE is the total number of severely-errored pages in Tc completed transactions. Then, represented as a percentage of pages in TC completed transactions: %PNSE, the percentage of non-severely-errored pages is defined as the complement of %PsE, i.e.: 3 It is recognized th

45、at scan line errors affecting text (or other picture element information) are much more important than those occurring in white spaces. However, there are several points which support collection of scan line performance over the entire page. NOTE - The ?entire page? is defined as an area that closel

46、y approximates the ?guaranteed reproducible area? described in ITU-T Recommendation T.4. Image quality performance results reported on the basis of entire pages present a conservative view of the results, in that customers would experience performance which is better than that measured. Lower limit

47、measurements such as this are useful in performance monitoring and network planning. Processing the scan line error distribution 1) 4 Recommendation E.453 (08/94) ITU-T RECMN*E=453 94 4Bb2.571 0575567 581 Pageitransaction category Error-free 2) There is a possibility that some scaling functions coul

48、d be applied to measurements to predict typical customer response. The application of any scaling functions should benefit if the initial measurements are based on entire pages. The subject of scaling functions is complex and left for further study, while entire-page measurements create a strong fou

49、ndation for them if needed. Tier 1 Tier 2 EF1 EF2 3) The evaluation of image quality is greatly simplified by measuring errored scan lines over the entire page. It will be easier to compare results conducted by different Administrations using different test architectures. Errored Severely-errored Since current ITU-T test charts have little white space, this simplification is not likely to have a great impact on the results. Uniform application of these metrics will provide accurate data that can be used to assess network performance, El E2 SE1 SE2 4 Facility-type sensitive performanc