HOLDEN HN 1823-2004 SEALER - ANEROBIC《厌氧的密封层》.pdf

《HOLDEN HN 1823-2004 SEALER - ANEROBIC《厌氧的密封层》.pdf》由会员分享，可在线阅读，更多相关《HOLDEN HN 1823-2004 SEALER - ANEROBIC《厌氧的密封层》.pdf（2页珍藏版）》请在麦多课文档分享上搜索。

1、A.C.N. 006 893 232 Holden Limited Engineering Department MATERIAL SPECIFICATION NUMBER SHEET RELEASE REVISION : HN 1823 1 of 2 January, 1985 April, 2004 NAME: SEALER - ANEROBIC THIS DOCUMENT MUST NOT BE REPRODUCED. IF USED IN RELATION TO THE COMPANYS PRODUCTS THE RECIPIENT IS RESPONSIBLE TO CONFIRM

2、THE DOCUMENT ISSUE DATE IS STILL VALID. FORM : I:CentralLaboratoryStandardForms MaterialSpecificationMatspec.doc 1. SCOPE This standard describes a single component, gel-like anerobic material intended for use in place of preformed and precut gaskets. The material solidifies by polymerisation into a

3、 tough plastic when confined between closely fitted metal surfaces, producing an effective seal against leakage 2. GENERAL The material shall be capable of sealing gaps up to 1.25mm with Primer N and 0.25mm without Primer N shall not migrate or drip when used on vertical surfaces. 3. PROPERTIES 3.1

4、Resin Type Polyacrylate 3.2 Colour Red 3.3 Specific Gravity 1.085 3.4 Shelf Life at 25 C 12 months minimum 3.5 Temperature range Continuous Operation -57 C to l50C 3.6 Viscosity at 22 C (Brookfield Viscometer 5 RPM) 400 1200 CPS 3.7 Cure Speed With Primer N 15min to 2 hours Without Primer N 1-12 Hou

5、rs A.C.N. 006 893 232 Holden Limited Engineering Department MATERIAL SPECIFICATION NUMBER SHEET RELEASE REVISION : HN 1823 2 of 2 January, 1985 April, 2004 NAME: SEALER - ANEROBIC THIS DOCUMENT MUST NOT BE REPRODUCED. IF USED IN RELATION TO THE COMPANYS PRODUCTS THE RECIPIENT IS RESPONSIBLE TO CONFI

6、RM THE DOCUMENT ISSUE DATE IS STILL VALID. FORM : I:CentralLaboratoryStandardForms MaterialSpecificationMatspec.doc 4 APPROVAL, INSPECTION AND REJECTION Refer HN 1000, Clauses A, C and G(Line Trial). 5. HAZARDOUS MATERIALS Refer HN 1000, Clause H. 6. RESTRICTED CHEMICALS Refer HN 1000, Clause J. 7.

7、APPROVED SUPPLIERS AND MATERIALS APPROVED SUPPLIER APPROVED MATERIAL Loctite Corporation Loctite 518 8. REFERENCES HN 1000 9. REVISIONS November, 1998 - Approved Material Loctite 518 replaces Loctite 514. - References section added. November, 2002 - HN 1823 was made INACTIVE. April, 2004 - HN 1823 was made ACTIVE. - Inclusion of reference to HN 1000, Clause C in section 4(APPROVED SUPPLIERS AND MATERIALS). Prepared by: Y. Zia