FORD M99C47-A-2009 MINERAL OIL - LIGHT《轻质矿物油》.pdf

《FORD M99C47-A-2009 MINERAL OIL - LIGHT《轻质矿物油》.pdf》由会员分享，可在线阅读，更多相关《FORD M99C47-A-2009 MINERAL OIL - LIGHT《轻质矿物油》.pdf（2页珍藏版）》请在麦多课文档分享上搜索。

1、 NON-PRODUCTION MATERIAL SPECIFICATION Material Name Specification Number Date Action Changes 2009 06 24 N-STATUS No Replacement Named L. Sinclair, NA 1985 06 01 Page 1 of 2 MINERAL OIL - LIGHT M99C47-A NOT TO BE USED FOR NEW DESIGN 1. SCOPE: The material defined by this standard is a light mineral

2、oil. 2. APPLICATION: This material is generally used as a machining coolant, as a quenching oil, or is blended with other oils for specific metalworking applications. 3. REQUIREMENTS: 3.1 VISCOSITY: (SUS at 100F): 70-95 (13.1-18.3 cSt) (ASTM D 446) 3.2 FLASH POINT: 300F min (149C) (ASTM D 92) 3.3 FI

3、RE POINT: 360F min (182C) (ASTM D 92) 3.4 POUR POINT: +30F max (-1.1C) (ASTM D 92) 3.5 NEUTRALIZATION VALUE: 0.10 max (ASTM D 664 or ASTM D 974) 3.6 CONTAMINATION: The material shall be free from acid, alkali, moisture, tarry or suspended matter, thickeners or other foreign matter. It must also be f

4、ree from any objectionable odors. 3.7 SUPPLIERS RESPONSIBILITY: All materials supplied to this standard must be equivalent in all characteristics to the material upon which approval was originally granted, and shall be suitable for the intended application. Changes in composition shall not be made w

5、ithout approval of Manufacturing Engineering and Systems Office, Engineering and Manufacturing Staff. 3.8 IDENTIFICATION: Materials supplied to this standard shall be identified with the “M“ number printed on the side as well as the top of the containers in letters at least 2“ (50 mm) high in a cont

6、rasting color to that of the container. Container marking shall be in accordance with Manufacturing Standard ZF-10 and conform to all Federal, State, and Local container contents labeling regula- tions which are in effect both in the area of shipment and use. NON-PRODUCTION MATERIAL SPECIFICATION M9

7、9C47-A Page 2 of 2 4. APPROVAL OF NEW SUPPLIERS: Materials submitted by new manufacturers to this standard must have Industrial Hygiene, Environmental Engineering, Laboratory and Shop Trial approvals. Suppliers are required to complete and submit the Material Health, Safety and Environmental Data Sh

8、eet (Form 129A) prior to Shop Trial. Recommendations for the addition of new manufacturers to the Manufacturing Approved Source List (ASL) must be made in writing to the responsible Staff Office by the appropriate divisional standards activity in accordance with Manufacturing Procedure IId1. 5. ENVI

9、RONMENTAL CONTROL: Use of any material approved to this standard must comply with the guidelines as established in the environmental review of the material as they appear in the Materials and Toxicology System (MATS). 6. HEALTH AND SAFETY: Use of any material approved to this standard must comply with the guidelines given under the Toxicological (TOX) review of the material as indicated in the MATS system.